Planar patterned stretchable electrode arrays based on flexible printed circuits.

For stretchable electronics to achieve broad industrial application, they must be reliable to manufacture and must perform robustly while undergoing large deformations. We present a new strategy for creating planar stretchable electronics and demonstrate one such device, a stretchable microelectrode array based on flex circuit technology. Stretchability is achieved through novel, rationally designed perforations that provide islands of low strain and continuous low-strain pathways for conductive traces. This approach enables the device to maintain constant electrical properties and planarity while undergoing applied strains up to 15%. Materials selection is not limited to polyimide composite devices and can potentially be implemented with either soft or hard substrates and can incorporate standard metals or new nano-engineered conductors. By using standard flex circuit technology, our planar microelectrode device achieved constant resistances for strains up to 20% with less than a 4% resistance offset over 120,000 cycles at 10% strain.

A viscoelastic, viscoplastic model of cortical bone valid at low and high strain rates.

The stress-strain behavior of cortical bone is well known to be strain-rate dependent, exhibiting both viscoelastic and viscoplastic behavior. Viscoelasticity has been demonstrated in literature data with initial modulus increasing by more than a factor of 2 as applied strain rate is increased from 0.001 to 1500 s(-1). A strong dependence of yield on strain rate has also been reported in the literature, with the yield stress at 250 s(-1) having been observed to be more than twice that at 0.001 s(-1), demonstrating the material viscoplasticity. Constitutive models which capture this rate-dependent behavior from very low to very high strain rates are required in order to model and simulate the full range of loading conditions which may be experienced in vivo; particularly those involving impact, ballistic and blast events. This paper proposes a new viscoelastic, viscoplastic constitutive model which has been developed to meet these requirements. The model is fitted to three sets of stress-strain measurements from the literature and shown to be valid at strain rates ranging over seven orders of magnitude.

Pattern transformation triggered by deformation.

Periodic elastomeric cellular solids are subjected to uniaxial compression and novel transformations of the patterned structures are found upon reaching a critical value of applied load. The results of a numerical investigation reveal that the pattern switch is triggered by a reversible elastic instability. Excellent quantitative agreement between numerical and experimental results is found and the transformations are found to be remarkably uniform across the samples. It is proposed that the mechanism will also operate at much smaller scales opening the possibility for imprinting complex patterns at the nanoscale or switching photonic and phononic crystals in a controlled way.

Nanoscale anisotropic plastic deformation in single crystal aragonite.

The nanoscale anisotropic elastic-plastic behavior of single-crystal aragonite is studied using nanoindentation and tapping mode atomic force microscopy imaging. Force-depth curves coaxial to the axis exhibited load plateaus indicative of dislocation nucleation events. Plasticity on distinct slip systems was evident in residual topographic impressions where four pileup lobes were present after indentation with a conospherical probe and distinct, protruding slip bands were present after indentation with a Berkovich pyramidal probe. A finite element crystal plasticity model revealed the governing roles of the {110}<001>slip system family, as well as the (100)[010], (100)[001], (010)[100], (010)[001], (001)[100] and (001)[010] systems.

Determination of additives in food by capillary electrophoresis.

The application of capillary electrophoresis (CE) to the analysis of additives in food has been reviewed. Additives included in the review are preservatives, antioxidants, sweeteners, colourings, caffeine, niacin, choline, nitrate, and nitrite. The review highlights the versatility of CE in separating this often widely disparate group of compounds. The application of the methods to real food samples is also discussed.

Indirect spectrophotometric detection of inorganic anions in ion-exchange capillary electrochromatography.

The application of indirect spectrophotometric detection was investigated for a capillary electrochromatographic system in which an anion-exchange stationary phase (in the form of aminated latex particles) was coated onto the wall of a fused-silica capillary. The study has focused on the choice of the type and concentration of the absorbing coion (probe) added to the background electrolyte and the role of this species in manipulating the ion-exchange contributions to the separation with a view to controlling the selectivity of the separation. Common inorganic anions were used as analytes and nitrate, p-toluenesulfonate, nicotinate, and chromate were investigated as probes. It was found that most of these probes produced only a limited range of separation selectivities when their concentration was varied over the practically accessible range. p-Toluenesulfonate provided the greatest variation in selectivity, but peak distortion due to electromigration dispersion was evident for the faster ions. When variation of the separation selectivity - from predominantly electrophoretic in nature to predominantly ion-exchange in nature - was desired, this was best achieved by varying the type of probe rather than its concentration. For example, the nitrate probe provided predominantly electrophoretic separations with good peak shapes and high efficiencies. A comprehensive list of probes, ranked in order of ion-exchange selectivity coefficients determined by ion chromatography, was compiled and this proved to be a useful tool to assist in the selection of a probe for a desired separation selectivity. The limits of detection for the analytes and probes studied ranged from 20-55 micromol for the chromate system to 230-600 micromol for the nicotinate system, with nitrate and p-toluenesulfonate giving intermediate values.

Analysis of the volatile components in vanilla extracts and flavorings by solid-phase microextraction and gas chromatography.

The development and application of a solid-phase microextraction (SPME) method in the analysis of vanilla extracts and vanilla flavorings was studied. The SPME method was developed to be used in conjunction with gas chromatography mass spectrometry (GC-MS). The optimized SPME sampling parameters for the determination of the volatile components included a poly(acrylate) fiber, a 40-min sampling time at room temperature, and a 2-min desorption time. The reproducibility of the method was good, with a percent relative standard deviation between 2.5 and 6.4% for the target compounds. The data suggest that the origin of natural extracts can be readily determined from the GC profile and that differences exist between nature-identical and synthetic flavorings and the natural extracts. The method also has potential for identifying the type of vanilla extract/flavoring used to flavor food.

Separation of food grade antioxidants (synthetic and natural) using mixed micellar electrokinetic capillary chromatography.

A capillary electrophoretic method, for the determination of antioxidants present in food, has been developed using mixed micellar electrokinetic capillary chromatography. The buffer consists of sodium cholate (40 mM), sodium dodecyl sulfate (15 mM), 10% methanol, and 10 mM borate at pH 9.3. A separation was obtained for nine antioxidants (synthetic and natural) commonly found in food. High-performance liquid chromatography and capillary electrophoresis were applied to the analysis of sesame oil and wine. Ascorbic acid was identified in wine.

Simultaneous determination of antioxidants, preservatives and sweeteners permitted as additives in food by mixed micellar electrokinetic chromatography.

A micellar electrokinetic chromatography method was developed to simultaneously analyse commonly used food additives. The additive mixture, comprising propyl gallate, octyl gallate, dodecyl gallate, butylated hydroxyanisole, butylated hydroxytoluene, tertiary butylhydroquinone, p-hydroxybenzoic acid methyl ester, p-hydroxybenzoic acid ethyl ester, benzoic acid, sorbic acid, saccharin, aspartame and acesulfame-K, was not resolved using single surfactant micellar systems consisting of sodium dodecyl sulfate (SDS), sodium cholate (SC) or sodium deoxycholate (SDC). The separation of these additives using mixed micellar systems, involving SDS/SC, SDS/SDC and SC/SDC, was investigated. Organic solvents were added to the mixed micellar phases to optimise the separation. The mixture was successfully separated using a 20 mM borate buffer with 35 mM SC, 15 mM SDS and 10% methanol added at pH 9.3. Additives in cola beverages and low-joule jam were investigated and quantified using this method.

Pediatric trauma documentation. Adequacy for assessment of child abuse.

OBJECTIVE: To determine how frequently information considered necessary for identification of potential cases of child abuse or neglect was adequately documented in cases of pediatric trauma. DESIGN: Retrospective study; medical record review. SETTING: Tertiary care hospital. SUBJECTS: The study included 1018 children treated in the emergency department or admitted to the hospital for trauma during the first 6 months of 1992. MAIN OUTCOME MEASURE: Physicians' documentation of information pertinent to the identification of child abuse and neglect. RESULTS: Of the 642 medical records that met study criteria, 28 (4%) included no history of how the child's injury occurred. A complete examination was documented in only 209 (33%) of the cases. The presence of a witness at the time of injury and inquiries about any previous injury were inadequately documented. The color of the injury was noted in only 57 (9%) of the medical records reviewed. The injury was consistent with the history in 614 (96%) of the cases. In 41 (6%) of the cases, because of inadequate documentation, reviewers were uncertain whether child abuse or neglect had occurred. Only 23 cases (4%) were reported to child protective services at the time of the examination. CONCLUSIONS: Documentation of pediatric trauma remains inadequate to differentiate accidental trauma from abuse. Inadequately explained or repeated injuries in children must be reported as suspected child abuse and neglect, and those reports should include well-documented histories and physical examinations by the physician involved.