First Measurement of a Long-Lived π

The adapted DIRAC experiment at the CERN PS accelerator observed for the first time long-lived hydrogenlike π^{+}π^{-} atoms, produced by protons hitting a beryllium target. A part of these atoms crossed the gap of 96 mm between the target and a 2.1 µm thick platinum foil, in which most of them dissociated. Analyzing the observed number of atomic pairs, n_{A}^{L}=436_{-61}^{+157}|_{tot}, the lifetime of the 2p state is found to be τ_{2p}=(0.45_{-0.30}^{+1.08}|_{tot})×10^{-11} s, not contradicting the corresponding QED 2p state lifetime τ_{2p}^{QED}=1.17×10^{-11} s. This lifetime value is three orders of magnitude larger than our previously measured value of the π^{+}π^{-} atom ground state lifetime τ=(3.15_{-0.26}^{+0.28}|_{tot})×10^{-15} s. Further studies of long-lived π^{+}π^{-} atoms will allow us to measure energy differences between p and s atomic states and so to discriminate between the isoscalar and isotensor ππ scattering lengths with the aim to check QCD predictions.

Observation of π

The observation of hydrogenlike πK atoms, consisting of π^{-}K^{+} or π^{+}K^{-} mesons, is presented. The atoms are produced by 24 GeV/c protons from the CERN PS accelerator, interacting with platinum or nickel foil targets. The breakup (ionization) of πK atoms in the same targets yields characteristic πK pairs, called "atomic pairs," with small relative momenta Q in the pair center-of-mass system. The upgraded DIRAC experiment observed 349±62 such atomic πK pairs, corresponding to a signal of 5.6 standard deviations. This is the first statistically significant observation of the strange dimesonic πK atom.

Detection of terrestrial radionuclides with X-ray fluorescence analysis.

This paper provides an overview of analytical methods frequently used to identify terrestrial radionuclides in samples. While radioactivity is normally measured through the ionising radiation produced during the spontaneous decay of unstable atoms, selected radionuclides or their chemical elements can be quantified with instrumental techniques based on stimulated emission or counting of atoms. The advantages and disadvantages of these analytical methods are discussed. Particular attention is paid to X-ray fluorescence analysis of materials containing uranium and thorium. It is also possible to determine the area distributions of these chemical elements in samples with the use of scanning X-ray fluorescence systems.

An evaluation of the response of a scintillation detector for estimating the radionuclide composition of a contaminated cloud.

We have made Monte Carlo calculations of the scintillation spectrometer response for the photon field from a cloud of contaminated air after selected scenarios of a nuclear power plant accident. Calculations (using MCNP5 code-X-5 Monte Carlo Team, 2005) were performed for 36 main energy lines of the expected radionuclides. The evaluated spectra enable us to simulate real composite spectra and their evolution in time, and to assess the applicability of a specific spectrometry system for a semi-qualitative and semi-quantitative analysis of the composition of the cloud.

Medical application of 3-D polymer gel dosemeter evaluated by nuclear magnetic resonance.

A polymer-gel dosemeter, which can be evaluated by nuclear magnetic resonance (NMR), was prepared and then a few samples were homogeneously irradiated by a Leksell gamma knife using an 18 mm collimator (60Co gamma photons) to obtain a calibration curve (NMR 1/T2 response to absorbed dose). To measure dose distribution from the Leksell gamma knife, a testing flask tilled with the gel was fixed in the head phantom and then irradiated based on a calculated treatment plan. Evaluation of dosemeters was performed on a Siemens EXPERT 1T NMR scanner. Dose profiles in X, Y and Z coordinates through the ellipsoidal shape of the dose distribution were obtained to compare experimental results from the irradiated phantom with the treatment planning system calculations. The use of a polymer-gel dosemeter for a verification of stereotactic procedures has some unique advantages which can be summarised as follows: (1) the dosemeter itself is tissue equivalent, (2) three-dimensional dose distributions can be measured, (3) the dosemeter allows patient's procedures to be simulated without any limitations.

Inactivation of individual cells by divers ions at different LET values.

A new formula linking the shape of survival curve to the inactivation probabilities after different numbers of cell hits has been derived. It has been used in analyzing recent experimental data obtained with monolayer cells irradiated at definite values of LET (in different parts of Bragg peaks). The new approach allows not only deriving the values of inactivation probabilities at given LET values; unexpected consequences seem to follow especially for inactivation characteristics of carbon ions in different parts of the Bragg peak, too.

Temperature dependence of polymer-gel dosimeter nuclear magnetic resonance response.

The purpose of this study was to find a physical-mathematical description capable to correct a polymer-gel dosimeter relaxation rate R2-dose response for different temperatures. Four different modifications of polymer-gel dosimeters were used in this study. Samples with polymer-gel dosimeter in glass test vessels were homogeneously irradiated by 60Co gamma photons. A multi-echo sequence with 16 equidistant echoes was used for evaluation of irradiated polymer-gel dosimeters. The sequence parameters were as follows: TR 2000 ms, TE 22.5-360.0 ms, slice thickness 5 mm, FOV 255 mm, one acquisition. The proposed description recommends to subtract R2 response of the nonirradiated dosimeter from the total R2-dose response. The relaxation rate for the irradiated dosimeter can be expressed as a function of temperature and dose. The temperature dependence has an exponential behavior in the measured range. The proposed description allows to correct the measured NMR R2-dose responses for different temperatures.

Energy and dose rate dependence of BANG-2 polymer-gel dosimeter.

The purpose of this study was to evaluate dependence of BANG-2 polymer-gel dosimeter sensitivity on different photon and electron energies as well as on different mean dose rates expressed as repetition rates for a standard clinically used linear accelerator. The sensitivity of the dosimeter was represented by the slope of calibration curve in the linear region measured for each modality. A calibration curve (in the linear region) based on five dosimeters (four irradiated and one background) was obtained for each photon and electron energy and different repetition rates. Dosimeter sensitivity dependence on energy was studied for 4, 6, and 18 MV x-ray photons and for nominal electron energies 9, 12, 16, and 20 MeV. Dosimeter sensitivity dependence on mean dose rate was separately studied for electron and photon beams with the use of repetition rates 80, 160, 240, 320, and 400 MU min(-1). Evaluation of dosimeters was performed on Siemens MAGNETOM EXPERT 1T scanner in the head coil. A multiecho sequence with 16 equidistant echoes was used for the evaluation of irradiated polymer-gel dosimeters. The parameters of the sequence were as follows: TR 2000 ms, TE 22.5-360.0 ms, slice thickness 5 mm, FOV 255 mm, one acquisition. There was observed a trend in polymer-gel dosimeter sensitivity dependence on the quality index of high energy x-ray beams used and on mean electron energy absorbed in the center of the dosimeter. Polymer-gel dosimeter sensitivity was decreasing with increasing photon or electron energy. There was observed no trend in polymer-gel dosimeter sensitivity dependence on mean dose rate expressed as a repetition rate for both photon and electron beams.

Radiation methods in research of ancient monuments

A "Laboratory of Quantitative Methods in Monument Research" is being built at the CTU Prague. Its primary orientation is the investigation of historic architecture, although other objects of art can also be investigated. In the first phase, two radiation methods are being established, but it is set up in such a way, that various other methods can readily be added in its future development. The radiation methods chosen for the initial development of the laboratory are: thermoluminescence dating and X-ray fluorescence analysis. The design of the automated TL-reader, built in our laboratories, is adjusted for the purpose of dating of historic brick architecture (which, of course, does not exclude applications for ceramics and other materials). The investigation of renaissance architecture in southern Bohemia and Moravia is under preparation as the first large campaign of this kind in the Czech Republic. Radionuclide X-ray fluorescence analysis has been chosen as the basic analytical method in the laboratory. The possibility of analyses of paintings and fired building materials (bricks, roof tiles) have been investigated. The first results in both the areas are very promising.