Pedicle screw pull-out testing in polyurethane foam blocks: Effect of block orientation and density.

Synthetic bone models such as polyurethane (PU) foam are a well-established substitute to cadaveric bone for screw pull-out testing; however, little attention has been given to the effect of PU foam anisotropy on orthopaedic implant testing. Compressive and screw pull-out performance in three PU foam densities; 0.16 g/cm3 (PCF 10), 0.32 g/cm3 (PCF 20) and 0.64 g/cm3 (PCF 40) were performed in each of the X, Y or Z orientations. The maximum compressive force, stiffness in the linear region, maximum stress and modulus were determined for all compression tests. Pedicle screws were inserted and pulled out axially to determine maximum pull-out force, energy to failure and stiffness. One-way ANOVA and post hoc tests were used to compare outcome variables between PU foam densities and orientations, respectively. Compression tests demonstrated the maximum force was significantly different between all orientations for PCF 20 (X, Y and Z) while stiffness and maximum stress were different between X versus Y and X versus Z. Maximum pull-out force was significantly different between all orientations for PCF 10 foam. No significant differences were noted for other foam densities. There is potential for screw pull-out testing results to be significantly affected by orientation in lower density PU foams. It is recommended that a single, known orientation of the PU foam block be used for experimental testing.

Sagittal patellar flexion angle measurement determines greater incidence of patella alta in patellar tendinopathy patients.

PURPOSE: The objective of this study was to compare patellar height and patella alta between a control cohort and patients with patellar tendinopathy by the sagittal patellar flexion angle (SPFA) measurement. METHODS: Magnetic resonance imaging (MRI) scans of the knee were obtained from a sports imaging facility and screened to select patients with anterior knee pain. This symptomatic group was divided into two patient cohorts: those with and without MRI features of patellar tendinopathy. Lateral knee radiographs were reviewed and SPFA, knee flexion angle and Insall-Salvati ratio (IS) were measured from the radiographs by two independent reviewers. RESULTS: A total of 99 patients consisting of 48 patellar tendinopathy patients and 51 control patients were included. There was a significantly higher mean patellar height (p = 0.002, d = 0.639) and a greater patella alta incidence in the patellar tendinopathy cohort (25.0%) compared to the controls (3.9%) (p = 0.022, d = 0.312). Insall-Salvati ratio measurements showed no difference in patella alta incidence between tendinopathy and control cohorts. There was excellent inter- and intra-observer reliability of SPFA measurements (ICC 0.99). CONCLUSION: This is the first study to demonstrate a greater incidence of patella alta in patellar tendinopathy patients compared to controls. A greater patella alta incidence amongst patellar tendinopathy patients as defined by SPFA was found to be clinically relevant, as it suggests these patients may comprise the recalcitrant patient subgroup who do not improve with current surgical intervention and may therefore benefit from a biomechanical surgical solution. LEVEL OF EVIDENCE: III.