Extrusion of xylans extracted from corn cobs into biodegradable polymeric materials.

Solvent casting technique, which comprises multiple energy demanding steps including the dissolution of a polymer in a solvent followed by the evaporation of the solvent from the polymer solution, is currently the main technique for the production of xylan based polymeric materials. The present study shows that sufficient water content renders arabinoglucuronoxylan (AGX) polymers extrudable, enabling the production of AGX based polymeric materials in a single step via extrusion, which is economically advantageous to solvent casting process for mass production. AGX polymers with water content of 27% were found to yield extrudates at an extrusion temperature of 90°C. The extruded strips showed very good mechanical properties with an ultimate tensile strength of 76 ± 6 MPa and elongation at break value of 35 ± 8%, which were superior to the mechanical properties of the strips obtained from polylactic acid.

Evaluation of alkaline pretreatment temperature on a multi-product basis for the co-production of glucose and hemicellulose based films from lignocellulosic biomass.

Cotton stalks were subjected to alkaline pretreatment for the co-production of glucose and hemicellulose based films with a multi-product approach. Three pretreatment temperatures (25, 60 and 90 °C) were evaluated for their effects both on the glucose yield and on the properties of hemicellulose based films. Compared to untreated cotton stalks, the glucose yields were enhanced 3.9, 4.1 and 4.2 times for pretreatments conducted at 25, 60 and 90 °C, respectively. The pretreatment temperature of 90 °C was detrimental in terms of film formation. Tensile energy to break values of the films obtained after pretreatments conducted at 25, 60 and 90 °C were 1.1, 0.8, and 0.4 MJ/m3, respectively. The hemicellulosic part of the process, which considers the production of hemicellulose based films, should govern the pretreatment temperature since it was more responsive to the changes in the pretreatment temperature compared to the cellulosic part that accounts for glucose production.

Selecting the right blood glucose monitor for the determination of glucose during the enzymatic hydrolysis of corncob pretreated with different methods.

In order to assess their accuracy for the determination of glucose during the enzymatic hydrolysis of pretreated lignocellulosic biomass, four different blood glucose monitors (BGMs), each utilizing a different enzymatic mechanism for the determination of glucose, were utilized in an experimental setup, which compares the efficiency of ionic liquid pretreatment with dilute acid and alkaline pretreatments applied on corncob. Among the tested devices, Optium Xceed was found to be the most accurate device for the determination of glucose where Accu-Chek Active was the least accurate BGM, yielding similar results to those obtained with DNS method. Based on the HPLC results, the % error values for Optium Xceed ranged between 3.9-10.5% for the determination of glucose concentration. Upon enzymatic hydrolysis, ionic liquid and alkaline pretreatments gave similar glucose yields, which were slightly higher than the dilute acid pretreatment, which were 31.9%, 31.0% and 27.8%, respectively, based on untreated corncob.