Electrostatic Induction Nanogenerator Boosted by One-Dimensional Metastructure: Application to Energy and Information Transmitting Smart Tag System.

The recent application of the internet of things demands the ubiquitous utilization of data and electrical power. Even with the development of a wide variety of energy-harvesting technologies, few studies have reported a device transporting electrical energy and data simultaneously. This paper reports an electrostatic induction nanogenerator (ESING) consisting of a one-dimensional metastructure that can modulate the output voltage based on the resonance of ultrasound waves to transmit energy and data simultaneously. The ESING device is fabricated using electronegative poly(vinylidene fluoride) (PVDF) membrane using a phase inversion process. The output voltage from the ESING device exhibits periodic resonant peaks as the gap between the PVDF membrane and the Al electrode changes, showing an up to 35-fold difference between the maximum and minimum output voltages depending on the resonance state. The energy and electrical signal can be transmitted simultaneously in free space because the ESING converts energy from high-frequency ultrasound waves. This paper provides proof of concept for a data and energy-transferable smart tag device based on ESING devices exhibiting resonant and non-resonant states. A device consisting of four ESINGs for a 4-bit signal is implemented to demonstrate 16 signals.

Churros-like Polyvinylidene Fluoride Nanofibers for Enhancing Output Performance of Triboelectric Nanogenerators.

Triboelectric nanogenerators (TENGs) have emerged as a next-generation sustainable power source for Internet of Things technology. Polyvinylidene fluoride (PVDF) nanofibers (NFs) have been investigated widely to enhance the TENG performance by controlling their polarity; however, controlling the surface morphology of the PVDF NFs has rarely been studied. Here, surface-roughened, churros-like PVDF NFs were fabricated by controlling the solvent evaporation kinetics. The solvent evaporation rate was modulated by varying the relative humidity (RH) during the electrospinning process. With increasing RH, the fraction of polar ß-phase in the PVDF NFs increased, the specific surface area of the PVDF NFs increased gradually and the surface morphology changed from smooth to rough, finally resulting in a churros-like structure. Therefore, the output performance of the TENG devices was enhanced with increasing RH, because of the combined effects of the enlarged surface area and the increased fraction of the polar phase in the PVDF NFs. The TENG device with the churros-like PVDF NFs showed an output voltage of 234 V, current of 11 µA, and power density up to 1738 µW/cm2, giving it the capability to turn on 60 series-connected commercial light-emitting diodes without using an external charge storage circuit.