A probe for measuring current density during magnetic stimulation.

Time-varying magnetic fields induce currents in conductive media, and when the induced current is large enough in excitable tissue, stimulation occurs. This phenomenon has been applied to the human brain and peripheral nerves for diagnostic evaluation of the neural system. One important aspect that is presently unknown is the current level necessary in tissue for stimulation induced by magnetic fields. This study presents a method of measuring the induced current density from pulsed magnetic fields in vitro and in vivo. The current-density probe was inserted into three concentrations of saline and into the brains of ten anesthetized cats. Two stimulation systems with coils 9 cm and 5 cm in diameter were used. The two systems provided sinusoidal and pulsatile coil currents. Measurements made in saline were compared with those calculated theoretically for a semi-infinite medium. The measured values were within 5% of the calculated values. Measurements made in the cat brain showed a 67% decrease compared with the theoretic model. This variance is attributed to the finite bounds of the skull. The results indicate that direct measurement of current density is possible. Subsequent measurements will aid in the design of improved magnetic stimulation systems.

Determination of tissue viability in experimental electrical injuries.

Electrical burns or ischemia (induced by vascular ligation) were produced in the legs of 15 anesthetized dogs to study evolution of tissue changes compared with impedance alterations. After the application of 1-ampere currents at 60 Hz, animals were monitored from 1 to 4 days. Muscle impendance was measured with frequency sweeping to determine tissue destruction. Nuclear magnetic resonance spectroscopy (phosphorus 31) was used to assess metabolic activity, and results were compared to impedance measurements. In burned limbs, 70% reduction in muscle impedance was seen, which corresponds to decreased metabolic activity (absent organic phosphates) and suggests necrosis. Visually viable tissue had impedance decreases of 25% and levels of organic phosphates slightly lower than normal. Relaxation frequencies in dogs with severe burns exceeded 80 kHz; in viable tissue, 30 to 40 kHz (normal: 30 kHz). In ischemic muscle, organic phosphates decreased rapidly (1 to 2 hours); impedance changes evolved more slowly (1 day), but they ultimately reached the same degree of severity. Measurement of impedance may be a valuable adjunct in the evaluation of electrical burns, since significant changes strongly suggest nonviability.

Fibrillation induced at powerline current levels.

Electrical fibrillation of the human heart results in many unfortunate deaths. Because little information is available on short duration high current fibrillation, current levels below 1 and 50 A were used to induce ventricular fibrillation in hogs. Application times ranged between 16 ms and 3 s. Fibrillation was only produced when currents were applied during the T-wave period of the cardiac cycle. However, only 50 percent of the current application during the T-wave caused fibrillation. The total body resistance of the hogs was also measured at the high voltages and currents. The average resistance for 90 current applications was 284 omega. Trends in the data show that the total resistance decreases for increasing voltage, for increasing electrode size, and for current applications following the first current application.

A new technique for subchoroidal implantation of experimental malignant melanoma.

A new technique for implanting Greene hamster amelanotic melanoma cells into the rabbit eye is described. The technique involves the deposition of a tumor fragment into the subchoroidal space via a transvitreal approach. Thirty rabbit eyes were implanted with 26 successful tumor growths producing solitary choroidal nodules. This technique offers the advantages of rapid implantation, the ability to precisely choose the site of implantation including posterior sites, and eliminates the need for a large scleral incision.

Comparison of the failure biomechanics of spinal fixation devices.

The failure biomechanics of Harrington distraction rods, modified Weiss springs, and Luque rods were studied in intact cadavers and isolated spinal columns using flexion-compression loading. Most spines fractured at T-11 or T-12 at applied loads ranging between 556 and 4220 newtons (mean = 1833 N). After Harrington distraction rod placement, the same spines failed at a mean load of 859 N (42% of control), always as a result of hook extrusion and often including lamina fracture (seven cases). When modified Weiss springs were used, the spines failed at a mean load of 1128 N (54% of control) by allowing the spine to bend to the initial failure angle; in most instances, deformities resolved when the load was reduced. Luque rods were tested in four specimens; these provided the most rigid stabilization and failed at 83% of control values. Modified Weiss springs often maintain spinal stability better than Harrington distraction rods.

Measure of tissue resistivity in experimental electrical burns.

Studies were conducted in 14 mongrel dogs to compare resistivities in normal muscle with those from muscle subjected to electrical burns. One-ampere, 60-Hz currents were passed between the hind limbs of the dogs producing injury in three measurement regions of the gracilis muscle. Histology, heart rate, body temperature, arterial and pulmonary artery pressure, cardiac output, hematocrit, leukocyte counts, fibrinogen levels, and platelet levels were determined. Muscle resistivity associated with severe tissue necrosis was 70% lower than control values. Resistivity in tissue showing edema and minimal necrosis decreased 20 to 40% from control values. Muscle showing only edema had a 10 to 30% decrease in resistivity.

Compression injuries of the cervical spine: a biomechanical analysis.

Three intact cadavers and 10 isolated cervical spinal columns underwent compression, with forces directed vertically, forward, or rearward. Failure modes were often different than force directions. The loads required to produce bony injury or ligamentous disruption ranged from 645 to 7439 N. Flexion and extension injuries were produced at approximately 50% of the loads required for axial compression failures. The direction of force delivery correlated only partially with the resulting pathological condition. Clinical decisions based on retrospective analysis of roentgenograms may not account for the variability of forces and the prominence of ligament injuries seen in spinal trauma. Some of the difficulties encountered in biomechanical analyses of spinal trauma are discussed.

Experimental electrical injury studies.

Voltages from 10 to 14,000 volts demonstrated currents up to 70 amperes with resistances of approximately 200 ohms in studies in hogs. Below 1,000 volts, a current reduction is observed following arcing and skin necrosis. At the higher voltages, this phenomenon was not observed. The energy required for tissue damage was dependent upon the voltage and time of application. The tissue electrode resistance with stainless steel disc was proportional to the diameter. Skin buring commenced at the periphery of the electrodes and moved inwards. For application of currents between the hindlimbs of the hog, the current per tissue cross-section was greatest in artery and nerve, followed by muscle, fat, bone marrow, and bone cortex.