Er3+ doped nanoparticles as upconversion thermometer probes in confined fluids.

Non-contact temperature measurement at the nanoscale by photoluminescence using a nano-sensor in a confined fluid has been performed in the present work. Upconversion lanthanide-doped nanoparticles applied to ratiometric thermometry could be considered as a self-referenced nanosensor. Gadolinium orthovanadate (GdVO4) nanoparticles doped with Yb3+ and Er3+ were synthesized and then dispersed in an ester-based fluid. Rheological measurements show that the viscosity of the dispersed NP suspension remains unchanged up to a shear rate of 10-4 s-1 at 393 K. The NP suspension allows luminescence intensity ratio (LIR) thermometry up to 473 K with a relative sensitivity of 1.17% K-1 with a NIR laser. Then, the temperature calibration by coupling the high pressure (1.08 GPa max) confirmed the applicability of NPs as a thermosensor in a variable pressure environment. According to these results, the fluid containing GdVO4:Yb3+/Er3+ nanoparticles can be used for temperature sensing in a pressurized environment for further application in tribology.

Electrochemical Properties of Silver Nanoparticles in Mesoporous Silica and Titania Films: Specific Behavior of Titania Composite.

Electrochemical behavior of silver nanoparticles in mesoporous oxides electrodes is investigated. Mesoporous SiO2 and TiO2 films deposited on FTO (fluorine-doped tin oxide) and containing Ag nanoparticles (NPs) are used as electrodes. The study of voltammetric curves (CVs) and the diffusion of Ag+ ions out of the films highlight the importance of the retention of Ag+ ions by the TiO2 films. By varying several factors such as the speed rate or the initial potential, we observe the existence of the two potentials' anodic peaks. These are explained by the nature of two silver NP populations created in two distinct areas in the film and with different size distributions, as shown by scanning electron microscopy (SEM) and transmission electron microscopy (TEM) observations. The size distributions of the two NP populations allow the position and shape of each of the oxidation peaks in the CVs to be adequately simulated.

Foam Silica Films Synthesized by Calcium Chloride-Assisted Emulsification.

The development of porous films with an accessible high specific surface area is important for designing new adsorbents, sensors, or catalyst supports. Here, we describe a simple method to prepare a silica foam coating using a calcium chloride-assisted evaporation-induced emulsification method. An alcoholic silica sol containing calcium chloride and a poly(ethylene oxide)-based polymer is deposited on a substrate by dipping. The evaporation of the alcohol induces a phase separation between the silica-rich phase and the calcium-rich one. The size of the droplets increases via a coalescence process until the gelation of the sol, which determines the final pore size between 100 nm and 3 µm. Thermal analysis and monitoring of droplet evaporation confirm that the departure of the solvent is delayed by the presence of calcium chloride in the sol. The influence of the nature of the polymer on the porosity is discussed. The use of a block copolymer such as the Pluronic F-127, which strongly stabilizes the emulsion, allows to reach a low pore size (400 nm), while on the contrary, we propose to use a short poly(ethylene glycol) (PEG) such as PEG-400, which weakly stabilizes it, leading to larger pores (2-3 µm). Furthermore, we show that the addition of a zirconium salt (ZrOCl2·8H2O) to the silica sol accelerates the condensation step of the silica and leads to the decrease in the pore size.

Electroactive Area from Porous Oxide Films Loaded with Silver Nanoparticles: Electrochemical and Electron Tomography Observations.

Electrochemical studies of nanomaterial-based electrodes have been widely developed for catalyst and energy-harvesting applications. The evolution of these electrodes over time and their efficiency have been extensively studied and analyzed in order to optimize their performance. However, the electrochemical responses of electrodes are rarely studied in terms of the position of the active species within these electrodes. In this paper, we highlight that the spatial location of silver nanoparticles (NPs) embedded inside semiconductive porous films, TiO2 or Fe2O3, is crucial for the electrochemical response. In fact, by using cycling voltammetry and electron tomography experiments, we show the existence of an "electroactive area", corresponding to a reduced thickness of the sample in close vicinity to a fluorine-doped tin oxide substrate where most of the electrochemical responses originate. Our results demonstrate that, for a film thickness of several hundred nanometers, only less than 30 nm close to the substrate responds electrochemically. However, cyclic voltammetry empties the electroactive area of silver NPs. Therefore, application of chronoamperometry coupled to irradiation allowed regeneration of this area thanks to an increased diffusion of silver species. In this paper, we also show the significant diffusion of silver species within the film during electrochemical experiments, a phenomenon even increased by irradiation. These results are therefore an important step that shows the importance of the localization of active species within a porous film and help in understanding and increasing the durability of nanomaterial-based electrodes.

Photoelectrochemical Behavior of Silver Nanoparticles inside Mesoporous Titania: Plasmon-Induced Charge Separation Effect.

The self-assembly block copolymer method was used to synthesize mesoporous titania films and silver nanoparticles (NPs) were grown inside the films. Such silver NPs-titania films are known for their multicolor photochromic properties due to a photo-oxidation reaction of silver in the presence of titania under light excitation which is attributed to a plasmon induced charge separation. Here, the photoelectrochemical properties of these composite films have been investigated at different light wavelengths and chemical environment in order to characterize the light-induced redox reactivity modifications. Cyclic voltammetry study shows that the Ag+ electro-reduction peak potential varies depending on the light irradiation, which determines the state of the silver nanoparticles complexed or not by titania.

Electroless growth of silver nanoparticles into mesostructured silica block copolymer films.

Silver nanoparticles and silver nanowires have been grown inside mesostructured silica films obtained from block copolymers using two successive reduction steps: the first one involves a sodium borohydride reduction or a photoreduction of silver nitrate contained in the film, and the second one consists of a silver deposit on the primary nanoparticles, carried out by silver ion solution reduction with hydroxylamine chloride. We have demonstrated that the F127 block copolymer ((PEO)(106)(PPO)(70)(PEO)(106)), "F type", mesostructured silica film is a suitable "soft" template for the fabrication of spherical silver nanoparticles arrays. Silver spheres grow from 7 to 11 nm upon the second reduction step. As a consequence, a red shift of the surface plasmon resonance associated with metallic silver has been observed and attributed to plasmonic coupling between particles. Using a P123 block copolymer ((PEO)(20)(PPO)(70)(PEO)(20)), "P type", mesostructured silica film, we have obtained silver nanowires with typical dimension of 10 nm x 100 nm. The corresponding surface plasmon resonance is blue-shifted. The hydroxylamine chloride treatment appears to be efficient only when a previous chemical reduction is performed, assuming that the first sodium borohydride reduction induces a high concentration of silver nuclei in the first layer of the porous silica (film/air interface), which explains their reactivity for further growth.

Chemical growth and photochromism of silver nanoparticles into a mesoporous titania template.

Elaboration of mesoporous titanium oxide film supporting silver nanoparticles is described. Mesoporous titanium oxide films are characterized by TEM analysis. Titania films are infiltrated with a silver salt solution and chemical reduction treatments are performed using either a NaBH(4) or a formaldehyde solution. Infiltrated films are then characterized by TEM, SEM, AFM, UV-visible spectroscopy, X-ray diffraction, and Rutherford Backscattering Spectrometry (RBS). The utilization of a mesoporous titania substrate allows to control the nanoparticle size and the interparticle distance. RBS experiments provide the evidence that NaBH(4) treatment induces a strong accumulation of silver nanoparticles in the subsurface of the layer, while formaldehyde treatment induces the formation of silver nanoparticles embedded into almost the whole depth of the titania film. Large silver nanocrystals are also formed at the film surface whatever the reducer used. A broad visible absorption band related to the surface plasmon resonance (SPR) is obtained in both cases and is strongly red-shifted compared to the SPR obtained for silver nanoparticles inside a silica matrix. Moreover, irradiation with visible light causes the photooxidation of silver nanoparticles by titania and a complete discoloration of the material. The photooxidation is related to a drastic decrease in the silver nanoparticle size and is found to be reversible, particularly in the case of the material obtained by the formaldehyde reduction.

Gold hollow spheres obtained using an innovative emulsion process: towards multifunctional Au nanoshells.

The tremendous development of materials with fine tuning of their composition, shape, size and chemical functionalities at the nanometer scale has opened a wide range of applications, particularly in medicine. Metallic nanoparticles are extremely interesting for such developments. The fundamental study of surface plasmon resonance (SPR) versus the shape/size of a particle is an important challenge. In this field, we propose a synthetic strategy using an original biphasic emulsion process linked to chemo-reduction of gold salt HAuCl(4). This method allows the preparation of new functional nanocapsules. These nanomaterials are fully characterized.