Synthesis of Carbon Nanotubes (CNTs) from Poultry Litter for Removal of Chromium (Cr (VI)) from Wastewater.

Pakistan, an agricultural country, raises 146.5 million commercial and domestic poultry birds, which generate around 544,831 tons of waste per year. This waste finds its final disposal in agricultural land as soil fertilizer or disposal site amendment. The usage of poultry litter for this purpose is uncontrolled, which results in environmental degradation such as emission of greenhouse gases, e.g., methane. However, alternative options such as thermochemical conversion of poultry litter can offer better solutions where this waste can be used as a low-cost carbon source for the synthesis of Multiwalled Carbon Nanotubes (MWCNTs). In this study, efforts were made to utilize this cheap and plentiful carbon source for the synthesis of CNTs in the presence of Ni/Mo/MgO as a catalyst, through pyrolysis. For a better yield of carbon product, the optimum ratio for the catalysts (Ni/Mo/MgO) was found to be 4:0.2:1. Furthermore, the process parameters were also optimized for better carbon yield. A good yield of CNTs resulted from a pyrolysis time of 12 min, a temperature of 825 °C, and a catalyst weight of 100 mg. The structure and morphology of the produced nanotubes were confirmed through X-ray Diffractometer (X-RD) and Scanning Electron Microscopy (SEM). The environmental application of the nanotubes was tested in a synthetic chromium solution in the lab using a batch experiment. Different experimental conditions (pH, adsorbent dosage, and contact time) were optimized to improve the adsorption of Cr (VI) by carbon nanotubes and a UV-Visible spectrophotometer was used at 540 nm to measure the absorbance of Cr (VI). The results showed that up to 81.83% of Cr (VI) removal was achieved by using 8 mg of CNTs at pH 3 with 400 rpm at 180 min of contact time. Thus, it was concluded that poultry litter can be a useful source for the synthesis of MWCNTs and thereby removal of Cr (VI) from industrial tanneries' wastewater.

Synthesis, characterization and heavy metal removal efficiency of nickel ferrite nanoparticles (NFN's).

The heavy metals, such as Cr(VI), Pb(II) and Cd(II), in aqueous solutions are toxic even at trace levels and have caused adverse health impacts on human beings. Hence the removal of these heavy metals from the aqueous environment is important to protect biodiversity, hydrosphere ecosystems, and human beings. In this study, magnetic Nickel-Ferrite Nanoparticles (NFNs) were synthesized by co-precipitation method and characterized using X-Ray Diffraction (XRD), Energy Dispersive Spectroscopy (EDS) and Field Emission Scanning Electronic Microscopy (FE-SEM) techniques in order to confirm the crystalline structure, composition and morphology of the NFN's, these were then used as adsorbent for the removal of Cr(VI), Pb(II) and Cd(II) from wastewater. The adsorption parameters under study were pH, dose and contact time. The values for optimum removal through batch-adsorption were investigated at different parameters (pH 3-7, dose: 10, 20, 30, 40 and 50 mg and contact time: 30, 60, 90, and 120 min). Removal efficiencies of Cr(VI), Pb(II) and Cd(II) were obtained 89%, 79% and 87% respectively under optimal conditions. It was found that the kinetics followed the pseudo second order model for the removal of heavy metals using Nickel ferrite nanoparticles.

Phytoaccumulation of heavy metals from municipal solid waste leachate using different grasses under hydroponic condition.

Grasses have been used widely to remediate contaminants present in domestic wastewater, but leachate generated from municipal solid waste that usually contain some concentrations of heavy metals has never been reported to be treated with grasses, especially Rhodes grass. A series of experiments was performed to investigate the contaminant uptake from municipal solid waste leachate by Chloris gayana (Rhodes grass) grown in combination with two commonly available grass varieties namely Vetiveria zizanioides (Vetiver grass) and Pennisetum purpureum (Elephant grass). Leachate used for the experiments had high values for chemical oxygen demand (5 g/L), pH (8.5), electrical conductivity (9.0 mS/cm), nitrates (182.1 mg/L), phosphates 6.4 mg/L along with heavy metals i.e. copper, zinc and manganese. Different dilutions of leachate ranging from 0 to 100% were applied in batches and their result showed that collectively all the grasses reduced overall contaminant concentrations. These were reported for chemical oxygen demand, electrical conductivity, nitrates, and phosphates reduced up to 67, 94, 94, and 73%, respectively. Metals uptake by grasses also showed a significant decrease in applied dose i.e. zinc (97%), copper (89%), and manganese (89%). Plant analysis showed that all grasses showed preference to heavy metals uptake e.g. Rhodes grass favoured up taking zinc, Elephant grass for copper and Vetiver grass preferred manganese. Overall growth performance of Rhodes grass was better in dilute leachate, whereas in more concentrated leachate, Rhodes grass did not perform better and production of biomass decreased. In Vetiver grass, root and shoot lengths decreased with increasing leachate strength, but the biomass did not change significantly.

Growth and nutrient removal efficiency of duckweed (lemna minor) from synthetic and dumpsite leachate under artificial and natural conditions.

Sustainable management of leachate produced from the dumpsite is one of the major concerns in developing countries Aquatic plants such as duckweed have the potential to remove pollutants from wastewater which can also be cost-effective and feasible options for leachate treatment. Therefore, the objective of our present study was to examine the growth and nutrient removal efficiency of duckweed (Lemna minor) on leachate. Three tests were performed each by growing lemna minor on synthetic leachate under controlled conditions and on dumpsite leachate under natural conditions. During each test, duckweed was grown in 300 ml plastic containers with a surface area of 25.8 cm2. About 60 mg of fresh mass of duckweed was grown on 250 ml leachate at an internal depth of 9.5 cm. Results revealed that, in comparison to synthetic leachate, duckweed removed Chemical Oxygen Demand (COD), nitrogen (N), and phosphorous (P) more efficiently from dumpsite leachate under natural climatic conditions. However, the amounts of N and P absorbed into duckweed body mass were about 16% and 35% respectively more at synthetic leachate under controlled conditions. Maximum growth rate of duckweed (7.03 g m-2 day-1) was also observed for synthetic leachate in comparison to the growth rate of 4.87 g m-2 day-1 at dumpsite leachate. Results of this study provide a useful interpretation of duckweed growth and nutrient removal dynamics from leachate under natural and laboratory conditions.

Assessing the generation, recycling and disposal practices of electronic/electrical-waste (E-Waste) from major cities in Pakistan.

Rapid increase in the quantity of electronic/electrical-waste (e-waste) has become an emerging issue throughout the world. To avoid higher expenditures on safe disposal and recycling, large quantities of e-waste are being exported from developed to developing countries like Pakistan. Emerging issue of e-waste in Pakistan demands its effective management strategy for the country. However, it cannot be achieved until assessment of e-waste quantification and disposal is carried out. The main objective of this study was to quantify the e-waste inventory and it's processing from major cities of Pakistan to evaluate its generation (domestic/import) and recycling practices. This study comprises the information of only those e-waste items (desktop computers, laptops/notebooks, computer monitors and liquid-crystal display units) which form the major portion of e-waste imported to Pakistan. Survey based data collected from three major cities/areas have been extrapolated to develop an e-waste generation inventory for the country. The study reveals that approximately 50 kt of e-waste is being imported as scrap in addition to its local generation of about 38 kt per year. During field visits and data collection surveys, it has been observed that the processing of e-waste in the country is being carried out in crude manner without safety gears. Findings of our study strongly recommend dire need for urgent and effective monitoring as well as control of informal e-waste management in Pakistan.

Correction: Effects of Pyrolysis Temperature on Product Yields and Energy Recovery from Co-Feeding of Cotton Gin Trash, Cow Manure, and Microalgae: A Simulation Study.

[This corrects the article DOI: 10.1371/journal.pone.0152230.].

Effects of Pyrolysis Temperature on Product Yields and Energy Recovery from Co-Feeding of Cotton Gin Trash, Cow Manure, and Microalgae: A Simulation Study.

The intensive search of new and cleaner energy catches interest in recent years due to huge consumption of fossil fuels coupled with the challenge of energy and environmental sustainability. Production of renewable and environmentally benign energy from locally available raw materials is coming in the frontline. In this work, conversion of the combined biomass (cotton gin trash, cow manure, and Microalgae [Nannochloropsis oculata]) through batch pyrolysis has been investigated. The effect of temperature to the production of energy fuels such as bio-oil, char, and biogas have been simulated considering the yield and energy content as responses. Result of the investigation generally revealed that the proportions of the different biomass did not significantly affect the product yield and energy recovery. Significant effect of temperature is evident in the simulation result of energy recovery whereby maximum conversion was achieved at 400°C for char (91 wt%), 600°C for syngas (22 wt%), and 551°C for bio-oil (48 wt%). Overall energy conversion efficiency of 75.5% was obtained at 589°C in which 15.6 MJ/kg of mixed biomass will be elevated to pyrolysis products.

A comparison of TiO2 nanoparticles and nanotubes for catalytic gas phase destruction of H2S gas at high temperatures.

Reduction of H2S gas over Sulphur doped TiO2 nanoparticles and TiO2 nanotubes was studied in this work. Fixed bed catalytic system was used for the catalytic reduction of H2S gas at a high temperature of 450 degrees C under laboratory conditions. 99.97% reduction was achieved using S-doped TiO2. 2.89% Sulphur was adsorbed on S-doped TiO2 nanoparticles in the form of Ti(SO4)2, while 95.6% reduction was achieved in case of TiO2 nanotubes and the sulphur adsorption was 2.67%. The XRD, SEM, and EDX techniques were carried out to characterize the nanoparticles and nanotubes, while gas reduction analysis was carried out using GC-MS for gas samples.