Does navigated patellar resurfacing in total knee arthroplasty result in proper bone cut, motion and clinical outcomes?

BACKGROUND: In total knee arthroplasty with patellar resurfacing, patellar bone preparation, component positioning and motion assessments are still not navigated. Only femoral/tibial component positioning is supported by computer-assistance. The aim of this study was to verify, in-vivo, whether knee surgical navigation extended to patellar resurfacing, by original instrumentation and procedures for patellar-based tracking, could achieve accurate patella preparation in terms of original thickness restoration, bone cut orientation, and normal knee motion. METHODS: An additional navigation system for patellar data acquisition was used together with a standard navigation system for total knee arthroplasty in 20 patients. This supported the surgeon for patellar resurfacing via measurement of removed bone thickness, three-dimensional patellar cut orientations, and patello-femoral motion. Radiological and clinical examinations at 6 and 24-month follow-up were also performed. FINDINGS: The medio-lateral patellar-bone cut orientation was respectively 0.5° (standard deviation: 3.0°) and 1.4° (1.7°) lateral tilt, as measured via navigation and post-operatively on the Merchant x-ray view. The cranio-caudal orientation was 3.8° (7.2°) of flexion. The thickness variation between patellar pre- and post-implantation was 0.2 (1.3) mm. Immediately after implantation, patello-femoral as well as tibio-femoral kinematics was within the normality. Good radiological and clinical examinations at 6 and 24-month follow-up were also observed. INTERPRETATION: For the first time, the effect of patellar navigation for its resurfacing was assessed in-vivo during surgery, with very good results for thickness restoration, proper cut orientation, and normal knee motion. These results support the introduction of patella-related navigation-based surgical procedures for computer-assisted total knee arthroplasty.

Conventional versus computer-assisted surgery in total knee arthroplasty: comparison at ten years follow-up.

PURPOSE: Computer-assisted systems (CAS) for total knee arthroplasty (TKA) were expected to result in more accurate prosthesis implantation, better patient outcomes, and longer implant survival when compared to conventional instrumentation (CI). The aim of this study was to compare two groups of patients operated using CAS or CI at ten years follow-up. METHODS: One hundred twenty TKA patients, 60 using CAS and 60 using CI, were contacted after a decade for follow-up. Eligible patients received radiological examination to assess the lower-limb mechanical axis. They were also clinically assessed using the Knee Injury and Osteoarthritis Outcome Score (KOOS) and the Knee Society Score for Knee (KSS-K) and Function (KSS-F) Scoring. Kaplan-Meier survival analysis was performed to assess revisions, not for post-traumatic reasons. RESULTS: In CAS and CI groups, the lower-limb mechanical axis was 1.7° ± 2.4° and 1.5° ± 2.8°, respectively; corresponding KOOS values were 82.3 ± 14.3 and 78.6 ± 14.4; KSS-K values were 85.9 ± 11.1 and 85.0 ± 9.7; KSS-F values were 82.2 ± 19.3 and 83.8 ± 18. For these assessments, the differences between the two groups were not statistically significant (p > 0.05). Two CAS (3.8%) and three CI patients (5.7%) were revised. The Kaplan-Meier analysis showed no significant differences between the two groups. CONCLUSIONS: No significant differences were found at long-term follow-up in terms of radiographical-clinical outcomes and of implant survival between TKA operated using CAS or CI.

Results at a minimum follow-up of 5 years of a ligaments-compatible total ankle replacement design.

BACKGROUND: A new design of 3-part ankle replacement was developed to achieve compatibility with the natural ligaments by allowing certain fibers to remain isometric during passive motion. METHODS: We evaluate 75 ankle prostheses implanted from July 2003 to December 2008, at a mean follow-up 6.5±1.1years (range 5-9 years). The mean age at surgery was 62±13years (range 29-82). RESULTS: The mean AOFAS scores achieved at pre-op and at last follow-up were respectively 37±5 (23-45) and 78±8 (64-98). (p<0.001). Clinical range of motion of the ankle measured by goniometer pre op was 1°±2 of dorsiflexion and 12°±4° of plantarflexion; at last follow-up range of motion increased to 6°±5° in dorsiflexion (p<0.01) and 18°±7° in plantarflexion (p<0.05). Radiographs showed no loosening and little signs of radiolucency. Two revisions necessitated component removal, neither for implant loosening. The overall survival rate was 97.3%. CONCLUSIONS: Function and Range-of-motion showed significant improvements. These results demonstrate that ligaments-compatible shaped talar and tibial components, with a fully conforming interposed meniscal bearing, can provide satisfactory survival rates and clinical outcomes in the middle term.

Early migration of the cemented tibial component of unicompartmental knee arthroplasty: a radiostereometry study.

PURPOSE: Unicompartmental knee arthroplasty has good clinical results but high revision rates. A unicompartmental knee arthroplasty design features an all-polyethylene and conforming tibial component, and we hypothesized that this may put at risk its fixation. Implant-to-bone micromotion was measured together with relevant clinical outcomes. METHODS: The migration of the tibial component in twenty patients was measured at 3, 6, 12 and 24 months, using standard radiostereometry, along with the relevant clinical outcomes using the IKS scoring system. RESULTS: The eighteen arthroplasties at 24 months were found successful, with very good functional (mean 87.7; SD 15.4) and knee scores (mean 94.8; SD 10.1). The means and the standard deviations of the maximum total point motion (MTPM) for the four follow-ups were, respectively, as small as 0.4 ± 0.1 mm, 0.6 ± 0.2 mm, 0.6 ± 0.3 mm and 0.7 ± 0.3 mm, an average over all patients but one. In this knee, these were 1.6, 2.1, 2.4 and 2.2 mm, therefore not at high risk of aseptic loosening according to the literature. Only one knee was found at this risk, having the MTPM from 12 to 24 months of 0.5 mm, and the component moving and sinking medially, and rising laterally. CONCLUSION: At 2-year follow-up, a successful implant-to-bone fixation can be achieved in conforming all-polyethylene cemented tibial component together with excellent clinical outcomes.