Dynamic compressive properties of the mandibular condylar cartilage.

The mandibular condylar cartilage plays an important role as a stress absorber during function. However, relatively little information is available on its dynamic properties under compression. We hypothesized that these properties are region-specific and depend on loading frequency. To characterize the viscoelastic properties of the condylar cartilage, we performed dynamic indentation tests over a wide range of loading frequencies. Ten porcine mandibular condyles were used; the articular surface was divided into 4 regions, anteromedial, anterolateral, posteromedial, and posterolateral. The dynamic complex, storage, and loss moduli increased with frequency, and these values were the highest in the anteromedial region. Loss tangent decreased with frequency from 0.68 to 0.17, but a regional difference was not found. The present results suggest that the dynamic compressive modulus is region-specific and is dependent on the loading frequency, which might have important implications for the transmission of load in the temporomandibular joint.

The frictional coefficient of the temporomandibular joint and its dependency on the magnitude and duration of joint loading.

In synovial joints, friction between articular surfaces leads to shear stress within the cartilaginous tissue, which might result in tissue rupture and failure. Joint friction depends on synovial lubrication of the articular surfaces, which can be altered due to compressive loading. Therefore, we hypothesized that the frictional coefficient of the temporomandibular joint (TMJ) is affected by the magnitude and duration of loading. We tested this by measuring the frictional coefficient in 20 intact porcine TMJs using a pendulum-type friction tester. The mean frictional coefficient was 0.0145 (SD 0.0027) after a constant loading of 50 N during 5 sec. The frictional coefficient increased with the length of the preceding loading duration and exceeded 0.0220 (SD 0.0014) after 1 hr. Application of larger loading (80 N) resulted in significantly larger frictional coefficients. In conclusion, the frictional coefficient in the TMJ was proportional to the magnitude and duration of joint loading.