Evaluation of BTEX and phenol removal from aqueous solution by multi-solute adsorption onto smectite organoclay.

The removal process of BTEX and phenol was evaluated. The smectite organoclay for single-solute system reached removal was evaluated by adsorption on smectite organoclay adsorbent by kinetic and equilibrium efficiencies between 55 and 90% while was reached between 30 and 90% for multi-solute system at 297 K and pH 9. The Langmuir-Freundlich model was used to fit the experimental data with correlation coefficient between 0.98 and 0.99 providing kinetic and equilibrium parameter values. Phenol and ethylbenzene presented high maximum adsorbed amount, 8.28 and 6.67 mg/g, respectively, compared to the other compounds for single-solute. Toluene and p-xylene presented high values of adsorption constant which indicates a high adsorption affinity of compounds to organoclay surface and high binding energy of adsorption. Phenol presented low kinetic adsorption constant value indicating slow rate of adsorption.

Kinetic and wet oxidation of phenol catalyzed by non-promoted and potassium-promoted manganese/cerium oxide.

The wet oxidation of organic compounds to CO2 and H2O has been shown to be a very efficient technique in the outflows treatment. This work focuses on the interaction of the chemical element potassium with the catalyst MnO2-CeO2 in the wet degradation of phenol. The reaction has been carried out in an autoclave with a controlled system of agitation, pressure, temperature and sampling of the liquid phase. The experiments were performed in the presence of the catalysts MnO2-CeO2 and K-MnO2-CeO2 in the following operational conditions: temperature of 130 degrees C, P = 20.4 atm, catalyst concentration in the range 1.5-5.0 g/L, initial phenol concentration of 0.5 g/L, initial pH varying between 6.8 and 8.5, and percentage of potassium in the catalyst MnO2-CeO2 ranging between 0% and 10%. Curves indicating the profile of conversion of total organic carbon show that the phenol degradation is favored when the potassium quantity is reduced. This behaviour is confirmed by BET analysis, whereby the catalyst presents larger specific area when compared to the percentages of other components. Regardless of the catalyst used in the phenol oxidation, the kinetic constant of reaction had the same order of magnitude for two parallel stages proposed by a first-order kinetic model.