Rubrene single crystal solar cells and the effect of crystallinity on interfacial recombination.

Single crystal studies provide a better understanding of the basic properties of organic photovoltaic devices. Therefore, in this work, rubrene single crystals with a thickness of 250 nm to 1000 nm were used to produce an inverted bilayer organic solar cell. Subsequently, polycrystalline rubrene (orthorhombic, triclinic) and amorphous bilayer solar cells of the same thickness as single crystals were studied to make comparisons across platforms. To investigate how single crystal, polycrystalline (triclinic-orthorhombic) and amorphous forms alter the charge carrier recombination mechanism at the rubrene/PCBM interface, light intensity measurements were carried out. The light intensity dependency of the JSC, VOC and FF parameters in organic solar cells with different forms of rubrene was determined. Monomolecular (Shockley Read Hall) recombination is observed in devices employing amorphous and polycrystalline rubrene in addition to bimolecular recombination, whereas the single crystal device is weakly affected by trap assisted SRH recombination due to reduced trap states at the donor acceptor interface. To date, the proposed work is the only systematic study examining transport and interface recombination mechanisms in organic solar cells produced by different structure forms of rubrene.

Correlating Crystal Thickness, Surface Morphology, and Charge Transport in Pristine and Doped Rubrene Single Crystals.

The relationship between charge transport and surface morphology is investigated by utilizing rubrene single crystals of varying thicknesses. In the case of pristine crystals, the surface conductivities decrease exponentially as the crystal thickness increases until ∼4 µm, beyond which the surface conductivity saturates. Investigation of the surface morphology using optical and atomic force microscopy reveals that thicker crystals have a higher number of molecular steps, increasing the overall surface roughness compared with thin crystals. The density of molecular steps as a surface trap is further quantified with the subthreshold slope of rubrene air-gap transistors. This thickness-dependent surface conductivity is rationalized by a shift from in-plane to out-of-plane transport governed by surface roughness. The surface transport is disrupted by roughening of the crystal surface and becomes limited by the slower vertical crystallographic axis on molecular step edges. Separately, we investigate surface-doping of rubrene crystals by using fluoroalkyltrichrolosilane and observe a different mechanism for charge transport which is independent of surface roughness. This work demonstrates that the correlation between crystal thickness, surface morphology, and charge transport must be taken into account when measuring organic single crystals. Considering the fact that these molecular steps are universally observed on organic/inorganic and single/polycrystals, we believe that our findings can be widely applied to improve charge transport understanding.

Poly[2,5-bis(3-dodecylthiophen-2-yl)thieno[3,2-b]thiophene] Oligomer Single-Crystal Nanowires from Supercritical Solution and Their Anisotropic Exciton Dynamics.

Supercritical fluids, exhibiting a combination of liquid-like solvation power and gas-like diffusivity, are a relatively unexplored medium for processing and crystallization of oligomer and polymeric semiconductors whose optoelectronic properties critically depend on the microstructure. Here we report oligomer crystallization from the polymer organic semiconductor, poly[2,5-bis(3-dodecylthiophen-2-yl)thieno[3,2-b]thiophene] (PBTTT) in supercritical hexane, yielding needle-like single crystals up to several microns in length. We characterize the crystals' photophysical properties by time- and polarization-resolved photoluminescence (TPRPL) spectroscopy. These techniques reveal two-dimensional interchromophore coupling facilitated by the high degree of π-stacking order within the crystal. Furthermore, the crystals obtained from supercritical fluid were found to be similar photophysically as the crystallites found in solution-cast thin films and distinct from solution-grown crystals that exhibited spectroscopic signatures indicative of different packing geometries.

Impact of morphology on polaron delocalization in a semicrystalline conjugated polymer.

We investigate the delocalization of holes in the semicrystalline conjugated polymer poly(2,5-bis(3-alkylthiophene-2-yl)thieno[3,2-b]thiophene) (PBTTT) by directly measuring the hyperfine coupling between photogenerated polarons and bound nuclear spins using electron nuclear double resonance spectroscopy. An extrapolation of the corresponding oligomer spectra reveals that charges tend to delocalize over 4.0-4.8 nm with delocalization strongly dependent on molecular order and crystallinity of the PBTTT polymer thin films. Density functional theory calculations of hyperfine couplings confirm that long-range corrected functionals appropriately describe the change in coupling strength with increasing oligomer size and agree well with the experimentally measured polymer limit. Our discussion presents general guidelines illustrating the various pitfalls and opportunities when deducing polaron localization lengths from hyperfine coupling spectra of conjugated polymers.

Oligothiophene semiconductors: synthesis, characterization, and applications for organic devices.

Oligothiophenes provide a highly controlled and adaptable platform to explore various synthetic, morphologic, and electronic relationships in organic semiconductor systems. These short-chain systems serve as models for establishing valuable structure-property relationships to their polymer analogs. In contrast to their polymer counterparts, oligothiophenes afford high-purity and well-defined materials that can be easily modified with a variety of functional groups. Recent work by a number of research groups has revealed functionalized oligothiophenes to be the up-and-coming generation of advanced materials for organic electronic devices. In this review, we discuss the synthesis and characterization of linear oligothiophenes with a focus on applications in organic field effect transistors and organic photovoltaics. We will highlight key structural parameters, such as crystal packing, intermolecular interactions, polymorphism, and energy levels, which in turn define the device performance.

Synthesis and structure-property evaluation of cellulose ω-carboxyesters for amorphous solid dispersions.

The use of amorphous solid dispersions (ASDs) is an effective and increasingly widely used approach for solubility enhancement of drugs and drug candidates with poor aqueous solubility. Successful molecular dispersion of drugs in polymer matrices requires new polymers that are designed to meet all ASD requirements, including drug release and prevention of drug recrystallization in storage or from solution. We describe herein design and synthesis of a new series of cellulose ω-carboxyalkanoates for ASDs, by reaction of cellulose with long-chain diacids that have been monoprotected as benzyl esters at one end, and monoactivated as acid chlorides at the other. Glass transition temperatures (Tg) of these cellulose ω-carboxyesters exceed ambient temperature by at least 50 °C, providing a sufficient ΔT to prevent drug mobility and crystallization. Cellulose acetate suberates and sebacates prepared in this way are extraordinary solution crystal growth inhibitors for the poorly soluble anti-HIV drug ritonavir. These new cellulose ω-carboxyesters have strong potential as ASD polymers for enhancement of drug solubility and bioavailability.