RESUMO
This work describes the development of styrene-divinylbenzene (St-DVB) particles with polyethylene glycol methacrylate (PEGMA) and/or glycidyl methacrylate (GMA) brushes for the removal of bilirubin from blood in haemodialyzed patients. Bovine serum albumin (BSA) was immobilized onto the particles using ethyl lactate as a biocompatible solvent, which allowed the immobilization of up to 2 mg BSA/g of particles. The presence of albumin on the particles increased their capacity for bilirubin removal from phosphate-buffered saline (PBS) by 43% compared to particles without albumin. The particles were tested in plasma, finding that St-DVB-GMA-PEGMA particles that had been wetted in ethyl lactate with BSA reduced the concentration of bilirubin in plasma by 53% in less than 30 min. This effect was not observed in particles without BSA. Therefore, the presence of albumin on the particles enabled quick and selective removal of bilirubin from plasma. Overall, the study highlights the potential use of St-DVB particles with PEGMA and/or GMA brushes for bilirubin removal in haemodialyzed patients. The immobilization of albumin onto the particles using ethyl lactate increased their capacity for bilirubin removal and enabled quick and selective removal from plasma.
RESUMO
Hyperbilirubinemia is one of the main causes of death in patients with severe hepatic problems, which justifies the research for bilirubin removal solutions. In this study, St-MMA particles with PEGMA and/or GMA brushes were synthesized. First, the recipe for St-MMA was optimized and then adapted for PEGMA and GMA incorporation. Different solvents were then assayed to improve the BSA immobilization capacity of the particles. Ethyl lactate proved to be the best solvent, reaching a BSA immobilization capacity improvement of up to 60% for St-MMA-GMA-PEGMA particles. These particles also presented the best results for BR removal from PBS. No significant differences in the final capacity for BR removal from PBS media were observed when BSA was attached to the particles; however, the kinetics were greatly improved, requiring half the time. Finally, St-MMA-GMA-PEGMA particles that were wetted in EL with BSA reduced the bilirubin concentration in plasma from levels that threaten the survival of critical patients to levels close to those of healthy individuals in less than 30 min. On the contrary, particles without BSA were unable to remove bilirubin from plasma. Thus, the attachment of albumin to the particles plays a key role in selectively reducing bilirubin levels.
RESUMO
Rigid polyurethane (RPU) foams have been successfully glycolyzed by using diethylene glycol (DEG) and crude glycerol (CG) as transesterification agents. However, DEG did not allow to achieve a split-phase process, obtaining a product with low polyol purity (61.7 wt %). On contrary, CG allowed to achieve a split-phase glycolysis improving the recovered polyol purity (76.5%). This is an important novelty since, up to now, RPUs were glycolyzed in single-phase processes giving products of low polyol concentration, which reduced the further applications. Moreover, the nanosilica used as filler of the glycolyzed foams was recovered completely pure. The recovered polyol successfully replaced up to 60% of the raw polyol in the synthesis of RPU foams and including the recovered nanosilica in the same concentration than in glycolyzed foam. Thus, the feasibility of the chemical recycling of this type of polyurethane composites has been demonstrated. Additionally, PU foams were synthesized employing fresh nanosilica to evaluate whether the recovered nanosilica has any influence on the RPU foam properties. These foams were characterized structurally, mechanically and thermally with the aim of proving that they met the specifications of commercial foams. Finally, the feasibility of recovering the of CG by vacuum distillation has been demonstrated.
