Decontamination efficacy of common liquid disinfectants against non-spore-forming biological agents in soil matrices.

AIMS: The purpose of this study was to evaluate decontamination efficacy, within three soil types, against Yersinia pestis, Burkholderia pseudomallei, and the Venezuelan Equine Encephalitis virus (VEEV). METHODS AND RESULTS: One of three liquid disinfectants (dilute bleach, Virkon-S or Klozur One) was added to three soil types (sand, loam, or clay) and allowed contact for four pre-spike durations: 0, 15, 30 and 60 min. Y. pestis, B. pseudomallei, or VEEV was then spiked into the soil (10 microliters or approx. 1 × 107  CFU or PFU into 1 g soil) and decontamination efficacy assessed at post-spike contact times of 10 or 60 min at ambient environmental conditions. Across all soil types, sandy soil resulted in the least quenching to all three disinfectants tested as shown by sustained decontamination efficacy across all pre-spike and post-spike timepoints. Clay and loam soil types exhibited quenching effects on the hypochlorite and peroxygen based disinfectants (dilute bleach and Virkon S) and in general resulted in decreased efficacy with increased pre-spike contact time. The sodium persulfate (Klozur One) performance was the most consistent across all soil types and pre-spike contact times, resulting in greater efficacy with increased post-spike time. CONCLUSIONS: Liquid disinfectants can provide high levels of decontamination in soil for both viral and non-spore-forming bacterial select agents. Hypochlorite and peroxygen based disinfectants used in soils containing higher organic content (loam or clay) may require extended contact times or re-application of liquid disinfectant, in as little as 15 min of application, to achieve a 6-log reduction. SIGNIFICANCE AND IMPACT OF THE STUDY: These results provide information for the performance of three disinfectants in soil against non-spore-forming select agents. These data may aid response decision makers following a biological contamination incident by informing the selection of disinfectant as well as the re-application time to achieve effective site remediation.

Residual antimicrobial coating efficacy against SARS-CoV-2.

AIMS: This study evaluated the residual efficacy of commercially available antimicrobial coatings or films against severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2) on non-porous surfaces. METHODS AND RESULTS: Products were applied to stainless steel or ABS plastic coupons and dried overnight. Coupons were inoculated with SARS-CoV-2 in the presence of 5% soil load. Recovered infectious SARS-CoV-2 was quantified by TCID50 assay. Tested product efficacies ranged from <1.0 to >3.0 log10 reduction at a 2-h contact time. The log10 reduction in recovered infectious SARS-CoV-2 ranged from 0.44 to 3 log10 reduction on stainless steel and 0.25 to >1.67 log10 on ABS plastic. The most effective products tested contained varying concentrations (0.5%-1.3%) of the same active ingredient: 3-(trihydroxysilyl) propyldimethyloctadecyl ammonium chloride. Products formulated with other quaternary ammonium compounds were less effective against SARS-CoV-2 in this test. CONCLUSIONS: The residual antimicrobial products tested showed varied effectiveness against SARS-CoV-2 as a function of product tested. Several products were identified as efficacious against SARS-CoV-2 on both stainless steel and ABS plastic surfaces under the conditions evaluated. Differences in observed efficacy may be due to variation in active ingredient formulation; efficacy is, therefore, difficult to predict based upon listed active ingredient and its concentration. SIGNIFICANCE AND IMPACT: This study highlights the formulation-specific efficacy of several products against SARS-CoV-2 and may inform future development of residual antiviral products for use on non-porous surfaces. The identification of antimicrobial coatings or films showing promise to inactivate SARS-CoV-2 suggests that these products may be worth future testing and consideration.

Influence of wash aids on Bacillus spore removal from an asphalt parking lot using two spray-based washing methods.

AIMS: The goal of this study was to measure the removal efficacy of Bacillus atrophaeus spores from a parking lot using spray-based washing methods (a pressure washer and a garden hose) and wash aids. B. atrophaeus is a commonly used nonpathogenic surrogate for B. anthracis, the causative agent of anthrax and a deadly bioterrorism agent that would cause major disruptions and damage to public health should it be disseminated over an urban area. METHODS AND RESULTS: Five wash aids (1 mM sodium chloride, an Instant Ocean® seawater solution, 0.01% Tween 20, 0.01% sodium dodecyl sulfate, and unamended tap water) were used along with two different spray sequences in this study. Across all treatment conditions, 3.7-6.4 log10  colony forming unit were recovered in the runoff water, and 0.15%-23% of spores were removed from the surface of the parking lot. CONCLUSIONS: Pressure washing removed more spores than the garden hose, and for both types of washing methods, the first pass removed more spores than the subsequent passes. The Instant Ocean and Tween 20 wash aids were found to significantly increase the percentage of spore removal when using the pressure washer, but the overall increase was only 1%-2% compared to the tap water alone. SIGNIFICANCE AND IMPACT OF STUDY: This study provides public officials and emergency responders with baseline spore physical removal information for situations where a corrosive disinfectant might have a negative impact on the environment and washing is being considered as an alternative remediation approach.