Aspects of surface scanning by direct analysis in real time mass spectrometry employing plasma glow visualization.

RATIONALE: Visual monitoring of the Direct Analysis in Real Time (DART) gas impact region during sampling was demonstrated via its metastable plasma glow. It is known that adding neon into helium for DART leads to plasma glow, but this effect has not been used in practice and discussed in the literature so far. METHODS: A single quadrupole mass spectrometer with a DART SVPA ion source was used for recording of DART mass spectra from different surfaces, using galangin and p-coumaric acid as model analytes. In specific cases, the composition of the mass spectra was clarified using an Orbitrap mass spectrometer. RESULTS: Plasma glow visualization made it possible to track the metastable gas distributions during surface scanning. The influence on the composition of the mass spectra was studied for different carrier gases, i.e. pure helium versus a helium-neon mixture, and for the vacuum pumping rate. The spatial resolution was substantially improved via a DART cap with a narrowed internal diameter, but impaired by a decreased sensitivity. Comparably low signal intensities were obtained for analytes on porous layers due to analyte penetration and metastable gas scattering. CONCLUSIONS: Visualization through the plasma glow enables the optimal selection of the coordinates for DART-MS analysis and thus it will support scanning and imaging MS on surfaces, including porous planar chromatographic separation materials.

Characterization of volatile and semi-volatile compounds in green and fermented leaves of Bergenia crassifolia L. by gas chromatography-mass spectrometry and ID-CUBE direct analysis in real time-high resolution mass spectrometry.

Chemical compositions of volatile and semi-volatile components in green and fermented leaves of Bergenia crassifolia L. were studied. Leaf components were identified using gas chromatography with low resolution mass spectrometry and direct analysis in real time (DART) high resolution mass spectrometry with an ID-CUBE ion source. Phytol, nerolidol, geraniol, linalool, alpha-bisabolol, alpha-bisabololoxide B, alpha-cadinol, delta-cadinene, alpha-terpineol and several other marker compounds of special interest were defined, for which the process of fermentation significantly changed their content in the leaves. Low resolution El GC-MS and ID-CUBE DART-HRMS were found to be complementary methods, as they provide different information, helpful to increase the confidence of identification.

Combined multivariate data analysis of high-performance thin-layer chromatography fingerprints and direct analysis in real time mass spectra for profiling of natural products like propolis.

Sophisticated statistical tools are required to extract the full analytical power from high-performance thin-layer chromatography (HPTLC). Especially, the combination of HPTLC fingerprints (image) with chemometrics is rarely used so far. Also, the newly developed, instantaneous direct analysis in real time mass spectrometry (DART-MS) method is perspective for sample characterization and differentiation by multivariate data analysis. This is a first novel study on the differentiation of natural products using a combination of fast fingerprint techniques, like HPTLC and DART-MS, for multivariate data analysis. The results obtained by the chemometric evaluation of HPTLC and DART-MS data provided complementary information. The complexity, expense, and analysis time were significantly reduced due to the use of statistical tools for evaluation of fingerprints. The approach allowed categorizing 91 propolis samples from Germany and other locations based on their phenolic compound profile. A high level of confidence was obtained when combining orthogonal approaches (HPTLC and DART-MS) for ultrafast sample characterization. HPTLC with selective post-chromatographic derivatization provided information on polarity, functional groups and spectral properties of marker compounds, while information on possible elemental formulae of principal components (phenolic markers) was obtained by DART-MS.

ID-CUBE direct analysis in real time high-resolution mass spectrometry and its capabilities in the identification of phenolic components from the green leaves of Bergenia crassifolia L.

RATIONALE: Bergenia crassifolia is a plant widely used in herbal medicine. Its chemical composition has been little studied, and no studies using high-resolution mass spectrometry (HRMS) have been performed. Its phenolic components are of particular interest, due to the interest in such compounds in medicine and cosmetics. The ID-CUBE, a simplified Direct Analysis in Real Time (DART) ion source, suitable for the fast MS analysis of liquids without complex sample preparation, offers a new method of studying extracts of such plant. Coupling the ID-CUBE with a high-resolution mass spectrometer can provide identification of extract components. METHODS: Mass spectral conditions were optimized for model solutions of the flavonoid naringenin and used for the identification of phenolic compounds in green leaves extracts of Bergenia crassifolia. OpenSpot sample cards with a metal grid surface were used for sample introduction into the ID-CUBE ion source on an Obitrap mass spectrometer. The samples were applied as 5-µL aliquots of the extract onto the metal grid of the card. Sample ionization was stimulated in the ion source within 20 s by applying an electric current to the metal grid to thermally desorb the analytes into the gas flow of metastable helium atoms from the ID-CUBE. RESULTS: Elemental compositions were assigned to abundant ions in the mass spectra of the extracts. The major phenolic components were confirmed by their [M-H](-) ions. Thirty-six other marker ions were found, and elemental compositions were suggested for 30% of them, based on a search for compounds found in herbal extracts. CONCLUSIONS: The ID-CUBE-Orbitrap MS coupling allowed the rapid accurate mass determination of the phenolic components (and other compounds) in herbal extracts. Higher confidence in component identification could be provided by using additional structural elucidation methods, including tandem mass spectrometry (MS/MS), and this will be the focus of future studies.

DART-Orbitrap MS: a novel mass spectrometric approach for the identification of phenolic compounds in propolis.

This is the first direct analysis in real-time mass spectrometry (DART-MS) study of propolis and a first study on the analysis of bee products using high-resolution DART-MS (DART-HRMS). Identification of flavonoids and other phenolic compounds in propolis using direct analysis in real-time coupling with Orbitrap mass spectrometry (DART-Orbitrap MS) was performed in the negative ion mode for minimizing the matrix effects, while the positive ion mode was used for the confirmation of selected compounds. Possible elemental formulae were suggested for marker components. The duration of one sample analysis by DART-MS analysis lasted ca. 30 s, and all benefits of high-resolution mass spectrometry were used upon data processing using the coupling of DART with the Orbitrap mass spectrometer. The possibility for scanning analysis of dried propolis extract spots on a planar porous surface was investigated in the heated gas flow of the DART ion source with adjustable angle. As an independent method, the approach of scanning analysis is of high interest and of future potential for confirmation of the results obtained from liquid sample analysis. Scanning analysis is highly promising for further development in the bioanalytical field due to the convenience of the storage and transportation of dried sample spots.

Some new features of Direct Analysis in Real Time mass spectrometry utilizing the desorption at an angle option.

The present study is a first step towards the unexplored capabilities of Direct Analysis in Real Time (DART) mass spectrometry (MS) arising from the possibility of the desorption at an angle: scanning analysis of surfaces, including the coupling of thin-layer chromatography (TLC) with DART-MS, and a more sensitive analysis due to the preliminary concentration of analytes dissolved in large volumes of liquids on glass surfaces. In order to select the most favorable conditions for DART-MS analysis, proper positioning of samples is important. Therefore, a simple and cheap technique for the visualization of the impact region of the DART gas stream onto a substrate was developed. A filter paper or TLC plate, previously loaded with the analyte, was immersed in a derivatization solution. On this substrate, owing to the impact of the hot DART gas, reaction of the analyte to a colored product occurred. An improved capability of detection of DART-MS for the analysis of liquids was demonstrated by applying large volumes of model solutions of coumaphos into small glass vessels and drying these solutions prior to DART-MS analysis under ambient conditions. This allowed the introduction of, by up to more than two orders of magnitude, increased quantities of analyte compared with the conventional DART-MS analysis of liquids. Through this improved detectability, the capabilities of DART-MS in trace analysis could be strengthened.

Fast quantitation of 5-hydroxymethylfurfural in honey using planar chromatography.

An approach for rapid quantitation of 5-hydroxymethylfurfural (HMF) in honey using planar chromatography is suggested for the first time. In high-performance thin-layer chromatography (HPTLC) the migration time is approximately 5 min. Detection is performed by absorbance measurement at 290 nm. Polynomial calibration in the matrix over a range of 1:80 showed correlation coefficients, r, of ≥ 0.9997 for peak areas and ≥ 0.9996 for peak heights. Repeatability in the matrix confirmed the suitability of HPTLC-UV for quantitation of HMF in honey. The relative standard deviation (RSD, %, n = 6) of HMF at 10 ng/band was 2.9% (peak height) and 5.2% (peak area); it was 0.6% and 1.0%, respectively, at 100 ng/band. Other possible detection modes, for example fluorescence measurement after post-chromatographic derivatization and mass spectrometric detection, were also evaluated and can coupling can be used as an additional tool when it is necessary to confirm the results of prior quantitation by HPTLC-UV. The confirmation is provided by monitoring the HMF sodium adduct [M + Na](+) at m/z 149 followed by quantitation in TIC or SIM mode. Detection limits for HPTLC-UV, HPTLC-MS (TIC), and HPTLC-MS (SIM) were 0.8 ng/band, 4 ng/band, and 0.9 ng/band, respectively. If 12 µL honey solution was applied to an HPTLC plate, the respective detection limits for HMF in honey corresponded to 0.6 mg kg(-1). Thus, the developed method was highly suitable for quantitation of HMF in honey at the strictest regulated level of 15 mg kg(-1). Comparison of HPTLC-UV detection with HPTLC-MS showed findings were comparable, with a mean deviation of 5.1 mg kg(-1) for quantitation in SIM mode and 6.1 mg kg(-1) for quantitation in TIC mode. The mean deviation of the HPTLC method compared with the HPLC method was 0.9 mg kg(-1) HMF in honey. Re-evaluation of the same HPTLC plate after one month showed a deviation of 0.5 mg kg(-1) HMF in honey. It was demonstrated that the proposed HPTLC method is an effective method for HMF quantitation in honey. Figure Fast quantitation of 5-hydroxymethylfurfural in honey.

Determination of drugs and drug-like compounds in different samples with direct analysis in real time mass spectrometry.

Direct analysis in real time (DART), a relatively new ionization source for mass spectrometry, ionizes small-molecule components from different kinds of samples without any sample preparation and chromatographic separation. The current paper reviews the published data available on the determination of drugs and drug-like compounds in different matrices with DART-MS, including identification and quantitation issues. Parameters that affect ionization efficiency and mass spectra composition are also discussed.

Increasing the accuracy of determination of nc/nH ratios by gas chromatography-atomic emission detection.

The influence of oxygen content in helium on the accuracy of nc/nH ratio determination for model mixtures of aliphatic and polyaromatic hydrocarbons and polychlorinated biphenyls was studied. The best accuracy was achieved at the oxygen content ca. 9%, which was the maximal possible oxygen content in helium for this GC-atomic emission detection (helium flow rate was 25 ml min(-1)). Using the maximal oxygen flow in plasma the nC/nH ratio determination accuracy improvement was accompanied by 10-fold increase in detection limit.

Improving the accuracy of carbon-to-hydrogen ratio determination for P, N, S, O, Cl, and Br-containing organic compounds using atomic emission detection.

The objective of this work was to investigate the dependence of atomic emission detector C and H response on microwave-induced plasma conditions and to improve the accuracy of carbon-to-hydrogen ratio determination for trialkylphosphates, herbicides, chlorophenols, and sulfur-containing organic compounds. Compounds which differed structurally from the analytes were used as reference compounds. It was found that when the oxygen concentration in the helium was the maximum for the instrument (9%) relative errors in carbon-to-hydrogen ratio determination were 3-8%, irrespective of analyte and reference compound structure, whereas when working in the mode of operation recommended by the manufacturer of the instrument (1.5% oxygen in helium) the respective errors were 10-20% or higher. This improvement in the accuracy of carbon-to-hydrogen ratio determination was accompanied by a factor of ten decrease in sensitivity.

Electron ionization mass spectra and their reproducibility for trialkylsilylated derivatives of organic acids, sugars and alcohols.

Mass spectra of trialkylsilyl derivatives of fatty acids, dicarboxylic acids, hydroxyacids, oxoacids, sugars, amino acids and alcohols were obtained. Amino acids were analyzed as tert-butyldimethylsilyl derivatives; all other model compounds were analyzed as trimethylsilyl derivatives. Reproducibility of the electron ionization (EI) mass spectra for the derivatives obtained was discussed. It was shown that, for many investigated derivatives, composition of the respective mass spectra depended greatly on ion source contamination. The trimethylsilylated alpha-tocopherol mass spectrum composition was most significantly influenced by ion source contamination. This compound can be used to test ion source contamination.

Determination of polychlorinated dibenzo-p-dioxins, dibenzofurans, and biphenyls by gas chromatography/mass spectrometry in the negative chemical ionization mode with different reagent gases.

Reagent gases that are used in mass spectrometry in the NCI mode for the determination of polychlorinated dibenzo-p-dioxins (PCDDs), dibenzofurans (PCDFs), and biphenyls (PCBs) are discussed. Ion-molecule reactions and respective characteristic ions that form while using reagent gases (CH(4), O(2), i-C(4)H(10), NH(3), H(2), He, Ar, Xe, SF(6)) or gas mixtures (CH(4)/O(2), Ar/CH(4), CH(4)/H(2)O, Ar/O(2), i-C(4)H(10)/CH(2)Cl(2)/O(2)) are reviewed. It is shown that only CH(4), O(2), CH(4)/O(2), and CH(4)/N(2)O are widely used and well studied, even though-in the case of these reagent gases-there are contradictions between the publications of various authors. Such reagent gases as NH(3) and He are not well studied, but further investigations of their use for the determination of organochlorine pollutants could be of interest. The possibilities of more sensitive and selective determination of PCDDs, PCDFs, and PCBs are discussed.