Co-hydrothermal carbonization with process water recirculation as a valuable strategy to enhance hydrochar recovery with high energy efficiency.

This study aims at valorizing the residual aqueous phase from hydrothermal carbonization (HTC) of Sicilian agro-wastes in order to enhance the hydrochar recovery, positively affecting the process energy balance. Process waters (PW) obtained from HTC and co-HTC using orange peel waste and fennel plant residues were used as recycled solvent in experiments carried out at the temperatures of 180 and 230 °C. The results showed that an additional hydrochar formation was promoted during recirculation of solvent, leading to average increments of solid mass yield of 10.5 wt% for tests conducted at 180 °C and 3.9 wt% for 230 °C. After five consecutive recirculation phases in co-HTC runs, the hydrochar yield increased up to 18.2 wt%. The low H/C and O/C atomic ratios values, found after recirculation, indicate that organic acids, accumulated in the PW, may catalyze the process and promote the biomass deoxygenation by boosting dehydration and decarboxylation. The recovered PWs from conversion steps with deionized water were also carbonized in absence of the solid feedstock in order to quantify their contribution in hydrochar formation during recirculation and thus the synergistic interactions. After recirculation, energy recovery averagely augmented by more than threefold, showing that the proposed strategy could significantly improve the sustainability of HTC.

Role of acidic hydrochar on dechlorination of waste PVC in high temperature hydrothermal treatment and fuel properties enhancement of solid residues.

In this study, the chlorine mitigation from waste polyvinyl chloride (WPVC) during high temperature co-hydrothermal treatment (co-HTT) and the properties of the generated solid products were assessed. WPVC was co-fed with acidic hydrochar (AHC), which was produced via hydrothermal carbonization of pineapple waste in the presence of citric acid water solution. High temperature co-HTT experiments were performed at 300-350 °C, 0.25-4 h of reaction time, and 0-20 wt% AHC loading. Co-HTT solid products (co-HTT_SP) were characterized via proximate analysis, ultimate analyses, combustion analysis, and ash analysis. The results show that the addition of 5% AHC enhances the dechlorination efficiency (DE) of WPVC from 89.35% to 97.66% at 325 °C and 0.5 h. The highest DE, reaching 99.46%, was achieved at 350 °C and 1 h in the presence of 5 wt% AHC. Furthermore, loading 5% AHC improved the higher heat value (HHV) of the solid products from 23.09 to 31.25 MJ/kg at 325 °C and 0.5 h. The maximum HHV (34.77 MJ/kg) of a solid product was achieved at 350 °C, 4 h, in the presence of 5 wt% of AHC. The co-HTT solids shown low slagging indices, fouling indices, alkali indices, and medium chlorine contents. These findings support the viability of WPVC conversion into clean solid fuel via co-HTT.

Spent coffee enhanced biomethane potential via an integrated hydrothermal carbonization-anaerobic digestion process.

This study reports the implications of using spent coffee hydrochar as substrate for anaerobic digestion (AD) processes. Three different spent coffee hydrochars produced at 180, 220 and 250 °C, 1 h residence time, were investigated for their biomethane potential in AD process inoculated with cow manure. Spent coffee hydrochars were characterized in terms of ultimate, proximate and higher heating value (HHV), and their theoretical bio-methane yield evaluated using Boyle-Buswell equation and compared to the experimental values. The results were then analyzed using the modified Gompertz equation to determine the main AD evolution parameters. Different hydrochar properties were related to AD process performances. AD of spent coffee hydrochars produced at 180 °C showed the highest biomethane production rate (46 mL CH4/gVS.d), a biomethane potential of 491 mL/gVS (AD lasting 25 days), and a biomethane gas daily composition of about 70%.