Lateral Force Microscopy of Interfacial Nanobubbles: Friction Reduction and Novel Frictional Behavior.

Atomic force microscopy is used to conduct single-asperity friction measurements at a water-graphite interface. Local mapping of the frictional force, which is based on the degree of the cantilever twisting, shows nearly friction-free when a tip scans over a nanobubble. Surprisingly, apart from being gapless, the associated friction loop exhibits a tilt in the cantilever twisting versus the tip's lateral displacement with the slope depending on the loading force. The sign of the slope reverses at around zero loading force. In addition, the measured normal and lateral tip-sample interactions exhibit unison versus tip-sample separation. Theoretical analysis, based on the balance of forces on the tip originated from the capillary force of the nanobubble and the torsion of the cantilever, offers quantitative explanations for both the tilted friction loop and the unison of force curves. The analysis may well apply in a wider context to the lateral force characterization on cap-shaped fluid structures such as liquid droplets on a solid substrate. This study further points to a new direction for friction reduction between solids in a liquid medium.

High-sensitivity imaging with lateral resonance mode atomic force microscopy.

In the operation of a dynamic mode atomic force microscope, a micro-fabricated rectangular cantilever is typically oscillated at or near its mechanical resonance frequency. Lateral bending resonances of cantilevers are rarely used because the resonances are not expected to be detected by the beam-deflection method. In this work, we found that micro-cantilevers with a large tip produced an out-of-plane displacement in lateral resonance (LR), which could be detected with the beam-deflection method. Finite-element analysis indicated that the presence of a large tip is the major source of the out-of-plane coupling for the LR. We also imaged a heterogeneous sample by operating a cantilever in LR, torsional resonance, and tapping modes. LR mode yielded a small deformation and noise level in the height maps as well as a high contrast and small noise level in the phase maps. LR mode also had a resonance frequency that was orders of magnitude higher than that of tapping mode. Operation with LR mode may have the benefits of high-speed scanning, high-sensitivity imaging, and mapping of in-plane mechanical properties of the sample surface. In general, LR mode may become a powerful new atomic force microscopy technique for characterizing sample materials.

Torsional resonance mode atomic force microscopy in liquid with Lorentz force actuation.

In this work, we present a design based on Lorentz force induction to excite pure torsional resonances of different types of cantilevers in air as well as in water. To demonstrate the atomic force microscopy imaging capability, the phase-modulation torsional resonance mode is employed to resolve fine features of purple membranes in a buffer solution. Most importantly, force-versus-distance curves using a relatively stiff cantilever can clearly detect the characteristic oscillatory profiles of hydration layers at a water-mica interface, indicating the high force sensitivity of the torsional mode. The high resonance frequencies and high quality-factors for the torsional mode may be of great potential for high-speed and high-sensitivity imaging in aqueous environment.

Motility measurement of a mouse sperm by atomic force microscopy.

Eukaryotic flagella are responsible for the motile organelles that cause the migration of mammalian sperms. The lashing force and torque of the sperm flagellum contain critical information regarding the sperm health, as important evaluation factors for sperm screening. The objective of the study was to investigate the lashing force and torque of a sperm under physiological conditions using atomic force microscopy (AFM). At a distance of about 18.5 µm from its head-tail junction, a lashing force of 0.96 ± 0.20 nN was measured. Its corresponding lashing torque was 1.77(± 0.37)× 10(-14) N·m. The torque increases in proportion to the square of the head-tail junction distance. Our results reasonably conclude that the axonemal motility is linear dependent on the flagellum length of the sperm. Our developed measurement system can consistently determine the lashing force and torque of a sperm, which can contribute to further studies concerning the mechanism of sperm transport and fertilization.