Development and validation of a quantitative snack and beverage food frequency questionnaire for adolescents.

BACKGROUND: A short, reliable and valid tool to measure snack and beverage consumption in adolescents, taking into account the correct definitions, would benefit both epidemiological and intervention research. The present study aimed to develop a short quantitative beverage and snack food frequency questionnaire (FFQ) and to assess the reliability and validity of this FFQ against three 24-h recalls. METHODS: Reliability was assessed by comparing estimates of the FFQ administered 14 days apart (FFQ1 and FFQ2) in a convenience sample of 179 adolescents [60.3% male; mean (SD) 14.7 (0.9) years]. Validity was assessed by comparing FFQ1 with three telephone-administered 24-h recalls in a convenience sample of 99 adolescents [52.5% male, mean (SD) 14.8 (0.9) years]. Reliability and validity were assessed using Bland-Altman plots, classification agreements and correlation coefficients for the amount and frequency of consumption of unhealthy snacks, healthy snacks, unhealthy beverages, healthy beverages, and for the healthy snack and beverage ratios. RESULTS: Small mean differences (FFQ1 versus FFQ2) were observed for reliability, ranking ability ranged from fair to substantial, and Spearman coefficients fell within normal ranges. For the validity, mean differences (FFQ1 versus recalls) were small for beverage intake but large for snack intake, except for the healthy snack ratio. Ranking ability ranged from slightly to moderate, and Spearman coefficients fell within normal ranges. CONCLUSIONS: Reliability and validity of the FFQ for all outcomes were found to be acceptable at a group level for epidemiological purposes, whereas for intervention purposes only the healthy snack and beverage ratios were found to be acceptable at a group level.

Factors influencing the reinforcing value of fruit and unhealthy snacks.

OBJECTIVE: The present study investigated the reinforcing value of healthy and unhealthy snack food in adolescents (n = 108, aged 14-16 years). Moderation by access to different foods, sex and the personality trait reward sensitivity is tested. METHODS: In a computerized Food Reinforcement Task, adolescents could earn portions of a healthy and an unhealthy snack following an identical progressive reinforcement schedule for both food types. Reinforcing value of food was indexed by the number of button presses for each food type. Participants were allocated randomly to two-order condition: fruit-snack versus snack-fruit. Reward sensitivity was assessed with the Dutch age-downward version of Carver and White's BIS/BAS scale. RESULTS: Results showed that the reinforcing value of an unhealthy snack is higher than that of fruit, with participants making more button presses for unhealthy snacks, M = 1280.40, SD = 1203.53, than for fruit, M = 488.04, SD = 401.45, F(1,48) = 25.37, p < 0.001. This effect is stronger in boys (ß = -1367.67) than in girls (ß = -548.61). The effect is only present in the snack-fruit condition, not in the fruit-snack condition, indicating that access to food moderates the effect of food type. There is no evidence for moderation by reward sensitivity. CONCLUSIONS: Results point to the importance of simultaneously increasing barriers to obtain unhealthy food and promoting access to healthy food in order to facilitate healthy food choices.

Using a gamified monitoring app to change adolescents' snack intake: the development of the REWARD app and evaluation design.

BACKGROUND: As the snacking pattern of European adolescents is of great concern, effective interventions are necessary. Till now health promotion efforts in children and adolescents have had only limited success in changing adolescents' eating patterns and anthropometrics. Therefore, the present study proposes an innovative approach to influence dietary behaviors in youth based on new insights on effective behavior change strategies and attractive intervention channels to engage adolescents. This article describes the rationale, the development, and evaluation design of the 'Snack Track School' app. The aim of the app is to improve the snacking patterns of Flemish 14- to 16-year olds. METHODS: The development of the app was informed by the systematic, stepwise, iterative, and collaborative principles of the Intervention Mapping protocol. A four week mHealth intervention was developed based on the dual-system model with behavioral change strategies targeting both the reflective (i.e., active learning, advance organizers, mere exposure, goal-setting, monitoring, and feedback) and automatic processes (i.e., rewards and positive reinforcement). This intervention will be evaluated via a controlled pre-post design in Flemish schools among 1400 adolescents. DISCUSSION: When this intervention including strategies focused on both the reflective and automatic pathway proves to be effective, it will offer a new scientifically-based vision, guidelines and practical tools for public health and health promotion (i.e., incorporation of learning theories in intervention programs). TRIAL REGISTRATION: NCT02622165 registrated November 15, 2015 on clinicaltrials.gov.

DROPLET SIZE DISTRIBUTION MEASUREMENTS OF ISO NOZZLES BY SHADOWGRAPHY METHOD.

The droplet size distribution of agricultural sprays is a key parameter during the plant protection product applications. Therefore, measurement of the drop size distribution is an important concern for spray users as well as nozzle manufacturers. The present work assessed the capability of a shadowgraphy technique to distinguish correctly the 6 spray class boundaries defined in the ISO draft standard (ISO 25358). The measurement set-up is composed by a high speed camera synchronized with a LED backlighting. The tested spray is positioned between the camera and the light. The droplets appear on the images as shadows on a brighter background. For each acquisition, two frames are recorded within a small time laps (38 µI. The droplet diameter and velocity are retrieved by using advanced image analysis algorithm on each pair of frames. Then, the drop size distribution is obtained by gathering the data retrieved from all the images. The global results showed that the 6 drop size distributions were correctly separated highlighting the ability of the method to measure small as well as large droplets using the same set-up configuration. The spatial analysis showed that the spray scanning should be extended in the minor axis direction in order to catch the whole spray.

DRIFT POTENTIAL OF TILTED SHIELDED ROTARY ATOMISERS BASED ON WIND TUNNEL MEASUREMENTS.

Crop protection is mainly achieved by applying Plant Protection Products (PPP) using hydraulic nozzles, which rely on pressure, to produce a wide droplet size distribution. Because of always increased concerns about drift reduction, a wider range of low drift nozzles, such as air induction nozzles, was adopted in order to reduce the finest part of the spray. While successful for some treatments, the efficiency of coarser sprays is dramatically reduced on small and superhydrophobic target, i.e. at early stage weed control. This may be related to the increased proportion of big bouncing and splashing droplets. On the other hand, Controlled Droplet Application (CDA), using shielded rotary atomizers, stands for an improved control of droplets diameters and trajectories compared to hydraulic nozzles. Unfortunately, these atomizers, because of their horizontal droplet release, are widely recognized to produce more drift than hydraulic nozzles. The present contribution investigates whether the setting of a rotary atomizer 60 degrees forward tilted can reduce drift to acceptable levels in comparison with vertical and 60 degrees forward tilted standard and low drift flat fan nozzles for the same flow rate. In a wind tunnel, the drift potential of a medium spray produced by a tilted shielded rotary atomizer Micromax 120 was benchmarked with that of a flat fan nozzle XR11002 fine spray and that of an anti-drift nozzle Hardi Injet 015 medium spray. Operating parameters were set to apply 0.56 l/min for every spray generator. Vertical drift profiles were measured 2.0 m downward from nozzle axis for a 2 m.s(-1) wind speed. The tilted hydraulic nozzles resulted in a significant drift increase while droplets trajectories are affected by the decrease of the droplet initial vertical speed. Droplets emitted by the shielded rotary atomizer drift due to low entrained air and turbulence. A significant reduction of the cumulative drift was achieved by the rotary atomizer in comparison with flat fan nozzle while still being higher than the anti-drift nozzle. Unfortunately, the drift potential index (DIX) revealed that the cumulative drift reduction may not results in actual drift decrease because of higher drift at higher sampling locations. As a result, the DIX of the shielded rotary atomizer was similar to the standard flat-fan nozzle while the anti-drift nozzle reduced drastically drift as intended. Therefore, the 60 degrees tilted rotary atomizer failed to reach low drift levels as expected despite the reduced span.

COMPUTER SIMULATIONS OF SPRAY RETENTION BY A 3D BARLEY PLANT: EFFECT OF FORMULATION SURFACE TENSION.

A spray retention model was used in this study to explore theoretically the effect of a range of mixture surface tension on the spray retention and the variability of deposits. The spray retention model was based on an algorithm that tested whether droplets from a virtual nozzle intercepted a 3D plant model. If so, the algorithm determined the contribution of the droplet to the overall retention depending on the droplet impact behaviour on the leaf; adhesion, rebound or splashing. The impact outcome probabilities, function of droplet impact energy, were measured using high-speed imaging on an excised indoor grown barley leaf (BBCH12) both for pure water (surface tension of 0.072 N/m) and a non-ionic super spreader (static surface tension of 0.021 N/m) depending on the surface orientation. The modification of spray mixture properties in the simulations was performed by gradually changing the spray the droplet impact probabilities between pure water and a solution with non-ionic surfactant exhibiting super spreading properties. The plant architecture was measured using a structured light scanner. The final retention was expressed as the volume of liquid retained by the whole plant relative to the projected leaf surface area in the main spray direction. One hundred simulations were performed at different volumes per hectare and flat-fan nozzles for each formulation surface tension. The coefficient of variation was used as indicator of variability of deposits. The model was able to discriminate between mixture surface tension. The spray retention increased as the mixture surface tension decreased. The variability of deposits also decreased as the surface tension decreased. The proposed modelling approach provides a suited tool for sensitivity analysis: nozzle kind, pressure, volume per hectare applied, spray mixture physicochemical properties, plant species, growth stage could be screened to determine the best spraying characteristics maximizing the retention. The model will be further extended with the real droplet trajectories in moving airstreams.

Myocardial oxygen demands of job activities in post-myocardial infarct patients.

In 17 patients who returned to work following rehabilitation after an uncomplicated acute myocardial infarction (AMI), the myocardial oxygen demands (MOD) of various job activities were assessed using discontinuous ambulatory heart rate (HR) and blood pressure measurements. All patients were on beta-blocking agents. HR and rate-pressure product (RPP) reserves were calculated as the differences between maximal values observed during a symptom-limited maximal bicycle exercise test and basal values. Basal values were either pre-test resting values or mean values from night-time registrations between 0100h and 0500h. Night-time values of basal HR and RPP were 7.7 and 18.7% lower respectively as compared to pre-test resting values. The myocardial energy demands of various job activities were calculated as the percentage use of the reserves. This resulted in lower MOD estimations when pre-test values were used as compared to night-time values. These differences were larger for the estimation of MOD of light physical work (mean difference 25%) than for heavy physical work (mean difference 12%). The estimations of MOD using HR reserve or RPP reserve were very similar. In patients who performed the same job activities no correlation was found between MOD and left ventricle ejection fraction. We believe these data provide useful information about the functional capacity of AMI patients. They also emphasise the great importance that has to be attached to the definition of basal values.

Influence of vegetation on acoustic properties of soils.

Possible influences of vegetation on acoustically relevant soil parameters, such as porosity and soil structure, were considered. In situ measurements of sound interference patterns were performed in seven plant communities by means of an inclined track method. Normal acoustical specific impedances were calculated with a plane wave outdoor sound propagation model. The impedances found generally showed a real part constant with frequency, and an imaginary part decreasing with frequency. It is concluded that forest floors have an acoustically detectable layer structure and that, for purposes of modelling of outdoor sound fields, much lower impedances have to be used than for institutional grass.