Typical values of z-resolution for different Digital Breast Tomosynthesis systems evaluated in a multicenter study.

PURPOSE: The aim of the present study, conducted by a working group of the Italian Association of Medical Physics (AIFM), was to define typical z-resolution values for different digital breast tomosynthesis (DBT) models to be used as a reference for quality control (QC). Currently, there are no typical values published in internationally agreed QC protocols. METHODS: To characterize the z-resolution of the DBT models, the full width at half maximum (FWHM) of the artifact spread function (ASF), a technical parameter that quantifies the signal intensity of a detail along reconstructed planes, was analyzed. Five different commercial phantoms, CIRS Model 011, CIRS Model 015, Modular DBT phantom, Pixmam 3-D, and Tomophan, were evaluated on reconstructed DBT images and 82 DBT systems (6 vendors, 9 models) in use at 39 centers in Italy were involved. RESULTS: The ASF was found to be dependent on the detail size, the DBT angular acquisition range, the reconstruction algorithm and applied image processing. In particular, a progressively greater signal spread was observed as the detail size increased and the acquisition angle decreased. However, a clear correlation between signal spread and angular range width was not observed due to the different signal reconstruction and image processing strategies implemented in the algorithms developed by the vendors studied. CONCLUSIONS: The analysis led to the identification of typical z-resolution values for different DBT model-phantom configurations that could be used as a reference during a QC program.

Optimisation of radiological protocols for chest imaging using computed radiography and flat-panel X-ray detectors.

PURPOSE: Digital radiography technology has replaced conventional screen-film systems in many hospitals. Despite the different characteristics of new detector materials, frequently, the same radiological protocols previously optimised for screen film are still used with digital equipment without any critical review. This study addressed optimisation of exposure settings for chest examinations with digital systems, considering both image quality and patient dose. MATERIALS AND METHODS: Images acquired with direct digital radiography equipment and a computed radiography system were analysed with specially developed commercial software with a four-alternative forced-choice method: the most promising protocols were then scored by two senior radiologists. RESULTS: Digital technology offers a wide dynamic range and the ability to postprocess images, allowing use of lower tube potentials in chest examinations. The computed radiography system showed both better image quality and lower dose at lower energies (85 kVp and 95 kVp) than those currently used (125 kVp). Direct digital radiography equipment confirmed both its superior image quality and lower dose requirements compared with the storage phosphor plate system. CONCLUSIONS: Generally, lowering tube potentials in chest examinations seems to allow better image quality/effective dose ratio when using digital equipment.

Radiographic evaluation of mediastinal lines as a diagnostic approach to occult or subtle mediastinal abnormalities.

The mediastinal lines visible at conventional radiography represent the interfaces between the mediastinum and adjacent lung parenchyma. Preservation, obliteration, thickening and distortion of these lines represent the key to detecting and localising mediastinal abnormalities on chest radiographs. The learning objectives of this review are to: illustrate radiographic anatomy of the mediastinum with particular attention to mediastinal lines; describe radiographic signs that allow identification of mediastinal abnormalities that are difficult to detect on conventional chest radiographs; describe findings that help localise abnormalities in the anterior, middle or posterior mediastinum. The anterior junction line obliteration, the hilum overlay sign, the preservation of the posterior mediastinal lines and the silhouette sign with the right cardiac border are radiographic signs that allow identification and localisation of anterior mediastinal lesions. Widening of the right paratracheal stripe, distortion of the azygo-oesophageal recess and the convex border of the aortopulmonary window indicate the presence of a middle mediastinal abnormality. Thickening, distortion or disruption of paraortic and paraspinal lines and posterior junction line obliteration are caused by posterior mediastinal lesions. Knowledge of normal radiographic mediastinal anatomy and mediastinal lines is crucial to identifying subtle mediastinal abnormalities that can be easily missed on conventional radiography. Moreover, this approach allows identification of the involved mediastinal compartment on chest radiographs, thereby directing the most appropriate further diagnostic workup.