Characterization of RDX and HMX explosive adduct ions using ESI FT-ICR MS.

Investigation of two common explosives such as cyclonite (RDX) and cyclotetramethylenetetranitramine (HMX) using a mass spectrometer with ultrahigh resolution and accuracy has not been comprehensively performed. Here, ultrahigh mass accuracy 15-T Fourier transform-ion cyclotron resonance mass spectrometry (FT-ICR MS) spectra were utilized to comprehensively characterize the adduct ions of RDX and HMX. Two different ionization sources such as a conventional electrospray ionization (ESI) source and a chip-based static nano-ESI source were used to investigate the adduct ions of RDX and HMX. The ESI-MS analyses of two explosives in negative ion mode provide some adduct ions of RDX and HMX even without prior addition of their corresponding anions. A total of six types of adduct ion were characterized: [M + Cl]- , [M + HCOO]- , [M + NO2 ]- , [M + CH3 COO]- , [M + NO3 ]- , and [M + C3 H5 O3 ]- , where M is either RDX or HMX. The ultrahigh accuracy of the 15-T FT-ICR MS was utilized to distinguish two closely spaced peaks representing the monoisotopic [M + NO2 ]- and second isotopic [M + HCOO]- ions, thereby enabling the discovery of a [M + NO2 ]- adduct ion in the ESI analysis of RDX or HMX. [M + NO2 ]- and [M + CH3 COO]- adduct ions were only observed when using a static nano-ESI source. It is the first report explaining the discovery of [M + NO2 ]- adduct ion in the ESI-MS analyses of RDX and HMX.

Ti(N5)4 as a Potential Nitrogen-Rich Stable High-Energy Density Material.

We have studied molecular structures and kinetic stabilities of M(N5)3 (M = Sc, Y) and M(N5)4 (M = Ti, Zr, Hf) complexes theoretically. All of these compounds are found to be stable with more than a 13 kcal/mol of kinetic barrier. In particular, Ti(N5)4 showed the largest dissociation energy of 173.0 kcal/mol and thermodynamic stability. This complex had a high nitrogen content (85% by weight), and a significantly high nitrogen to metal ratio (20:1) among the neutral M(N5)n species studied here and in the literature. Ti(N5)4 is thus forecasted to be a good candidate for a nitrogen-rich high-energy density material (HEDM). We reveal in further detail using ab initio molecular dynamics simulations that the dissociation pathways of M(N5)n involve the rearrangements of the bonding configurations before dissociation.

Molecular dynamics study of the behavior of nitromethanes enclosed inside carbon nanotube containers.

We utilized molecular dynamics (MD) to investigate the behavior of nitromethane molecules (NMs) enclosed inside carbon nanotube (CNT) containers sealed with buckybowl caps. Two different sizes of CNT containers, i.e., (10,10) and (20,20), were employed to contain the energetic NMs. After loading the NMs into these containers, MD simulations were carried out at different loading densities. The loading density was changed from 0.4 to 2.0 g/cc. At low loading densities, NMs preferentially resided near the surface of the CNT wall (orienting themselves in the cylindrical direction) and near the buckybowl caps (orienting themselves in the principal-axis direction). This behavior suggests the buckybowl caps and the CNT wall have attractive interactions with the NMs. The distribution of the NMs inside the containers did not change upon increasing the temperature from ambient to 100 °C. However, the positional preference of the NMs found at ambient temperature to 100 °C was not the same as that observed at 1000 °C due to the increased thermal motions of the NMs. The size of the CNT container had a significant effect on the fluidity of the NMs. From 25 to 100 °C, the NMs inside the (10,10) CNT container were only mobile at low loading densities. On the other hand, in the (20,20) CNT container, the NMs showed good mobility up to a loading density of 1.6 g/cc. Graphical Abstract Attractive interactions between the nitromethanes and the buckybowl caps as well as the carbon nanotube wall.

Silicon quantum dot sensors for an explosive taggant, 2,3-dimethyl-2,3-dinitrobutane (DMNB).

Silicon quantum dots obtained by the reaction of magnesium silicide with ethylenediamine dihydrochloride were utilized to investigate the sensing mechanism and sensitivity for DMNB detection applications. Sensing DMNB provided us with evidence that Si QDs with a higher lying conduction band have better sensitivity compared to CdSe QDs.

A priori prediction of heats of vaporization and sublimation by EFP2-MD.

New theoretical procedures were proposed for the heats of vaporization (ΔHvap) and sublimation (ΔHsub) predictions by adopting effective fragment potential version 2-molecular dynamics (EFP2-MD) simulations. The particular EFP2, as generated by HF/6-31++G(2d,2p), yielded excellent results in the predictions of ΔHvap, where mean absolute deviation (MAD) and root-mean-square deviation (RMSD) for 16 molecules were 0.34 and 0.44 kcal/mol, respectively. By introducing a uniform scaling factor, we further derived a prediction procedure for ΔHsub, where its MAD and RMSD were 0.76 and 0.90 kcal/mol, respectively. Because EFP2-MD does not require any ab initio computations during simulation, computational overhead of our procedures is minimal. We believe that our new procedures for the ΔHvap and ΔHsub predictions could be widely applicable in the areas where accurate chemical information for virtual molecules is critical.

Analysis of explosives using corona discharge ionization combined with ion mobility spectrometry-mass spectrometry.

Corona discharge ionization combined with ion mobility spectrometry-mass spectrometry (IMS-MS) was utilized to investigate five common explosives: cyclonite (RDX), trinitrotoluene (TNT), pentaerythritol tetranitrate (PETN), cyclotetramethylenetetranitramine (HMX), and 2,4-dinitrotoluene (DNT). The MS scan and the selected ion IMS analyses confirmed the identities of the existing ion species and their drift times. The ions observed were RDX·NO3(-), TNT(-), PETN·NO3(-), HMX·NO3(-), and DNT(-), with average drift times of 6.93 ms, 10.20 ms, 9.15 ms, 12.24 ms, 11.30 ms, and 8.89 ms, respectively. The reduced ion mobility values, determined from a standard curve calculated by linear regression of (normalized drift times)(-1) versus literature K0 values, were 2.09, 1.38, 1.55, 1.15, 1.25, and 1.60 cm(2) V(-1) s(-1), respectively. The detection limits were found to be 0.1 ng for RDX, 10 ng for TNT, 0.5 ng for PETN, 5.0 ng for HMX, and 10 ng for DNT. Simplified chromatograms were observed when nitrogen, as opposed to air, was used as the drift gas, but the detection limits were approximately 10 times worse (i.e., less sensitivity of detection).

Ultrasensitive trace analysis for 2,4,6-trinitrotoluene using nano-dumbbell surface-enhanced Raman scattering hot spots.

We report an ultra-sensitive surface-enhanced Raman scattering (SERS)-based detection system for 2,4,6-trinitrotoluene (TNT) using nano-dumbbell structures formed by the electrostatic interaction between positively and negatively charged gold nanoparticles. First, Meisenheimer complexes were produced between TNT and l-cysteine on gold substrates, and 4-mercaptopyridine (4-MPY) labeled gold nanoparticles (positively charged) were allowed to interact with the Meisenheimer complexes through the electrostatic interaction between the negatively charged aromatic ring of the complex molecules and the positively charged nanoparticles. Then, negatively charged gold nanoparticles were added in order to form nano-dumbbells. As a result, many hot junctions were generated by the dumbbell structures, and the SERS signals were greatly enhanced. Our experimental results demonstrate that the SERS-based assay system using nano-dumbbells provides an ultra-sensitive approach for the detection of TNT explosives. It also shows strong potential for broad application in detecting various explosive materials used for military purposes.

Quantum dot-engineered M13 virus layer-by-layer composite films for highly selective and sensitive turn-on TNT sensors.

We developed quantum dot-engineered M13 virus layer-by-layer hybrid composite films with incorporated fluorescence quenchers. TNT is designed to displace the quenchers and turn on the quantum dot fluorescence. TNT was detected at the sub ppb level with a high selectivity.

Theoretical studies on the formation mechanism and explosive performance of nitro-substituted 1,3,5-triazines.

To develop new highly energetic materials, we have considered the design of molecules with high nitrogen content. Possible candidates include 1,3,5-triazine derivatives. In this work, we studied potential synthetic routes for melamine using the MP2/6-31+G(d,p)//B3LYP/6-31G(d) level of theory. The mechanisms studied here are stepwise mechanism beginning with the dimerization of cyanamide and one-step termolecular mechanism. The same type of mechanism is also applied to nitro-substituted 1,3,5-triazines. Values for the heat of formation in the solid phase were predicted from density functional theory calculations. Densities were estimated from a regression equation obtained by molecular surface electrostatic potentials. The Cheetah program was used to study the explosive performance of these compounds. In this study, we found that the explosive properties of 2-amino-4, 6-dinitro-1, 3,5-triazine (ADNTA), and 2,4,6-trinitro-1,3,5-triazine (TNTA) are similar to those of RDX and HMX, respectively.

Prediction of densities for solid energetic molecules with molecular surface electrostatic potentials.

The densities of high energetic molecules in the solid state were calculated with a simplified scheme based on molecular surface electrostatic potentials (MSEP). The MSEP scheme for density estimation, originally developed by Politzer et al., was further modified to calculate electrostatic potential on a simpler van der Waals surface. Forty-one energetic molecules containing at least one nitro group were selected from among a variety of molecular types and density values, and were used to test the suitability of the MSEP scheme for predicting the densities of solid energetic molecules. For comparison purposes, we utilized the group additivity method (GAM) incorporating the parameter sets developed by Stine (Stine-81) and by Ammon (Ammon-98 and -00). The absolute average error in densities from our MSEP scheme was 0.039 g/cc. The results based on our MSEP scheme were slightly better than the GAM results. In addition, the errors in densities generated by the MSEP scheme were almost the same for various molecule types, while those predicted by GAM were somewhat dependent upon the molecule types.

An ab Initio Study of Intramolecular Hydrogen Bondings in α-Hydroxy Ketomethylene Dipeptide Isostere.

Ab initio calculations of the representative α-hydroxy ketomethylene dipeptide isostere (2S,5S)-5-amino-2-hydroxy-4-oxohexanoic acid (1) are described. All calculations including full geometry optimizations were performed at the MP2/6-31G* level. In the gas phase, 12 low-energy conformers are located by minimizing geometries assembled from stable molecular fragments. Among these conformers, six structurally similar conformers, in which the 2-hydroxyl group forms hydrogen bondings with both the O atom of the 4-carbonyl group in 1,3-fashion and the O atom of 1-carboxylic acid in 1,2-fashion simultaneously, are found to be particularly stable. Thus, the conformational preference of 1 appears to be governed by arrangements and strength of intramolecular hydrogen bondings. To examine conformational natures of 1 in solutions more accurately, we corrected the thermochemical properties and carried out self-consistent reaction field calculations. Going from the gas phase to solutions, the basic features of the conformational preferences in 1 also appear to be maintained in solutions including a highly polar aqueous medium, despite slight changes in the population of each conformer.