RESUMO
The long-lived xenon isomers 129mXe and 131mXe are of interest for the GAMMA-MRI project, which aims at developing a novel imaging modality based on magnetic resonance of polarized unstable tracers. Here, we present the steps leading to and following the production of these two isomers via neutron irradiation of highly-enriched 128Xe and 130Xe gas samples at two high-flux reactors, the High-Flux Reactor (Réacteur à haut flux, RHF) at the Institut Laue-Langevin (ILL) and the MARIA reactor at the National Centre for Nuclear Research (NCBJ). We describe the experimental setups and procedures used to prepare the stable xenon samples, to open the irradiated samples, and to transfer xenon isomers into reusable transport vials. The activity of 129mXe and 131mXe was measured to be in the range of tens of MBq per sample of 0.8(1)mg, and was proportional to thermal neutron flux density. A small activity of unstable contaminants was also visible in the samples, but their level is not limiting for the GAMMA-MRI project's objectives. In addition, the minimum thermal neutron flux density required to produce 129mXe and 131mXe sufficient for the project could be also determined.
RESUMO
The improvement in the performance of a conventional laser ion source in the laser ion source and trap (LIST) project is presented, which envisages installation of a repeller electrode and a linear Paul trap/ion guide structure. This approach promises highest isobaric purity and optimum temporal and spatial control of the radioactive ion beam produced at an online isotope separator facility. The functionality of the LIST was explored at the offline test separators of University of Mainz (UMz) and ISOLDE/CERN, using the UMz solid state laser system. Ionization efficiency and selectivity as well as time structure and transversal emittance of the produced ion beam was determined. Next step after complete characterization is the construction and installation of the radiation-hard final trap structure and its first online application.
