Microplastic accumulation in bivalves collected from different coastal areas of Vietnam and an assessment of potential risks.

Microplastic (MP) pollution is an emerging problem in many areas around the world and in coastal areas of Vietnam, requiring more studies dedicated to the accumulation of this pollutant in the food chain as well as its potential risk to human health. This study investigated MP levels in tissues of five common bivalve species collected from aquaculture areas along the coast of Vietnam. MPs were found in all bivalve samples, with average values of 10.84 ± 2.61 items/individual or 2.40 ± 1.34 items/g wet weight. Impacts of feeding habits of bivalves showed influences on MP abundance in the samples. Fibers were the dominant shape of MPs recorded, most of which accumulated in the gills and digestive glands of all bivalve samples, with the majority falling within the size range of 300-2000 µm. MPs found in all studied species had relatively similar chemical compositions, mainly composed of polypropylene (PP) and polyethylene (PE). In this study, a diverse diet consisting of different bivalve species and detailed data on the consumption rate of these species were used to assess the human health risk of MPs dedicated to the coastal communities of Vietnam. The results suggested a significant part of MP uptake by human could be via bivalve consumption, in which removing viscera and proper depuration should be applied prior to eating, thereby reducing the risk.

Microplastics in sediments from urban and suburban rivers: Influence of sediment properties.

Although sediments are considered to be a major sink for microplastics (MP), there is still a relative lack of knowledge on the factors that influence the occurrence and abundance of MP in riverine sediments. The present study investigated the occurrence and distribution of MP in riverine sediments collected at twelve sites representative of different populated and urbanized rivers (To Lich, Nhue and Day Rivers) located in the Red River Delta (RRD, Vietnam, during dry and rainy seasons. MP concentrations ranged from 1600 items kg-1 dw to 94,300 items kg-1dw. Fiber shape dominated and MP were made of polypropylene (PP) and polyethylene (PE) predominantly. An absence of seasonal effect was observed for both fragments and fibers for each rivers. Decreasing MP concentrations trend was evidenced from the To Lich River, to the Nhue River and to the Day River, coupled with a decreasing fiber length and an increasing fragment area in the surface sediment from upstream to downstream. Content of organic matter was correlated to MP concentrations suggesting that, high levels of organic matter could be MP hotspots in urban rivers. Also, high population density as well as in highly residential areas are related to higher MP concentrations in sediments. Finally, a MP high ecological risk (RI: 866 to 4711) was calculated in the RDD.

Roles, mechanism of action, and potential applications of sulfur-oxidizing bacteria for environmental bioremediation.

Sulfur (S) is a crucial component in the environment and living organisms. This work is the first attempt to provide an overview and critical discussion on the roles, mechanisms, and environmental applications of sulfur-oxidizing bacteria (SOB). The findings reveal that key enzymes of SOB embarked on oxidation of sulfide, sulfite, thiosulfate, and elemental S. Conversion of reduced S compounds was oxidatively catalyzed by various enzymes (e.g. sulfide: quinone oxidoreductase, flavocytochrome c-sulfide dehydrogenase, dissimilatory sulfite reductase, heterodisulfide reductase-like proteins). Environmental applications of SOB discussed include detoxifying hydrogen sulfide, soil bioremediation, and wastewater treatment. SOB producing S0 engaged in biological S soil amendments (e.g. saline-alkali soil remediation, the oxidation of sulfide-bearing minerals). Biotreatment of H2S using SOB occurred under both aerobic and anaerobic conditions. Sulfide, nitrate, and sulfamethoxazole were removed through SOB suspension cultures and S0-based carriers. Finally, this work presented future perspectives on SOB development, including S0 recovery, SOB enrichment, field measurement and identification of sulfur compounds, and the development of mathematical simulation.

Selection of a density separation solution to study microplastics in tropical riverine sediment.

Microplastics (MPs) are small (< 5 mm) plastic particles that are widely found in marine, freshwater, terrestrial and atmospheric environments. Due to their prevalence and persistence, MPs are considered an emerging contaminant of environmental concern. The separation and quantitation of MPs from freshwater sediments is a challenging and critical issue. It is necessary to identify the fate and sources of MPs in the environment, minimise their release and adverse effects. Compared to marine sediments, standardised methods for extracting and estimating the amount of MPs in freshwater sediments are relatively limited. The present study focuses on MP recovery efficiency of four commonly used salt solutions (NaCl, NaI, CaCl2 and ZnCl2) for isolating MPs during the density separation step from freshwater sediment. Known combinations of artificial MP particles (PS, PE, PVC, PET, PP and HDPE) were spiked into standard river sediment. Extraction using NaI, ZnCl2 and NaCl solutions resulted in higher recovery rates from 37 to 97% compared to the CaCl2 solution (28-83%) and varied between polymer types. Low-density MPs (PE, HDPE, PP and PS) were more effectively recovered (> 87%) than the denser polymers (PET and PVC: 37 to 88.8%) using NaCl, NaI and ZnCl2 solutions. However, the effective flotation of ZnCl2 and NaI solutions is relatively expensive and unsafe to the environment, especially in the context of developing countries. Therefore, considering the efficiency, cost and environmental criteria, NaCl solution was selected. The protocol was then tested by extracting MPs from nine riverine sediment samples from the Red River Delta. Sediments collected from urban rivers were highly polluted by MPs (26,000 MPs items·kg-1 DW) compared to sediments located downstream. Using a NaCl solution was found to be effective in this case study and might also be used in long-term and large-scale MP monitoring programmes in Vietnam.

Microplastics in Asian freshwater ecosystems: Current knowledge and perspectives.

Plastic pollution in freshwater ecosystems, including microplastics (MPs) smaller than 5 mm, has become an emerging global concern. Asia is considered a "hot spot" for plastic pollution due to rapid economic and demographic growth, together with rapid urbanization. Here, we provide an overview of the current knowledge on MP abundance, sources, fate, and transfer in Asian freshwater ecosystems based on publications from January 2014 to May 2021. MP contamination in freshwater compartments, including water, sediment, and biota, was found to vary strongly. In water, it ranged from 0.004 items m-3 in a moderately urbanized region to more than 500,000 items m-3 in a dumping river in a highly populated watershed. In the sediment, MP abundance ranged from 1 to more than 30,000 items kg-1 dry weight. Polyethylene (PE) and polypropylene (PP) were predominant in both water and sediment compartments. MP was detected in biota samples from all the studied species, but their abundance depended on the locations and species studied. Overall, MP characteristics (form, size, color, and polymer type) depended on sources and natural constraints (mainly hydrodynamics). This study also revealed that MP in Asian freshwater ecosystems mainly originated from domestic wastewater/runoff, followed by industrial emissions, fisheries and aquaculture wastewater. Plastic waste is not efficiently recycled or incinerated in Asia, leading to MP transfer and accumulation in the aquatic environment, and, more importantly, to ingestion by low to high trophic level organisms. This work highlights several knowledge gaps to guides future research to improve MP pollution management for the sustainable development of highly populated regions such as Asia.

Auxin production of the filamentous cyanobacterial Planktothricoides strain isolated from a polluted river in Vietnam.

Cyanobacteria are photosynthetic microorganisms with widespread diversity and extensive global distribution. They produce a wide variety of bioactive substances (e.g., lipopeptides, fatty acids, toxins, carotenoids, vitamins and plant growth regulators) that are released into culture media. In this study, the capability of a cyanobacterial strain of Planktothricoides raciborskii to produce intra- and extracellular auxins was investigated. The filamentous cyanobacterial P. raciborskii strain was isolated from a river in Vietnam, and it was cultivated in the laboratory under the optimum conditions of the BG11 culture medium and a pH of 7.0. The auxins were identified and quantified by the Salkowski colorimetric method and high-performance liquid chromatography coupled with mass spectrometry (HPLC-MS). Colorimetric analysis revealed that P. raciborskii produces extracellular indole-3-acetic acid (IAA) in the absence and presence of l-tryptophan. The maximum extracellular IAA concentration of the culture reached 118 ± 2 µg mL-1, which was supplemented with 900 µg mL-1 of l-tryptophan. HPLC-MS analysis revealed that the isolated cyanobacteria accumulate other plant-growth-promoting hormones besides IAA, such as indole-3-carboxylic acid (ICA), indole-3 butyric acid (IBA) and indole propionic acid (IPA). This is the first report on the production of auxins in an isolated strain of cyanobacteria Planktothricoides from a polluted river. The capability of producing auxins makes the P. raciborskii strain an appropriate candidate for the formulation of a biofertilizer.