RESUMO
Sodium tungsten bronze (Na x WO3) is a promising alternative plasmonic material to nanoparticulate gold due to its strong plasmonic resonances in both the visible and near-infrared (NIR) regions. Additional benefits include its simple production either as a bulk or a nanoparticle material at a relatively low cost. In this work, plasmonic Na x WO3 nanoparticles were introduced and mixed into the nanoparticulate zinc oxide electron transport layer of a water processed poly(3-hexylthiophene):phenyl-C61-butyric acid methyl ester (P3HT:PC61BM) nanoparticle (NP) based organic photovoltaic device (NP-OPV). The power conversion efficiency of NP-OPV devices with Na x WO3 NPs added was found to improve by around 35% compared to the control devices, attributed to improved light absorption, resulting in an enhanced short circuit current and fill factor.
RESUMO
Resolution is a key parameter for microscopy, but methods for standardizing its definition are often poorly defined. For a developing technique such as scanning helium microscopy, it is critical that a consensus-based protocol for determining instrument resolution is prepared as a written standard to allow both comparable quantitative measurements of surface topography and direct comparisons between different instruments. In this paper we assess a range of quantitative methods for determining instrument resolution and determine their relative merits when applied to the specific case of the scanning helium microscope (SHeM). Consequently, we present a preliminary protocol for measuring the resolution in scanning helium microscopy based upon utilizing appropriate test samples with sets of slits of well-defined dimensions to establish the quantitative resolution of any similar instrument.
RESUMO
The photochemistry of poly{p-phenylene[1-(tetrahydrothiophen-1-io)ethylene chloride]} (PPTEC), a water soluble precursor of the semiconducting polymer, poly{p-phenylenevinylene} (PPV), has been studied both under atmospheric conditions and in environments devoid of oxygen. UV-visible spectroscopy and photoluminescence data has been used to provide a picture of the mechanistic pathways involved in UV irradiation of the PPTEC material. A new quantitative model for the effect of UV irradiation upon film morphology is presented, which leads to insights for the improved control of the characteristics of PPV nanostructures produced via near-field scanning optical lithography.
RESUMO
The preparation and structures of a variety of oxonium ion tetrachloroaurate(III) salts isolated from aqua regia are reported. The new compounds are [(H(5)O(2))(2)(12-crown-4)(2)][AuCl(4)](2) (1), [(H(7)O(3))(15-crown-5)][AuCl(4)] (2), [(H(5)O(2))(benzo-15-crown-5)(2)][AuCl(4)] (3), [(H(3)O)(18-crown-6)][AuCl(4)] (4), [(H(5)O(2))(dibenzo-24-crown-8)][AuCl(4)] (5), [(H(5)O(2))(4-nitrobenzo-15-crown-5)(2)][AuCl(4)] (6), [(H(3)O)(4-nitrobenzo-18-crown-6)][AuCl(4)] (7), [(H(11)O(5))(tetrachlorodibenzo-18-crown-6)(2)][AuCl(4)] (8), and [(H(7)O(3))(dinitrodibenzo-30-crown-10)][AuCl(4)] (9). A significant correlation between the degree of proton hydration and crown ether size is observed. Aryl crown ethers are nitrated in concentrated aqua regia, but nonnitrated products may be obtained in a dilute solution of aqua regia by reaction with aqueous HAuCl(4).