Synchronized Improvements in the Protective and Bioactive Properties of Plasma-Electrolyzed Layers via Cellulose Microcrystalline.

This study reports synchronized improvements in the protective and bioactive properties of Ti-6Al-4V alloy through the formation of titania-based inorganic layers by considering the role of cellulose microcrystalline (CMC) additive into account. Acetate-phosphate-based electrolyte with cellulose CMC is formulated for the first time to modify the porous structure of the oxide layers made via plasma electrolysis of Ti-6Al-4V alloy. The presence of CMC (0, 1, 2, 3 g/L) changed the characteristics of plasma discharges where porous oxide layers with different pore sizes and surface roughness were obtained. A rough oxide layer with large pores was found in the 3 g/L CMC, while a slightly smoother oxide layer with smaller pores was obtained in the case of 2 g/L CMC. The -OH groups in CMC would facilitate the formation of an adsorption layer on the substrate surface, affecting the sparking behavior during plasma electrolysis (PE). Due to a synergy between controlled microstructure, surface roughness, and the insertion of bioactive phases, the coated samples in CMC-containing electrolytes displayed protective and bioactive properties simultaneously. Based on the obtained results, the samples coated in CMC-containing electrolytes can be used as safe implants to replace missing teeth in dental applications.

Low elastic modulus Ti-Ta alloys for load-bearing permanent implants: enhancing the biodegradation resistance by electrochemical surface engineering.

In this study, the in vitro degradation behaviour of titanium-tantalum (Ti-Ta) alloys (10-30 wt.% Ta) was investigated and compared with conventional implant materials, i.e., commercially pure titanium (Cp-Ti) and titanium-aluminium-vanadium (Ti6Al4V) alloy. Among the three Ti-Ta alloys studied, the Ti20Ta (6.3×10(-4) mm/y) exhibited the lowest degradation rate, followed by Ti30Ta (1.2×10(-3) mm/y) and Ti10Ta (1.4×10(-3) mm/y). All the Ti-Ta alloys exhibited lower degradation rate than that of Cp-Ti (1.8×10(-3) mm/y), which suggests that Ta addition to Ti is beneficial. As compared to Ti6Al4V alloy (8.1×10(-4) mm/y), the degradation rate of Ti20Ta alloy was lower by ~22%. However, the Ti30Ta alloy, which has closer elastic modulus to that of natural bone, showed ~48% higher degradation rate than that of Ti6Al4V alloy. Hence, to improve the degradation performance of Ti30Ta alloy, an intermediate thin porous layer was formed electrochemically on the alloy followed by calcium phosphate (CaP) electrodeposition. The coated Ti30Ta alloy (3.8×10(-3) mm/y) showed ~53% lower degradation rate than that of Ti6Al4V alloy. Thus, the study suggests that CaP coated Ti30Ta alloy can be a viable material for load-bearing permanent implants.