A compact evolved antenna for 5G communications.

Flexible and bendable electronics are gaining a lot of interest in these last years. In this scenario, compact antennas on flexible substrates represent a strategical technological step to pave the way to a new class of wearable systems. A crucial issue to overcome is represented by the poor radiation properties of compact antennas, especially in the case of flexible and thin substrates. In this paper, we propose an innovative design of a miniaturized evolved patch antenna whose radiation properties have been enhanced with a Split Ring Resonator (SRR) placed between the top and the ground plane. The antenna has been realized on a flexible and biocompatible substrate polyethylene naphthalate (PEN) of 250 µm by means of a new fabrication protocol that involves a three-layer 3D-inkjet printing and an alignment step. The antenna has been characterized in terms of the scattering parameter S11 and the radiation pattern showing a good agreement between simulations and measurements.

Air bio-contamination control in hospital environment by UV-C rays and HEPA filters in HVAC systems.

The contamination of air-handling units is a widespread phenomenon in buildings with air-conditioning systems, including hospitals. The germicide capacity of UV-C rays is known and, in the air-conditioning apparatuses, the UV-C lamps are generally located inside the air ducts. Aim of the paper is to evaluate the effectiveness of UV-C lamps when they are differently placed, i.e. in a position to directly irradiate the HEPA filters surface. We built ad hoc experimental air-conditioning systems, with HEPA filters and UV-C lamps in the two described positions. The results obtained demonstrate that, for disinfection purpose, the direct irradiation of the HEPA filters by UV-C provides better results than irradiation of the air stream and the effectiveness increases when lowering the relative humidity of the air. The survival curves of the tested microorganisms (fungi) show typical tail shaped curves (two steps survival curves). Additional tests using both HEPA filters alone, and HEPA filters plus UV lamps, have been performed measuring the air pressure drop between entrance and exit the HEPA filters and collecting air samples in order to obtain total microbial and fungal count. The results obtained suggest that, at least in experimental conditions described, the radiation on filter surface reduces significantly the microbial load and the pressure drop through the filter, compared to a situation of not-irradiated HEPA filters.

Amplitude and phase modulation in microwave ring resonators by doped CVD graphene.

In this paper, we numerically and experimentally demonstrate how to modulate the amplitude and phase of a microwave ring resonator by means of few-layers chemical vapour deposition graphene. In particular, both numerical and experimental results show a modulation of about 10 dB and a 90 degrees-shift (quadrature phase shift) when the graphene sheet-resistance is varied. These findings prove once again that graphene could be efficiently exploited for the dynamically tuning and modulation of microwave devices fostering the realization of (i) innovative beam-steering and beam-forming systems and (ii) graphene-based sensors.

Optically transparent microwave screens based on engineered graphene layers.

We propose an innovative approach for the realization of a microwave absorber fully transparent in the optical regime. This device is based on the Salisbury screen configuration, which consists of a lossless spacer, sandwiched between two graphene sheets whose sheet resistances are different and properly engineered. Experimental results show that it is possible to achieve near-perfect electromagnetic absorption in the microwave X-band. These findings are fully supported by an analytical approach based on an equivalent circuital model. Engineering and integration of graphene sheets could facilitate the realization of innovative microwave absorbers with additional electromagnetic and optical functionalities that could circumvent some of the major limitations of opaque microwave absorbers.

Graphene-based perfect optical absorbers harnessing guided mode resonances.

We investigate graphene-based optical absorbers that exploit guided mode resonances (GMRs) attaining theoretically perfect absorption over a bandwidth of few nanometers (over the visible and near-infrared ranges) with a 40-fold increase of the monolayer graphene absorption. We analyze the influence of the geometrical parameters on the absorption rate and the angular response for oblique incidence. Finally, we experimentally verify the theoretical predictions in a one-dimensional, dielectric grating by placing it near either a metallic or a dielectric mirror, thus achieving very good agreement between numerical predictions and experimental results.

Graphene-based absorber exploiting guided mode resonances in one-dimensional gratings.

A one-dimensional dielectric grating, based on a simple geometry, is proposed and investigated to enhance light absorption in a monolayer graphene exploiting guided mode resonances. Numerical findings reveal that the optimized configuration is able to absorb up to 60% of the impinging light at normal incidence for both TE and TM polarizations resulting in a theoretical enhancement factor of about 26 with respect to the monolayer graphene absorption (≈2.3%). Experimental results confirm this behavior showing CVD graphene absorbance peaks up to about 40% over narrow bands of a few nanometers. The simple and flexible design points to a way to realize innovative, scalable and easy-to-fabricate graphene-based optical absorbers.

Nonlinear control of absorption in one-dimensional photonic crystal with graphene-based defect.

Perfect, narrow-band absorption is achieved in an asymmetric 1D photonic crystal with a monolayer graphene defect. Thanks to the large third-order nonlinearity of graphene and field localization in the defect layer we demonstrate the possibility to achieve controllable, saturable absorption for the pump frequency.

Experimental study of a semi-passive ventilation grille with a feedback control system.

The diffusion of window frames with low air permeability, due to the energy saving regulations, has implied in several cases the worsening of the indoor microclimate and air quality. On the other hand, air-tight window frames imply uncontrolled and too high air change rates. The mechanical ventilation not always is a practicable solution because of economic reasons and because it implies energy waste. Various Italian and European environmental and energetic laws take into consideration and promote the use of controlled natural ventilation, though this definition is not associated to well defined and tested technical solutions. An adequate solution can be achieved by using semi-passive self adjustable ventilation devices, able to ensure controlled changes of indoor air. In this paper, a semi-passive damper with a feedback control system is proposed and its behavior is investigated by means of experimental study. The presented semi-passive grille allows to control the air flow rate, injected into the room by natural or artificial pressure gradient, more effectively than the usual passive ventilation grilles made available by the present industrial production. However, since the semi-passive grille has a one-way flow, in the natural ventilation of a flat the proper functioning of the system could be ensured with a more complex configuration, with respect to the passive self-regulating grilles, able to limit the flow of fresh air in the presence of high levels of Δp; conversely, it could have widespread use in applications requiring a more accurate control of airflow in case of mechanical ventilation plants.

Photoacoustic cell for ultrasound contrast agent characterization.

Photoacoustics has emerged as a tool for the study of liquid gel suspension behavior and has been recently employed in a number of new biomedical applications. In this paper, a photoacoustic sensor is presented which was designed and realized for analyzing photothermal signals from solutions filled with microbubbles, commonly used as ultrasound contrast agents in echographic imaging techniques. It is a closed cell device, where photothermal volume variation of an aqueous solution produces the periodic deflection of a thin membrane closing the cell at the end of a short pipe. The cell then acts as a Helmholtz resonator, where the displacement of the membrane is measured through a laser probe interferometer, whereas photoacoustic signal is generated by a laser chopped light beam impinging onto the solution through a glass window. Particularly, the microbubble shell has been modeled through an effective surface tension parameter, which has been then evaluated from experimental data through the shift of the resonance frequencies of the photoacoustic sensor. This shift of the resonance frequencies of the photoacoustic sensor caused by microbubble solutions is high enough for making such a cell a reliable tool for testing ultrasound contrast agent, particularly for bubble shell characterization.

Optical filter with very large stopband (approximately 300 nm) based on a photonic-crystal vertical-directional coupler.

We have designed, fabricated, and demonstrated a vertical directional coupler based on the coupling between a polymer waveguide and a W1 photonic crystal waveguide. The filters have a bandwidth of approximately 2 nm within a stopband of Delta lambda approximately 300 nm and an on-chip insertion loss of 1 dB. This is the first (to our knowledge) demonstration of a filter with such a large stopband that overcomes the bandwidth limitation of existing filters.

Incomplete division of labor: error-prone multitaskers coexist with specialists.

Division of labor (DoL) occurs when individual members of a group specialize by performing particular tasks toward some common goal. Under complete DoL, every individual acts as a specialist and so performs only one kind of task. But under incomplete DoL, some individuals may act as generalists and so have the capacity to perform more than one kind of task. This persistence of generalists in the presence of specialists presents a theoretical challenge, particularly if generalists must pay an extra cost, an inefficiency penalty, for their capacity to perform more than one type of task. Prior work focused on how such costs tend to drive evolution toward complete DoL, with only specialists typically remaining at equilibrium [Wahl, L.M., 2002a. Evolving the division of labor: generalists, specialists and task allocation. J. Theoret. Biol. 219, 371-388; Wahl, L.M., 2002b. The division of labor: genotypic versus phenotypic specialization. Am. Nat. 160, 135-145]. Relaxing this key assumption, we show that generalists, despite paying some extra costs, can coexist with specialists. Relaxing another assumption, we also show that this coexistence can hold even when generalists often perform the wrong task. How can stable multitasking emerge despite this flawed decision-making? From the perspective that cognitive errors matter only when they translate into fitness decrements, we observe that error-prone generalists may persist most commonly in situations in which their mistakes do little to jeopardize group success. Our findings show that incomplete DoL can emerge even when generalists often err and must pay extra costs for their multitasking capacity.

Mecanismos de continencia en reservorios ostómicos. Evaluación en modelo experimental / Continence mechanisms in stoma pouch. Evaluation in an experimental model

Objetivo: Comparar los diferentes mecanismos de continencia aplicables a reservorios ileales ostómicos en un modelo experimental.Materiales y Métodos: Se realizaron 24 reservorios completos y 40 minirreservorios ileales en un modelo experimental con intestino bovino, donde se confeccionaron distintos mecanismos de continencia ostómicos: afinamiento tubular, Witzel, Monti, enteroplicatura y Kock. La continencia fue evaluada mediante estudios urodinámicos y se definió incontinencia a la presión de pérdida menor de 50 cm de agua. Resultados: El afinamiento tubular requirió un tiempo promedio de confección de 18 minutos y la presión de pérdida fue de 0-2 cm de agua, resultando incontinente. El trayecto subseroso de Witzel, 26 minutos y la presión de pérdida fue de 4-6 cm de agua, resultando incontinente. Los mecanismos de Monti y enteroplicatura, 59 y 30 minutos respectivamente, y sin pérdida hasta una presión de 70-80 cm de agua, resultando continentes. Conclusión: Los resultados funcionales de los mecanismos de continencia fueron superiores en enteroplicatura y Monti, siendo la enteroplicatura de menor complejidad para su confección

Kawasaki's disease with paralytic ileus. A case report.

The authors report on an 18 month-old boy affected by Kawasaki's disease (KD). The diagnosis of KD was made after exclusion of conditions with similar presentation. Two days after admission the child presented vomiting, abdominal distension, meteorism and increase of scrotal swelling with edema. An abdominal X-ray showed the presence of multiple water and gas levels in the ileum and subsequent diagnosis of paralitic ileus was made. After several evacuative enema the intestinal symptomatology resolved. The patient was treated twice (2 g/kg day and after 3 days again 2 g/kg day) with intravenous immunoglobulin following which he made an uneventful recovery. The authors conclude that the presence of paralytic ileus in a febrile child may represent an unusual clinical sign of KD and justify a timely commencement of intravenous immuno-globulin therapy.

Polymorphisms of the interleukin-1beta gene affect the risk of myocardial infarction and ischemic stroke at young age and the response of mononuclear cells to stimulation in vitro.

OBJECTIVE: To investigate the role of interleukin-1beta (IL-1beta) gene polymorphisms as a link between inflammation, coagulation, and risk of ischemic vascular disease at young age. METHODS AND RESULTS: A total of 406 patients with myocardial infarction (MI) at young age, frequency-matched for age, sex, and recruitment center, with 419 healthy population-based controls and 134 patients with ischemic stroke at young age, matched by age and sex, with 134 healthy population-based controls, were studied. Subjects carrying the TT genotype of the -511C/T IL-1beta polymorphism showed a decreased risk of MI (odds ratio [OR], 0.36; 95% CI, 0.20 to 0.64) and stroke (OR, 0.32; 95% CI, 0.13 to 0.81) after adjustment for conventional risk factors. In both studies, the T allele showed a codominant effect (P=0.0020 in MI; P=0.021 in stroke). Mononuclear cells from volunteers carrying the T allele showed a decreased release of IL-1beta and a decreased expression of tissue factor after stimulation with lipopolysaccharide compared with CC homozygotes. The presence of a monoclonal antibody against IL-1beta during cell stimulation resulted in a marked reduction of tissue factor activity expression. CONCLUSIONS: -511C/T IL-1beta gene polymorphism affects the risk of MI and ischemic stroke at young age and the response of mononuclear cells to inflammatory stimulation.

Time domain analysis of optical amplification in Er3+ doped SiO2-TiO2 planar waveguide.

A time domain analysis of light amplification in an erbium doped silica-titania planar waveguide is reported. The investigation is performed by means of a home-made computer code which exploits the auxiliary differential equation scheme combined with the finite difference time domain technique to solve Maxwell's equations and the rate equations. The simulation model takes into account the pump and input signal propagation, the secondary transitions pertaining to the ion-ion interactions and exploits the optical, spectroscopic and geometrical parameters measured on the fabricated waveguide.

Refinement of Er3+-doped hole-assisted optical fiber amplifier.

This paper deals with design and refinement criteria of erbium doped hole-assisted optical fiber amplifiers for applications in the third band of fiber optical communication. The amplifier performance is simulated via a model which takes into account the ion population rate equations and the optical power propagation. The electromagnetic field profile of the propagating modes is carried out by a finite element method solver. The effects of the number of cladding air holes on the amplifier performance are investigated. To this aim, four different erbium doped hole-assisted lightguide fiber amplifiers having a different number of cladding air holes are designed and compared. The simulated optimal gain, optimal length, and optimal noise fig. are discussed. The numerical results highlight that, by increasing the number of air holes, the gain can be improved, thus obtaining a shorter amplifier length. For the erbium concentration NEr=1.8x1024 ions/m3, the optimal gain G(Lopt) increases up to ~2dB by increasing the number of the air holes from M=4 to M=10.

Photonic band gap filter for wavelength division multiplexer.

An optical multiplexer-demultiplexer based on an index-confined photonic band gap waveguide is proposed. The dropping of electromagnetic waves having a given frequency or a certain frequency band is obtained via a phase-shifted grating obtained by breaking the uniform period sequence to include a defect layer. The selective filtering properties of the proposed structure are simulated by means of a computer code relying on a bi-directional beam propagation method based on the method of lines.