Dual anode single-photon avalanche diode for high-speed and low-noise Geiger-mode operation.

The after-pulsing effect is a common problem in high-speed and low-noise single-photon detection based on single-photon avalanche diodes (SPADs). This article presents a dual anode InGaAs/InP SPAD (DA-SPAD) with two separate anode output ports that can be utilized for discriminating relatively weak avalanche signals, providing a simple and robust configuration of the SPAD-based single-photon detection system. Weak avalanche signals with amplitudes below the amplitude of the parasitic capacitive response of the SPAD were easily detected by the DA-SPAD and a simple subtraction circuit. The gated Geiger-mode performance of the DA-SPAD was also investigated. At a gating frequency of 1 GHz, the detection efficiency was 20.4% with an after-pulse probability of 3.5% at a temperature of -20 °C.

Active stabilization of a fiber-optic two-photon interferometer using continuous optical length control.

The practical realization of long-distance entanglement-based quantum communication systems strongly rely on the observation of highly stable quantum interference between correlated single photons. This task must accompany active stabilization of the optical path lengths within the single-photon coherence length. Here, we provide two-step interferometer stabilization methods employing continuous optical length control and experimentally demonstrate two-photon quantum interference using an actively stabilized 6-km-long fiber-optic Hong-Ou-Mandel interferometer. The two-step active control techniques are applied for measuring highly stable two-photon interference fringes by scanning the optical path-length difference. The obtained two-photon interference visibilities with and without accidental subtraction are found to be approximately 90.7% and 65.4%, respectively.

Weak avalanche discrimination for gated-mode single-photon avalanche photodiodes.

The after-pulsing effect is a common problem that needs to be overcome for high-speed single-photon detection based on gated-mode single-photon avalanche photodiodes (SPADs). This paper presents a simple and practical method for suppression of the after-pulsing probability using an auxiliary signal to discriminate quite weak avalanches. The detection efficiency and after-pulse probability of an InGaAs/InP SPAD are investigated with a 10 MHz gating for conventional and proposed methods, and a sharp decrease of after-pulse probability is demonstrated with the application of the proposed method. At a gating frequency of 100 MHz, a detection efficiency of 10.4% is achieved with an after-pulse probability of 5.6% without dead time.

Stabilization of a long-armed fiber-optic single-photon interferometer.

We report on single-photon interference experiments in a Michelson-type interferometer built with two 6-km-long fiber spools, as well as on the active stabilization of the interferometer. A weak coherent light signal was (de-) multiplexed with a strong reference light using wavelength-division multiplexing technique, and real-time feedback control technique was applied for the reference light to actively stabilize the phase fluctuation in the long-armed fiber interferometer. The stabilized interferometer showed phase stability of 0.06 rad, which corresponds to an optical path length fluctuation of 15 nm between the 6-km-long interfering arms. The raw visibility obtained without subtracting noise counts in the single-photon interference experiment was more than 98% for stabilized conditions.

Two-photon quantum interference in the 1.5 mum telecommunication band.

We report on two-photon quantum interference experiments in the standard telecommunication band. Two identical photons in the 1.5 mm wavelength band were generated in spatially separated modes by a type-I spontaneous parametric down-conversion process, and injected into a fiber-optic Hong-Ou-Mandel interferometer. Two-photon interference patterns of dip and spatial beating in the coincidence counting rate were observed by varying the difference in optical path lengths. The visibilities obtained in the net coincidences were close to the theoretical value of 100%. The raw visibilities were also well above the classical limit.

Noncollinear correlated photon pair source in the 1550 nm telecommunication band.

We present a source of noncollinear correlated photon pairs in the standard 1550 nm telecommunication band. They are generated by a spontaneous parametric down-conversion process and emitted in a cone because of type-I noncollinear phase matching. Within the band, the source gives a completely flexible choice of the frequencies of the photon pairs, and correlation properties related to spatial momentum as well as energy and time can easily be utilized.We characterize the source by measuring the spatial intensity distribution of the down-converted light and by performing coincidence counting.

Pulse width dependence of Brillouin frequency in single mode optical fibers.

Stimulated Brillouin scattering in optical fibers can be used to measure strain or temperature in a distributed manner. Brillouin optical time domain analysis (BOTDA) is the most common sensor system based on the Brillouin scattering. This paper presents the experimental analysis of the characteristics of Brillouin gain spectrum (BGS) influenced by the width of launched pulse. Brillouin strain coefficient is also examined for the different pulse widths, which is important to apply a Brillouin scattering-based sensor to a structural health monitoring. Experimental results showed that not only the Brillouin linewidth and gain but also the Brillouin frequency were dependent on the pulse widths.

Strain event detection using a double-pulse technique of a Brillouin scattering-based distributed optical fiber sensor.

Stimulated Brillouin scattering in optical fibers can be used to measure strain or temperature in a distributed manner. Brillouin optical time domain analysis (BOTDA) is the most common sensor system based on the Brillouin scattering. To improve the spatial resolution of these measurements, shorter pulses must be used, resulting in reduced signal powers causing a decrease of the dynamic range. In this paper, a doublepulse technique was proposed to enhance the spatial resolution of BOTDA. Experimental results showed that the ability to resolve two adjacent events could be enhanced, about twice, by using a double-pulsed pump light without decreases in the dynamic range.