Polyurethane Adhesives for Wood Based on a Simple Mixture of Castor Oil and Crude Glycerin.

Developing a new type of polyurethane is essential because conventional options often exhibit shortcomings in terms of environmental sustainability, cost-effectiveness, and performance in specialized applications. A novel polyurethane adhesive derived from a simple mixture of castor oil (CO) and crude glycerin (CG) holds promise as it reduces reliance on fossil fuels and harnesses renewable resources, making it environmentally friendly. Simple CO/CG mixtures, adjusted at three different weight fractions, were used as bio-based polyester polyols to produce polyurethane adhesive for wood bonding. The resulting products are yellowish liquids with moderate-to-high viscosity, measuring 19,800-21,000 cP at 25 °C. The chemical structure of the polyester polyols was characterized using infrared spectroscopy (FTIR), thermogravimetry (TG), and differential scanning calorimetry (DSC). These polyols reacted with polymeric 4,4-methylene diphenyl diisocyanate (p-MDI) at a consistent isocyanate index of 1.3, resulting in the formation of polyurethane adhesives. Crucially, all final adhesives met the adhesive strength requirements specified by ASTM D-5751 standards, underscoring their suitability for wood bonding applications. The addition of CG enhanced the surface and volumetric hydrophobicity of the cured adhesives, resulting in adhesive properties that are not only stronger but also more weather-resistant. Although the thermal stability of the adhesives decreased with the inclusion of CG, FTIR analysis confirmed proper polyurethane polymer formation. The adhesive adjusted for a 2:1 CO:CG weight ratio promoted wood-wood bonding with the highest shear strength, likely due to a higher formation of urethane linkages between hydroxyl groups from the blend of polyols and isocyanate groups from the p-MDI.

Rigid Polyurethane Biofoams Filled with Pine Seed Shell and Yerba Mate Wastes.

Pine seed shells and yerba mate are common wastes leftover from the food and beverage industry. This study presents the development of rigid polyurethane foams (RPUFs) filled with pine seed shells and yerba mate at 5, 10 and 15 wt%. The fillers were characterized for chemical properties using bench chemistry analyses, and the RPUFs were investigated in terms of chemical, morphological, mechanical, thermal and colorimetric characteristics. The main results indicated that yerba mate showed good compatibility with the polyurethane system, probably because its available hydroxyl groups reacted with isocyanate groups to form urethane bonds, producing increases in mechanical and thermal properties. However, pine seed shell did not appear to be compatible. Anisotropy increased slightly, as there was an increase in the percentage of reinforcement. The mechanical properties of the yerba mate reinforced foams proved stable, while there was a loss of overall up to ~50% for all mechanical properties in those reinforced with pine seed shell. Thermal properties were improved up to ~40% for the yerba mate reinforced foams, while those reinforced with pine nuts were stable. It was possible to observe a decrease in the glass transition temperature (Tg) of ~-5 °C for the yerba mate reinforced foams and ~-14 °C for the pine seed shell reinforced ones.