RESUMO
In this work, we report the design and the preparation of two new dyes and a molecular dyad for the photoelectrochemical hydrogen production from water in a dye-sensitized photoelectrochemical cell (DSPEC). We designed dyes that include a benzothiadiazole (BTD) and an indacenodithiophene (IDT) units, and we obtained a new molecular dyad by covalent coupling with the cobalt diimine-dioxime catalyst. The introduction of the benzothiadiazole core in the structure improves the absorption properties and leads to an extension of the spectrum in the visible range up to 650 nm. The photoelectrochemical properties of the new dyad were evaluated on pristine and lithium-doped NiO electrodes. We demonstrate that increasing the light harvesting efficiency of the dyad by introducing a IDT-BTD chromophore is clearly beneficial for the photoelectrochemical activity. We also demonstrate that lithium doping of NiO, which improves the electronic conductivity of the mesoporous film, leads to a significant increase in performance, in terms of TON and F.E., more than doubled with our new dyad. This BTD-based molecular system outperforms the results of previously reported dyads using the same catalyst.
RESUMO
We describe the development of a novel setup, in which large stencils with suspended silicon nitride membranes are combined with atomic force microscopy (AFM) regulation by using tuning forks. This system offers the possibility to perform separate AFM and nanostencil operations, as well as combined modes when using stencil chips with integrated tips. The flexibility and performances are demonstrated through a series of examples, including wide AFM scans in closed loop mode, probe positioning repeatability of a few tens of nanometer, simultaneous evaporation of large (several hundred of micron square) and nanoscopic metals and fullerene patterns in static, multistep, and dynamic modes. This approach paves the way for further developments, as it fully combines the advantages of conventional stenciling with the ones of an AFM driven shadow mask.
RESUMO
We describe in detail how atomic force microscopy (AFM) images can be routinely achieved with macroscopic silicon-based chips integrating mesoscopic tips, paving the way for the development of new near field devices combining AFM imaging with any kind of functionality integrated on a chip. The chips have been glued at the end of the free prong of 100 kHz quartz tuning forks mounted in Qplus configuration. Numerical simulations by modal analysis have been carried out to clarify the nature of the vibration modes observed in the experimental spectra. It is shown that two low frequency modes can be used to drive the system and scan the surface with a great stability in amplitude modulation as well as in frequency modulation AFM under ultrahigh vacuum. The AFM capabilities are demonstrated through a series of examples including phase and dissipation contrast imaging, force spectroscopy measurements, and investigations of soft samples in weak interaction with the substrate. The lateral resolution with the tips grown by focused ion beam deposition already matches the one achieved in standard amplitude modulation mode AFM experiments.
RESUMO
Combined CV studies and UV-Vis-NIR spectroelectrochemical investigations revealed an unusual stability of the p- and n-doped PMOThOD in the wide potential window of 4 V. The n-doping process occurs in this polymer down to -2.7 V (vs. Ag/Ag+) in a non-destructive way with the characteristic development of the omega3 transition as a function of the doping level. In situ electronic transport studies revealed a high conductivity of the n-doped polymer which implies high mobility of the negatively charged carriers in the freshly doped PMOThOD film electrodes. An increase in the cathodic polarization, long-term cycling of the film electrodes, especially of higher thickness, results in a growing contribution of the negatively charged carriers trapping to the redox properties of the PMOThOD. The trapping of the charged carriers reduces gradually the electronic conductance of the PMOThOD film, but its effect on the redox-capacity of the film (in a typical scan rates range up to 50 mV s(-1)) is only minor.