Imaging and Timing Performance of 1cm × 1cm Position-sensitive Solid-state Photomultiplier.

We have designed and built a large-area 1cm × 1cm position-sensitive solid-state photomultiplier (PS-SSPM) for use in detector design for medical imaging applications. Our new large-area PS-SSPM concept implements resistive network between the micro-pixels, which are photodiodes operated in Geiger mode, called Geiger Photodiodes (GPDs), to provide continuous position sensitivity. Here we present imaging and timing performance of the large-area PS-SSPM for different temperatures and operating biases to find the optimum operating parameters for the device in imaging applications. A detector module was built by coupling a polished 8×8 LYSO array, with 1×1×20 mm3 elements, to a 1×1 cm2 PS-SSPM. Flood images recorded at room temperature show good crystal separation as all 64 elements were separated from each other. Cooling the device at 10 °C showed significant improvement. The device optimum bias voltage was ~4.5V over breakdown voltage. The coincidence timing resolution was improved significantly by increasing the operating bias, as well as by lowering the temperature to 0 °C. Results show excellent imaging performance and good timing response with a large-area PS-SSPM device.

Performance measurements of a depth-encoding PET detector module based on position-sensitive avalanche photodiode read-out.

We are developing a high-resolution, high-efficiency positron emission tomography (PET) detector module with depth of interaction (DOI) capability based on a lutetium oxyorthosilicate (LSO) scintillator array coupled at both ends to position-sensitive avalanche photodiodes (PSAPDs). In this paper we present the DOI resolution, energy resolution and timing resolution results for complete detector modules. The detector module consists of a 7 x 7 matrix of LSO scintillator crystals (1 x 1 x 20 mm3 in dimension) coupled to 8 x 8 mm2 PSAPDs at both ends. Flood histograms were acquired and used to generate crystal look-up tables. The DOI resolution was measured for individual crystals within the array by using the ratio of the signal amplitudes from the two PSAPDs on an event-by-event basis. A measure of the total scintillation light produced was obtained by summing the signal amplitudes from the two PSAPDs. This summed signal was used to measure the energy resolution. The DOI resolution was measured to be 3-4 mm FWHM irrespective of the position of the crystal within the array, or the interaction location along the length of the crystal. The total light signal and energy resolution was almost independent of the depth of interaction. The measured energy resolution averaged 14% FWHM. The coincidence timing resolution measured using a pair of identical detector modules was 4.5 ns FWHM. These results are consistent with the design goals and the performance required of a compact, high-resolution and high-efficiency PET detector module for small animal and breast imaging applications.

Investigations on neutron-induced prompt gamma ray analysis of bulk samples.

A systematic investigation was carried out for the improvement of the prompt gamma interrogation method used for contraband detection by the pulsed fast/thermal neutron analysis (PFTNA) technique. Optimizations of source detector shielding and geometry, role of the type and dimension of the gamma detector, attenuation of neutrons and gamma rays in bulky samples were also studied. Results obtained for both the shielding materials and elemental content of cocaine simulants have been compared with the values calculated by the MCNP-4A code.