Your browser doesn't support javascript.
loading
Mostrar: 20 | 50 | 100
Resultados 1 - 2 de 2
Filtrar
Mais filtros










Base de dados
Intervalo de ano de publicação
1.
Int J Pharm ; 252(1-2): 207-12, 2003 Feb 18.
Artigo em Inglês | MEDLINE | ID: mdl-12550796

RESUMO

Due to the fact that some proteins have a tendency to bind to glass surfaces, plastic CZ-resin vials were evaluated as an alternative material to glass vials for packaging protein-based parenteral formulations. Physico-chemical tests including protein binding, extractable evaluation, oxygen permeation, light transmission and moisture loss were performed. Data show that two proteins (A and B) were found to bind to USP type I glass but not to CZ-resin. The CZ-resin vials passed all USP test specifications for extractables (organic extractable, non-volatile residue and residue on ignition). The oxygen permeation rate (79.06 cm(3)mm/m(2)24 h atm) was consistent with that reported by the vendor (67 cm(3)mm/m(2)24 h atm). The value obtained for light transmission, which was also found to be consistent with that reported by the vendor, shows that these vials offer no protection from light. The average moisture loss from 2 cm(3) vials filled with water was gravimetrically determined to be 0.04 mg/day/vial when the vials were stored at 40 degrees C/75% relative humidity (RH). Assuming a 1cm(3) product fill, this corresponds to approximately a 3% loss over a 2-year period. However, moisture loss was found to be negligible at the typical storage condition of 5 degrees C for protein formulations. The physico-chemical tests indicate that CZ-resin vial is a suitable candidate for packaging parenteral formulations since it shows low moisture loss at typical storage condition of 5 degrees C, and does not leach out extractables. However, it should not be used for light-sensitive and oxygen-sensitive parenteral formulations. For proteins A and B, the CZ-resin vial is a viable alternate to the use of glass vials since it offered significantly less protein binding. Protein binding in general, should be evaluated on a case by case basis, since it may vary for different proteins and under different formulation conditions.


Assuntos
Embalagem de Medicamentos/instrumentação , Proteínas/análise , Resinas Sintéticas/análise , Química Farmacêutica , Avaliação Pré-Clínica de Medicamentos/métodos , Embalagem de Medicamentos/métodos , Infusões Parenterais , Proteínas/metabolismo , Resinas Sintéticas/metabolismo
2.
Pharm Res ; 6(1): 85-90, 1989 Jan.
Artigo em Inglês | MEDLINE | ID: mdl-2717524

RESUMO

An in vitro study was carried out to elucidate the mechanisms controlling iontophoretic transport. The investigation focused on three areas, including the nature of the permeant (state of ionization and hydrophobicity), skin structures (hair follicle distribution and stratum corneum), and various parameters influencing iontophoresis (current, permeant concentration, and competitive ion effects). The data indicate that iontophoretic-facilitated transport is essentially pore mediated and that the transport of ionized and nonionized molecules may be enhanced through the pore-type pathway. The data presented show that iontophoresis has a detrimental effect on the lipoidal transport pathway and that the transport of more hydrophobic nonionized molecules is decreased compared with passive diffusion. The iontophoretic enhancement values decreased linearly with increasing alkyl chain length of n-alkanols. The iontophoretic permeability coefficients of ionized n-alkanoic acids was shown to decrease with increasing permeant hydrophobicity.


Assuntos
Álcoois/farmacocinética , Butiratos/farmacocinética , Cabelo/fisiologia , Íons/farmacocinética , Pele/metabolismo , Administração Cutânea , Animais , Transporte Biológico , Ácido Butírico , Estimulação Elétrica , Ratos , Ratos Nus , Pele/efeitos dos fármacos
SELEÇÃO DE REFERÊNCIAS
DETALHE DA PESQUISA
...