Genetic polymorphisms of the IGF-II gene intron 8 coding region and its association with growth and carcass traits in yak.

Insulin-like growth factor II (IGF-II) plays a key role in mammalian growth and is involved in stimulating fetal cell division, differentiation, and metabolic regulation. IGF-II is considered a candidate gene for genetic markers of growth and carcass traits. Therefore, in this study, the associations of single nucleotide polymorphisms (SNPs) in the IGF-II gene region with growth and carcass characteristics in five yak breeds were investigated. Two SNPs, G(330)C and A(358)G, were identified by sequencing intron 8 of the IGF-II gene in homozygotes. Two alleles, A and B, and three genotypes, AA, AB, and BB, were identified by polymerase chain reaction. Genotypic frequencies of IGF-II allele B were 0.8623, 0.8936, 0.8535, 0.8676, and 0.8300 for Datong yak, Gannan yak, Tianzhu white yak, Qinghai Plateau yak, and Xinjiang yak, respectively. Allele and the genotype of IGF-II were strongly associated with growth and carcass traits. Least square analysis revealed a significant effect (P < 0.01) of genotypes AA and AB compared with genotype BB on live-weight (at 12, 13-24, and 25-36 months of age), average daily weight gain (P < 0.01) and carcass weight (P < 0.05). Animals with genotype AB had a higher mean rib eye area, and a lower mean yield grade. The results indicated that the IGF-II gene acts by a primarily additive biological mechanism by adding weight independently of skeletal growth.

Microstructure characterization of Al matrix composite reinforced with Ti-6Al-4V meshes after compression by scanning electron microscope and transmission electron microscope.

Compressive properties of Al matrix composite reinforced with Ti-6Al-4V meshes (TC4(m)/5A06 Al composite) under the strain rates of 10(-3)S(-1) and 1S(-1) at different temperature were measured and microstructure of composites after compression was characterized by scanning electron microscope (SEM) and transmission electron microscope (TEM). Compressive strength decreased with the test temperature increased and the strain-rate sensitivity (R) of composite increased with the increasing temperature. SEM observations showed that grains of Al matrix were elongated severely along 45° direction (angle between axis direction and fracture surface) and TC4 fibres were sheared into several parts in composite compressed under the strain rate of 10(-3)S(-1) at 25°C and 250°C. Besides, amounts of cracks were produced at the interfacial layer between TC4 fibre and Al matrix and in (Fe, Mn)Al(6) phases. With the compressive temperature increasing to 400°C, there was no damage at the interfacial layer between TC4 fibre and Al matrix and in (Fe, Mn)Al(6) phases, while equiaxed recrystal grains with sizes about 10 µm at the original grain boundaries of Al matrix were observed. However, interface separation of TC4 fibres and Al matrix occurred in composite compressed under the strain rate of 1S(-1) at 250°C and 400°C. With the compressive temperature increasing from 25°C to 100°C under the strain rate of 10(-3) S(-1), TEM microstructure in Al matrix exhibited high density dislocations and slipping bands (25°C), polygonized dislocations and dynamic recovery (100°C), equiaxed recrystals with sizes below 500 µm (250°C) and growth of equiaxed recrystals (400°C), respectively.

[Chemical synthesis and cloning of Plasmodium falciparum 45 peptide antigen gene].

We have synthesized a 162 bp gene of human Plasmodium falciparum hybrid peptide antigen by the solid-phase phosphoramidite method with ABI 381A DNA synthesizer. The gene encodes three fragments of the relative molecules 83 kDa, 55 kDa and 35 kDa merozoite-specific proteins and two CS repeats or four peptides. The gene with the designed two cohesive ends was divided into 8 fragments to be synthesized. All synthetic fragments were annealed and ligated with T4 DNA ligase to form double DNA chain. This synthetic gene was recombined with P-Blue script as vector and transformed into E. coli JM109. The positive recombinants were screened out by dot hybridization and enzyme analysis. The DNA sequence analysis showed that the synthesized human Plasmodium falciparum hybrid peptide antigen gene was identical with the designed one. (Figs. 1-4).