Determination of pesticide dermal transfer to operators and agricultural workers through contact with sprayed hard surfaces.

BACKGROUND: In the present study, the rate of dermal transfer of pesticides to agricultural workers occurring via contact with sprayed hard surfaces was investigated. Cotton gloves were used as dosimeters to collect residues from hard surfaces contaminated by pesticides in greenhouses. Dosimeters, either dry or moistened, were in contact with wood, metal and plastic surfaces that had previously been sprayed. The experimental approach applied mimicked typical hand contact. Moistened cotton gloves were used to simulate hand moisture from dew/condensation or rainfall. The effect of total duration of contact on the final hand exposure via transfer was investigated. RESULTS: The higher duration contact tested (50 s) resulted in higher transfer rates for metal and plastic surfaces; no such effect was noted in the case of the wood surface. The pesticide amount transferred from the metal and plastic surfaces to wet gloves was greater than that transferred to dry gloves. Such a trend was not observed for the wood surface. Transfer rates varied from 0.46 to 77.62% and from 0.17 to 16.90% for wet and dry samples, respectively. CONCLUSION: The current study has generated new data to quantify the proportion of pesticide deposits dislodged from three different non-crop surfaces when in contact with dry or wet gloves. © 2018 Crown copyright. Pest Management Science © 2018 Society of Chemical Industry.

Assessment of field re-entry exposure to pesticides: A dislodgeable foliar residue study.

A dislodgeable foliar residue study was conducted in greenhouse pepper and tomato on the island of Crete, Greece, following the spray application of an SC insecticide (with active substance (a.s.) tebufenozide) and an EC fungicide (a.s. bupirimate). Furthermore, for the assessment of worker exposure to pesticides - as a result of re-entering the treated crops - a worker dermal exposure study was carried out during the tasks of tying or pruning, which allowed the transfer coefficient values for the specific tasks to be determined. Pesticide residues were analysed with an in house developed and fully validated HPLC-ESI/MS analytical method. The results from the study resulted in transfer coefficient values which were in agreement with current EFSA guideline values in most of the cases with the exception of bupirimate in a tomato greenhouse. In that case, high potential dermal exposure and low dislodgeable foliar residue values were observed, which is thought to be due to the moist leaves collected during sampling and monitoring, which led to greater than expected transfer coefficient values.

Dermal & inhalation exposure of operators during fungicide application in vineyards. Evaluation of coverall performance.

In the present study the dermal and the inhalation exposure of five operators during fungicide applications in vineyards were determined. The produced exposure datasets can be used as surrogate for the estimation of the actual and the potential dermal as well as inhalation operator exposure levels for this application scenario. The dermal exposure was measured using the whole body dosimetry method while the inhalation exposure with the use of personal air sampling devices with XAD tubes located on the operator's breathing zone. Ten field trials were carried out by 5 different operators using a tractor assisted hand-held lance with spray gun at the Tanagra region of Viotia, Greece. An in-house GC-ECD analytical method was developed and validated for the determination of penconazole, which was the active substance (a.s.) of the fungicide formulation used in field trials. The mean recovery of field-fortified samples was 81%. The operator exposure results showed expected variability and were compared to those derived from the German model for prediction of operator exposure. The comparison of the 75th percentile values for an operator wearing personal protection equipment has shown that the measured levels were 2.2 times lower than those estimated by the German model. The levels of actual dermal exposure ranged from 2 to 19 mg/kg a.s. applied. The protection provided by the two types of coveralls was evaluated and in comparison to the existing reduction factors used for other types of PPE (coveralls) was found satisfactory for the operator under the conditions of the specific applications.