Measurement of diabetic wounds with optical coherence tomography-based air-jet indentation system and a material testing system.

OBJECTIVE: Material testing system is a conventional but destructive method for measuring the biomechanical properties of wound tissues in basic research. The recently developed optical coherence tomography-based air-jet indentation system is a non-destructive method for measuring these properties of soft tissues in a non-contact manner. The aim of the study was to examine the correlation between the biomechanical properties of wound tissues measured by the two systems. METHOD: Young male Sprague-Dawley rats with streptozotocin-induced diabetic were wounded by a 6 mm biopsy punch on their hind limbs. The biomechanical properties of wound tissues were assessed with the two systems on post-wounding days 3, 7, 10, 14, and 21. Wound sections were stained with picro-sirius red for analysis on the collagen fibres. Data obtained on the different days were charted to obtain the change in biomechanical properties across the time points, and then pooled to examine the correlation between measurements made by the two devices. Qualitative analysis to determine any correlation between indentation stiffness measured by the air-jet indentation system and the orientation of collagen fibres. RESULTS: The indentation stiffness is significantly negatively correlated to the maximum load, maximum tensile stress, and Young's modulus by the material testing system (all p<0.05). The orientation of collagen changes with the indentation stiffness over time. CONCLUSION: Our findings support the use of optical coherence tomography-based air-jet indentation system to evaluate the biomechanical properties of wounds in a non-contact manner. It is a potential clinical device to examine the biomechanical properties of chronic wounds in vivo in a repeatable manner.

Transcutaneous electrical nerve stimulation for neuropathic pain.

This study examined the clinical effectiveness of high-frequency transcutaneous electrical nerve stimulation for reducing hypersensitivity of the hand. Nineteen patients suffering from hand hypersensitivity were randomly assigned into either a treatment or a placebo group. A visual analogue scale and the Downey Hand Centre Hand Sensitivity Test were used to measure the tactile tolerance of the hand. Grip strength was assessed by a grip dynamometer. Daily applications of electrical stimulation were provided for 2 weeks. Significantly lower pain scores were found in the treatment group than in the placebo group by Day 7 and Day 11. The ranking of ten dowel textures of the Downey Hand Centre Hand Sensitivity Test in the treatment group was significantly higher than in the placebo group by Day 7 and Day 11. However, no significant inter-group difference was found in grip strength.