Continuous Feeding and Blending Demonstration with Co-Processed Drug Substance.

Continuous direct compression (CDC) of solid oral dosage forms requires materials exhibiting acceptable flow and compression properties. The desired active pharmaceutical ingredient (API) powder properties can be difficult to achieve through conventional particle engineering approaches, such as particle size and habit modification during crystallization. Co-processing of API with excipients can significantly improve the powder properties to overcome these difficulties. In this manuscript, performance of a co-processed API was evaluated in a continuous feeding and blending process using GEA ConsiGma® Continuous Dosing and Blending Unit (CDB1). The co-processed theophylline was generated via a methodology in which polymer was precipitated and coated the crystalline theophylline particles resulting in nearly spherical agglomerates. A range of drug loads (1-25% w/w), flow rates (15-40 kg/h) and blender speeds (220-400 rpm) were studied. The results demonstrated that the co-processed API can be successfully fed through a loss-in-weight feeder and blended with other excipients in a high shear blender to generate tablets with acceptable content uniformity at 1-25% w/w drug loads. This study supports that using co-processed API with enhanced powder properties is a promising approach to enable continuous manufacturing for APIs with challenging properties.

Characterization of NIR interfaces for the feeding and in-line monitoring of a continuous granulation process.

This work describes the characterization of three NIR interfaces intended to monitor a continuous granulation process. Two interfaces (i.e. a barrel interface and a rotating paddle interface) were evaluated to monitor the API concentration at the entrance of the granulator, and a third interface (i.e. an outlet interface), was evaluated to examine the quality of the resulting outlet granules. The barrel interface provided an assessment of the API concentration during the feeding process by scanning the material conveyed by the screws of the loss-in-weight feeder. The rotating paddle interface analyzed discrete amounts of powder upon exiting the feeder via the accumulation of material on the paddles. Partial Least Squares (PLS) calibration models were developed using the same powder blends for the two inlet interfaces and using the outlet granules for the outlet interface. Five independent batches were used to evaluate the prediction performance of each inlet calibration model. The outlet interface produced the lowest error of prediction due to the homogeneity of the granules. The barrel interface produced lower errors of prediction than the rotating paddle interface. However, powder density affected only the barrel interface, producing deviations in the predicted values. Therefore, powder density is a factor that should be considered in the calibration sample design for spectroscopic measurements when using this type of interface. A variographic analysis demonstrated that the continuous 1-dimensional motion in the barrel and outlet interfaces produced representative measurements of each batch during calibration and test experiments, generating a low minimum practical error (MPE).