How does the high pressure affects the solubility of the drug within the polymer matrix in solid dispersion systems.

In this paper, we employed Broadband Dielectric Spectroscopy (BDS) in order to determine the effect of the high pressure on the solubility limits of the amorphous flutamide within Kollidon VA64 matrix. In order to achieve this goal, drug-polymer systems have been examined: (i) at ambient pressure and both isothermal and nonisothermal conditions by means of BDS as well as Differential Scanning Calorimetry (DSC), to validate proposed method; (ii) at high pressure conditions (20 and 50 MPa) and elevated temperatures (343 K, 353 K and 363 K) by means of dielectric spectroscopy. Our studies revealed that regardless of applied pressure the solubility of the flutamide within the co-polymer matrix increases with increasing temperature at isobar conditions. Moreover, our results clearly indicate that with increasing pressure the solubility of the drug within the polymer matrix is decreasing at isothermal conditions. Therefore, during the solubility limit studies one should consider the situation in which by increasing the pressure (at constant temperature) would achieve an effect similar to the lowering of the temperature (at constant pressure).

Broadband dielectric spectroscopy as an experimental alternative to calorimetric determination of the solubility of drugs into polymer matrix: Case of flutamide and various polymeric matrixes.

In this paper we determined the solubility limits of the amorphous flutamide within the two different polymeric matrixes - poly vinylpyrrolidone and poly vinylacetate. In order to achieve this goal, series of broadband dielectric spectroscopy measurements were performed. As a result we found that the maximal amount of the drug that can be successfully dissolved within the PVAc (maintaining the non-supersaturated conditions) is equal to 35 wt% of the amorphous solid dispersion system. Interestingly enough similar results, in terms of solubility limits, were achieved utilizing significantly higher amount of the pharmaceutical - 71 wt% - in the PVP matrix. Accordingly, we established the following relationship in the solubility limits of the amorphous flutamide dispersed within examined polymer matrixes: PVP > PVAc. It is worth highlighting that in order to preserve the thermodynamic stability - one of the two contributors to the physical stability - drug loading in the amorphous solid dispersion system should not exceed its solubility limits. Hence, choosing appropriate amount of the polymer addition will determine if obtained system remains physically stable. Subsequently, we presented the "stability maps" for all investigated FL-based ASD systems from which one might predict the stabilization effect exerted by certain amount of polymer.

A New Method To Identify Physically Stable Concentration of Amorphous Solid Dispersions (I): Case of Flutamide + Kollidon VA64.

In this paper, a novel approach to determine stable concentration in API-polymer systems is presented. As a model, binary amorphous mixtures flutamide (FL) drug with a copolymer Kollidon VA64 (PVP/VA) have been used. It is worthwhile to note that finding an effective method to achieve this goal is a matter of great importance because physical stability of the amorphous pharmaceuticals is the key issue that is investigated worldwide. Due to the fact that molecular dynamics was found to be the crucial factor affecting physical stability of disordered pharmaceuticals, we examined it for both neat FL and its PVP/VA mixtures by means of broadband dielectric spectroscopy (BDS). Thorough investigation of the impact of polymeric additive on the molecular mobility of disordered FL reveals unusual, previously unreported behavior. Namely, simultaneously with the beginning of the recrystallization process, we observe some transformation from unstable supersaturated concentration of investigated mixture to the different, unknown concentration of FL-PVP/VA. Observed, during BDS experiment, transformation enables us to determine the limiting, highly physically stable concentration of FL in PVP/VA polymer (saturated solution), which is equivalent to FL + 41% wt. of PVP/VA. The described high physical stability of this unveiled system has been confirmed by means of long-term XRD measurements. According to our knowledge, this is the first time when such a behavior has been observed by means of BDS.

Molecular Factors Governing the Liquid and Glassy States Recrystallization of Celecoxib in Binary Mixtures with Excipients of Different Molecular Weights.

Transformation of poorly water-soluble crystalline pharmaceuticals to the amorphous form is one of the most promising strategies to improve their oral bioavailability. Unfortunately, the amorphous drugs are usually thermodynamically unstable and may quickly return to their crystalline form. A very promising way to enhance the physical stability of amorphous drugs is to prepare amorphous compositions of APIs with certain excipients which can be characterized by significantly different molecular weights, such as polymers, acetate saccharides, and other APIs. By using different experimental techniques (broadband dielectric spectroscopy, differential scanning calorimetry, X-ray diffraction) we compare the effect of adding the large molecular weight polymer-polyvinylpyrrolidone (PVP K30)-and the small molecular weight excipient-octaacetylmaltose (acMAL)-on molecular dynamics as well as the tendency to recrystallization of the amorphous celecoxib (CEL) in the amorphous solid dispersions: CEL-PVP and CEL-acMAL. The physical stability investigations of the binary systems were performed in both the supercooled liquid and glassy states. We found that acMAL is a better inhibitor of recrystallization of amorphous CEL than PVP K30 deep in the glassy state (T < Tg). In contrast, PVP K30 is a better crystallization inhibitor of CEL than acMAL in the supercooled liquid state (at T > Tg). We discuss molecular factors governing the recrystallization of amorphous CEL in examined solid dispersions.

Impact of BaTiO(3) nanoparticles on pretransitional effects in liquid crystalline dodecylcyanobiphenyl.

The pretransitional behavior of dodecylcyanobiphenyl (12CB) (isotropic-smectic-A-solid mesomorphism) with d=50nmBaTiO(3) nanoparticles (NPs) linked to the cubic phase was monitored via temperature studies of dielectric constant. Tests were carried out in the isotropic, liquid crystal mesomorphic, and solid phases. For each phase transition the same value of the critical exponent α∼0.5 was obtained, including nanocolloids. All phase transitions show the weakly discontinuous nature. The temperature metric of the discontinuity ΔT notably decreases when adding nanoparticles. The addition of nanoparticles first decreases the dielectric constant by approximately 50% in comparison with pure 12CB, but already for a concentration ∼x=0.4% NP an increase over 50% takes place. It is notable that for the latter concentration unique hallmarks of the pretransitional effect emerge also for the solid-mesophase transition. All these indicate the important impact of nanoparticles on multimolecular mesoscale fluctuations.

Development of high-density DNA microarray membrane for profiling smoke- and hydrogen peroxide-induced genes in a human bronchial epithelial cell line.

Development of the high-density DNA microarray technique permits the analysis of thousands of genes simultaneously for their differential expression patterns in various biological processes. Through clustering analysis and pattern recognition, the significance of differentially expressed genes can be recognized and correlated with biological events that may take place inside the cell and tissue. With this notion in mind, high-density DNA microarray nylon membrane with colorimetry detection was used to profile the expression of smoke- and hydrogen peroxide-inducible genes in a human bronchial epithelial cell line, HBE1. On the basis of the time course of expression, at least three phases of change in gene expression could be recognized. The first phase is an immediate event in response to oxidant injury. This phase includes induction of the bcl-2 and mdm-2 genes, which are involved in the regulation of apoptosis, and the mitogen-activated protein (MAP) kinase phosphatase 1 (MKP-1) gene, that functions as a regulator of various mitogen-activated protein kinase activities. The second phase, usually 5 h later, includes the induction of various stress proteins and ubiquitin, which are important in providing the chaperone mechanism and the turnover of damaged macromolecules. The third phase, which is 5-10 h later, includes the induction of genes that are apparently involved in reducing oxidative stress by metabolizing reactive oxygen species. In this phase, enzymes associated with tissue and cell remodeling are also elevated. These results demonstrate a complex gene expression array by bronchial epithelial cells in response to the insult of oxidants that are relevant to environmental pollutants.

Web damage and feeding experience influence web site tenacity in the orb-web spider Argiope keyserlingi Karsch.

For orb-web spiders, the decision to remain at a particular site or to relocate elsewhere will ultimately depend on the quality of the site. In the past, the quality of the site has been measured in terms of prey availability; spiders experiencing large numbers of prey items are less likely to relocate. However, regular web damage caused by larger nonprey animals may also contribute to the quality of a particular site. Laboratory experiments revealed that the frequency and extent of web relocation by the orb-web spider Argiope keyserlingi was influenced by the feeding regime and the rate of nonprey web damage. Daily movement patterns were influenced by web damage, and these movements were in the direction away from the source of damage. However, the cumulative distance moved during the 7 days of the experiment was influenced by the frequency with which spiders were fed. Spiders that were not given prey moved further than spiders that obtained prey. These data indicate that spiders respond to web damage on a daily basis, but the cumulative movement of spiders over a longer period is influenced mostly by the history of prey ingestion rate. Copyright 2000 The Association for the Study of Animal Behaviour.

Differential expression of stress proteins in nonhuman primate lung and conducting airway after ozone exposure.

The presence of seven stress proteins including various heat shock proteins [27-kDa (HSP27), 60-kDa (HSP60), 70-kDa (HSP70) and its constitutive form HSC70, and 90-kDa (HSP90) HSPs] and two glucose-regulated proteins [75-kDa (GRP75) and 78-kDa (GRP78) GRPs] in ozone-exposed lungs of nonhuman primates and in cultured tracheobronchial epithelial cells was examined immunohistochemically by various monoclonal antibodies. Heat treatment (42 degrees C) resulted in increased HSP70, HSP60, and HSP27 and slightly increased HSC70 and GRP75 but no increase in GRP78 in primary cultures of monkey tracheobronchial epithelial cells. Ozone exposure did not elevate the expression of these HSPs and GRPs. All of these HSPs including HSP90, which was undetectable in vitro, were suppressed in vivo in monkey respiratory epithelial cells after ozone exposure. Both GRP75 and GRP78 were very low in control cells, and ozone exposure in vivo significantly elevated these proteins. These results suggest that the stress mechanism exerted on pulmonary epithelial cells by ozone is quite different from that induced by heat. Furthermore, differences between in vitro and in vivo with regard to activation of HSPs and GRPs suggest a secondary mechanism in vivo, perhaps related to inflammatory response after ozone exposure.

Lead content of small mammals at a roadside site in relation to the pathways of exposure.

Concentration of lead have been determined in three species of small mammal, Sorex araneus, Clethrionomys glareolus and Apodemus sylvaticus at roadside and control sites. The results are considered in relation to the lead content of the diet and the air, and it is concluded that the diet provides far the major pathway for lead exposure, even at the roadside site. Bone lead concentrations are found to be consistent with estimated lead exposure and metabolism.