Distinct mutational pattern of T-cell large granular lymphocyte leukemia combined with pure red cell aplasia: low mutational burden of STAT3.

T-cell large granular lymphocyte leukemia (T-LGL) is often accompanied by pure red cell aplasia (PRCA). A high depth of next generation sequencing (NGS) was used for detection of the mutational profiles in T-LGL alone (n = 25) and T-LGL combined with PRCA (n = 16). Beside STAT3 mutation (41.5%), the frequently mutated genes included KMT2D (17.1%), TERT (12.2%), SUZ12 (9.8%), BCOR (7.3%), DNMT3A (7.3%), and RUNX1 (7.3%). Mutations of the TERT promoter showed a good response to treatment. 3 of 41 (7.3%) T-LGL patients with diverse gene mutations were revealed as T-LGL combined with myelodysplastic syndrome (MDS) after review of bone marrow slide. T-LGL combined with PRCA showed unique features (low VAF level of STAT3 mutation, low lymphocyte count, old age). Low ANC was detected in a STAT3 mutant with a low level of VAF, suggesting that even the low mutational burden of STAT3 is sufficient for reduction of ANC. In retrospective analysis of 591 patients without T-LGL, one MDS patient with STAT3 mutation was revealed to have subclinical T-LGL. T-LGL combined with PRCA may be classified as unique subtype of T-LGL. High depth NGS can enable sensitive detection of concomitant MDS in T-LGL. Mutation of the TERT promoter may indicate good response to treatment of T-LGL, thus, its addition to an NGS panel may be recommended.

Prolonged, acute suppression of cysteinyl leukotriene to reduce capsular contracture around silicone implants.

We hypothesize that periodically early, local suppression of cysteinyl leukotrienes (CysLTs), which are potent inflammatory mediators, can reduce the fibrotic capsular contracture around silicone implants. We tested this hypothesis with the silicone implants enabled with the sustained release of montelukast, a CysLT receptor antagonist, for 3 and 15days. In this work, we inserted each of the distinct implants into the pocket of the subpanniculus carnosus plane of living rats and performed histological and immunofluorescent (IF) analyses of the tissues biopsied at predetermined periods for 12weeks after implant insertion. The implants with montelukast exhibited significantly reduced polymorphonuclear leukocytes (i.e., PMNs), implying a concurrent reduction of CysLT. This effect was more prominent after long-term local montelukast exposure. Thus, fewer fibroblasts were recruited, thereby reducing transforming growth factor (TGF)-ß and myofibroblasts in the tissue around the implant. Therefore, the fibrotic capsule formation, which was assessed using the capsule thickness and collagen density, decreased along with the myofibroblasts. Additionally, the tissue biopsied at the experimental end point exhibited significantly decreased mechanical stiffness. STATEMENT OF SIGNIFICANCE: Capsular contracture is troublesome, making the tissues hardened around the silicone implant. This causes serious pain and discomfort to the patients, often leading to secondary surgery for implant replacement. To resolve this, we suggest a strategy of long-term, local suppression of cysteinyl leukotriene, an important mediator present during inflammation. For this, we propose a silicone implant abled to release a drug, montelukast, in a sustained manner. We tested our drug-release implant in living animals, which exhibited a significant decrease in capsule formation compared with the intact silicone implant. Therefore, we conclude that the sustained release of montelukast at the local insertion site represents a promising way to reduce capsular contracture around silicone implants.

Mucoadhesive microparticles with a nanostructured surface for enhanced bioavailability of glaucoma drug.

Topical drug administration to the eye is limited by low drug bioavailability due to its rapid clearance from the preocular surface. Thus, multiple daily administrations are often needed, but patient compliance is low, hence a high chance of unsatisfactory treatment of ocular diseases. To resolve this, we propose mucoadhesive microparticles with a nanostructured surface as potential carriers for delivery of brimonidine, an ocular drug for glaucoma treatment. For sustained drug delivery, the microparticles were composed mainly of a diffusion-wall material, poly(lactic-co-glycolic acid) and a mucoadhesive polymer, polyethylene glycol, was used as an additive. Due to their nanostructured surface, the microparticles with a mucoadhesive material exhibited a 13-fold increase in specific surface area and could thus adhere better to the mucous layer on the eye, as compared with the conventional spherical microparticles. When loaded with brimonidine, the mucoadhesive microparticles with a nanostructured surface increased both drug bioavailability and its activity period by a factor of more than 2 over Alphagan P, a marketed eye drop of brimonidine.

Bioabsorbable bone fixation plates for X-ray imaging diagnosis by a radiopaque layer of barium sulfate and poly(lactic-co-glycolic acid).

Bone fixation systems made of biodegradable polymers are radiolucent, making post-operative diagnosis with X-ray imaging a challenge. In this study, to allow X-ray visibility, we separately prepared a radiopaque layer and attached it to a bioabsorbable bone plate approved for clinical use (Inion, Finland). We employed barium sulfate as a radiopaque material due to the high X-ray attenuation coefficient of barium (2.196 cm(2) /g). The radiopaque layer was composed of a fine powder of barium sulfate bound to a biodegradable material, poly(lactic-co-glycolic acid) (PLGA), to allow layer degradation similar to the original Inion bone plate. In this study, we varied the mass ratio of barium sulfate and PLGA in the layer between 3:1 w/w and 10:1 w/w to modulate the degree and longevity of X-ray visibility. All radiopaque plates herein were visible via X-ray, both in vitro and in vivo, for up to 40 days. For all layer types, the radio-opacity decreased with time due to the swelling and degradation of PLGA, and the change in the layer shape was more apparent for layers with a higher PLGA content. The radiopaque plates released, at most, 0.5 mg of barium sulfate every 2 days in a simulated in vitro environment, which did not appear to affect the cytotoxicity. The radiopaque plates also exhibited good biocompatibility, similar to that of the Inion plate. Therefore, we concluded that the barium sulfate-based, biodegradable plate prepared in this work has the potential to be used as a fixation device with both X-ray visibility and biocompatibility.

Nanostructured mucoadhesive microparticles for enhanced preocular retention.

We describe nanostructured microparticles (NMs) containing a mucoadhesive polymer for enhanced preocular retention and consider them as potential carriers of drugs to the eye. These NMs are each composed of entangled nanofibers to give an enlarged specific surface area, and thus can better adhere to the preocular mucus surface. This physical design allows the microparticles still to be composed mainly of a wall material, poly(lactic-co-glycolic acid), as required for controlled drug delivery, while the effects of an additive, mucoadhesive material, polyethylene glycol, can be synergistically improved via the nanostructured morphology. Thus, when formulated in a dry tablet dosage form, the NMs in this work show more than a 10-fold increase in preocular retention in vivo compared to conventional spherical microparticles. Therefore, we conclude that these mucoadhesive NMs can reside on the preocular surface for a prolonged period, and thus appear to be a promising system for topical drug delivery to the eye.

Surgical suture assembled with polymeric drug-delivery sheet for sustained, local pain relief.

Surgical suture is a strand of biocompatible material designed for wound closure, and therefore can be a medical device potentially suitable for local drug delivery to treat pain at the surgical site. However, the preparation methods previously introduced for drug-delivery sutures adversely influenced the mechanical strength of the suture itself - strength that is essential for successful wound closure. Thus, it is not easy to control drug delivery with sutures, and the drug-delivery surgical sutures available for clinical use are now limited to anti-infection roles. Here, we demonstrate a surgical suture enabled to provide controlled delivery of a pain-relief drug and, more importantly, we demonstrate how it can be fabricated to maintain the mechanical strength of the suture itself. For this purpose, we separately prepare a drug-delivery sheet composed of a biocompatible polymer and a pain-relief drug, which is then physically assembled with a type of surgical suture that is already in clinical use. In this way, the drug release profiles can be tailored for the period of therapeutic need by modifying only the drug-loaded polymer sheet without adversely influencing the mechanical strength of the suture. The drug-delivery sutures in this work can effectively relieve the pain at the surgical site in a sustained manner during the period of wound healing, while showing biocompatibility and mechanical properties comparable to those of the original surgical suture in clinical use.