Infiltration/evaporation-induced shrinkage of demineralized dentin by solvated model adhesives.

During dentin bonding, solvated adhesive comonomers are applied to water-saturated decalcified dentin matrices. When alcohol-solvated hydrophilic or hydrophobic methacrylate monomers are applied, they chemically remove water and cause matrix shrinkage during comonomer infiltration. Evaporation of solvent induces further shrinkage. The purpose of this work was to compare the shrinkage of water-saturated dentin matrices infiltrated with ethanol- or methanol-solvated 2-hydroxyethyl methacrylate (HEMA), 2,2-bis[4(2-hydroxy-3-methacryloyloxy-propyloxy)-phenyl] propane (BisGMA), or triethyleneglycol dimethacrylate (TEGDMA) at 90/10, 70/30, 50/50, and 30/70 mass fraction % alcohol/monomer before and after evaporation of alcohol. Thin (ca 0.2 mm) disks of human mid-coronal dentin were demineralized and placed in a well beneath the contact probe of a linear variable differential transformer (LVDT). The height of the matrix was measured before and after random application of one of the twelve alcohol/monomer mixtures. Matrix height was measured during infiltration and during solvent evaporation. Between trials, residual monomer was extracted using ethanol. These studies were repeated on specimens in which 100% alcohol was used to substitute for water in the matrix. Both studies revealed that matrices shrink 30-50% but that pretreatment of matrices with alcohol prevents BisGMA phase separations from occurring. Wet bonding with ethanol instead of water permits infiltration of relatively hydrophobic alcohol/monomers.

Net expansion of dried demineralized dentin matrix produced by monomer/alcohol saturation and solvent evaporation.

The purpose of this work was to determine if nonaqueous methacrylate monomer/alcohol mixtures could expand dried collapsed demineralized dentin matrix. Thin disks (ca. 200 microm) of human dentin were demineralized and placed in wells beneath contact probes of linear variable differential transformers. The probes were placed on water-saturated expanded matrices to record the shrinkage associated with drying. Monomer mixtures containing hydroxyethyl methacrylate, 2,2-bis[4-(2-hydroxy-3 methacryloyloxy)propoxyphenyl] propane, or triethyleneglycol dimethacrylate were mixed with methanol or ethanol at alcohol/monomer mass fraction % of 90/10, 70/30, 50/50, or 30/70. They were randomly applied to the dried matrices to determine the rate and magnitude of expansion; then shrinkage was recorded during evaporation of the alcohols. The results indicated that matrix expansion was positively correlated with the Hoy's solubility parameters for hydrogen bonding forces (delta(h)) of the monomer/solvent mixtures (p < 0.001). Expansions were more rapid with methanol-containing than with ethanol-containing monomer mixtures. For the test solutions, triethyleneglycol dimethacrylate-containing mixtures produced the slowest rate of matrix expansion and hydroxyethyl methacrylate-containing mixtures the most rapid expansion. When the solvents were evaporated, the matrix shrank in proportion to the solvent content and the delta(h) of the monomer-solvent mixtures. The results indicate that expansion of dried, collapsed dentin matrices requires that the delta(h) of the mixtures be larger than 17 (J/cm(3))(1/2). The greater the delta(h) of the monomer solutions, the greater the rate and extent of expansion.