RESUMO
Microalgae cultures were used for a WW treatment to remediate nutrients while producing biomass and recycling water. In these trials, raceway ponds (RWPs; 1 and 0.5 ha) were located next to a municipal (WW) treatment plant in Mérida, Spain. The ponds were used for continuous, all-year-round microalgae production using WW as a source of nutrients. Neither CO2 nor air was supplied to cultures. The objective was to validate photosynthesis monitoring techniques in large-scale bioreactors. Various in-situ/ex-situ methods based on chlorophyll fluorescence and oxygen evolution measurements were used to follow culture performance. Photosynthesis variables gathered with these techniques were compared to the physiological behavior and growth of cultures. Good photosynthetic activity was indicated by the build-up of dissolved oxygen concentration up to 380% saturation, high photochemical yield (Fv/Fm = 0.62-0.71), and relative electron transport rate rETR between 200 and 450 µmol e- m-2 s-1 at midday, which resulted in biomass productivity of about 15-25 g DW m-2 day-1. The variables represent reliable markers reflecting the physiological status of microalgae cultures. Using waste nutrients, the biomass production cost can be significantly decreased for abundant biomass production in large-scale bioreactors, which can be exploited for agricultural purposes.
RESUMO
Raceway reactors are still the most extensive technology for microalgae production. However, these reactors have some drawbacks, one of them being a low mass transfer capacity, which provokes dissolved oxygen accumulation and thus reduction of system performance. To overcome this problem, it is imperative to improve the photobioreactor design as well as the operating conditions. One solution is to maintain the dissolved oxygen below defined limits. In this work, a new control algorithm is proposed to improve the mass transfer capacity of raceway reactors while at the same time reducing air injection costs. The main idea of the proposed control approach is that only the necessary amount of airflow will be applied according to transfer capacity demand. This control strategy was first analyzed in simulation and compared with classical On/Off solutions, and subsequently evaluated in outdoor conditions in a photobioreactor of 80 m2.
Assuntos
Microalgas , Algoritmos , Biomassa , Oxigênio , FotobiorreatoresRESUMO
This study evaluates the production of biomass and mycosporine-like amino acids (MAAs) throughout the year in Gracilaria vermiculophylla (Rhodophyta) collected in Ria de Aveiro (Portugal). The algae were grown in outdoor tanks in seawater with the addition of fishpond effluents under two different water flows (100 and 200 L h-1) in an integrated multi-trophic aquaculture (IMTA) system (tanks 1200 L; 1.5 m2) and different algal densities (3, 5, and 7 kg m-2). MAA content in IMTA seaweeds was significantly affected by the interaction of time and stocking density, but not by the water flow. The highest MAA content was observed in April (about 3.13 mg g-1 DW) followed by May (1.79 mg g-1 DW). Seaweed biomass productivity was higher in May (372.06 g DW m-2 week-1) than in April (353.40 g DW m-2 week-1). Four MAAs were identified by HPLC and electrospray ionization mass spectrometry (ESI-MS) in G. vermiculophylla: Porphyra-334, Shinorine, Palythine and Asterina-330. The highest levels of Porphyra-334 and Shinorine were reached from November to January and the Palythine + Asterina-330 from April to August. Taking into account the average biomass and MAA production of G. vermiculophylla growing in this IMTA system (8.56 g of MAA in 18 m2 culture along 8 months; 35.5% produced in April), a total amount of 71.33 g MAA year-1 could be produced in this system by scaling up to 100 m2. MAAs could be further used as photoprotector and antioxidant compounds in cosmetic products.
