Mineral and natural films change the physical-chemical properties of grapes and modulate oviposition behaviour of Ceratitis capitata Wiedemann (Diptera: Tephritidae).

The Mediterranean fruit fly, Ceratitis capitata (Wiedemann), is one of the main pests of fruit, worldwide, and the use of population suppression method with low environmental impact is an increasingly strong requirement of the consumer market. The aim of this study was to evaluate the effect of mineral and natural films on the physical-chemical properties of grapes (Vitis vinifera L.), cultivar Itália, and oviposition behaviour of C. capitata. Fruits were immersed in suspensions (100 and 200 g L-1) of mineral (kaolin Surround®WP, kaolin 607, kaolin 608, kaolin 611 and talc) and natural films (chitosan, cassava starch, potato starch and guar gum 5.0 g L-1) and distilled water (control). After drying, fruits were exposed to C. capitata pairs of males and females for 24 h in choice and non-choice tests; the number of punctures with and without eggs, eggs per fruit and behavioural response of fly to treated and untreated fruits were recorded. Results obtained in this study are promising, given the scientific evidence that films of mineral particles such as kaolin (Surround®, 607, 608 and 611) changed the firmness, luminosity, chroma and hue angle of grapes and reduced the oviposition of C. capitata. In addition, our results also showed that natural polymers do not deter C. capitata females, but rather seem to stimulate oviposition.

The influence of solution environment on the nucleation kinetics and crystallisability of para-aminobenzoic acid.

The influence of solvent type on the solution thermodynamics, nucleation-kinetics and crystal growth of alpha para-aminobenzoic acid (PABA) crystallising from supersaturated ethanol, acetonitrile and water solutions, is examined using poly-thermal analysis of the metastable zone width. Application of a recently proposed model for analysis of crystallisation kinetics (J. Cryst. Growth, 2010, 312, 698-704) indicates a solvent and concentration dependence of the nucleation mechanism and key nucleation parameters for the alpha form of PABA. The mechanism of nucleation is found to change from instantaneous to progressive with decreasing concentration and also when changing the solvent from ethanol to acetonitrile to water. The dependence of the nucleation mechanism is correlated to the kinetic component of the nucleation rate through calculated values of instantaneously nucleated crystallites, which increase from 1.40 × 109 m-3 in ethanol to 1.08 × 1010 m-3 in acetonitrile to 2.58 × 1010 m-3 in water. This in combination with low calculated number concentrations of interfacial tension between 1.13 and 2.71 mJ m-2, supports the conclusion that the kinetic component of the nucleation rate is more limiting when crystallising PABA from ethanol solutions in comparison to water solutions. This finding is further supported by molecular dynamics simulations of the solvation free energy of PABA, which is found to be greatest in water, -42.4 kJ mol-1 and lowest in ethanol, -58.5 kJ mol-1.

Analysis of the activation mechanism of Pseudomonas stutzeri cytochrome c peroxidase through an electron transfer chain.

The activation mechanism of Pseudomonas stutzeri cytochrome c peroxidase (CCP) was probed through the mediated electrochemical catalysis by its physiological electron donor, P. stutzeri cytochrome c-551. A comparative study was carried out, by performing assays with the enzyme in the resting oxidized state as well as in the mixed-valence activated form, using cyclic voltammetry and a pyrolytic graphite membrane electrode. In the presence of both the enzyme and hydrogen peroxide, the peak-like signal of cytochrome c-551 is converted into a sigmoidal wave form characteristic of an E(r)C'(i) catalytic mechanism. An intermolecular electron transfer rate constant of (4 ± 1) × 10(5) M(-1) s(-1) was estimated for both forms of the enzyme, as well as a similar Michaelis-Menten constant. These results show that neither the intermolecular electron transfer nor the catalytic activity is kinetically controlled by the activation mechanism of CCP in the case of the P. stutzeri enzyme. Direct enzyme catalysis using protein film voltammetry was unsuccessful for the analysis of the activation mechanism, since P. stutzeri CCP undergoes an undesirable interaction with the pyrolytic graphite surface. This interaction, previously reported for the Paracoccus pantotrophus CCP, induces the formation of a non-native conformation state of the electron-transferring haem, which has a redox potential 200 mV lower than that of the native state and maintains peroxidatic activity.

Adaptation of a commercial ion selective fluoride electrode to a tubular configuration for analysis by flow methodologies.

The determination of fluoride ions in water samples is accomplished by using a tubular flow through detector constructed by drilling a channel through a commercially available LaF(3) crystal electrode in such a way that the original contacts of the non-modified unit are maintained. Its performance when incorporated in both FIA and SIA systems was evaluated and the results show that the tubular unit retains the characteristics of the non-modified electrode. In SIA conditions an extended linear range of response and lower detection limit were achieved when compared with the electrode performance in FIA conditions. These aspects together with the additional advantage of low sample and reagent consumptions in SIA when compared to FIA, makes the incorporation of the proposed tubular ISE in a SIA system the preferred approach for on line determination and monitoring of fluoride content in natural water samples.

Benefits of membrane electrodes in the electrochemistry of metalloproteins: mediated catalysis of Paracoccus pantotrophus cytochrome c peroxidase by horse cytochrome c: a case study.

A comparative study of direct and mediated electrochemistry of metalloproteins in bulk and membrane-entrapped solutions is presented. This work reports the first electrochemical study of the electron transfer between a bacterial cytochrome c peroxidase and horse heart cytochrome c. The mediated catalysis of the peroxidase was analysed both using the membrane electrode configuration and with all proteins in solution. An apparent Michaelis constant of 66 +/- 4 and 42 +/- 5 microM was determined at pH 7.0 and 0 M NaCl for membrane and bulk solutions, respectively. The data revealed that maximum activity occurs at 50 mM NaCl, pH 7.0, with intermolecular rate constants of (4.4 +/- 0.5) x 10(6) and (1.0 +/- 0.5) x 10(6) M(-1) s(-1) for membrane-entrapped and bulk solutions, respectively. The influence of parameters such as pH or ionic strength on the mediated catalytic activity was analysed using this approach, drawing attention to the fact that careful analysis of the results is needed to ensure that no artefacts are introduced by the use of the membrane configuration and/or promoters, and therefore the dependence truly reflects the influence of these parameters on the (mediated) catalysis. From the pH dependence, a pK of 7.5 was estimated for the mediated enzymatic catalysis.

Mediated catalysis of Paracoccus pantotrophus cytochrome c peroxidase by P. pantotrophus pseudoazurin: kinetics of intermolecular electron transfer.

This work reports the direct electrochemistry of Paracoccus pantotrophus pseudoazurin and the mediated catalysis of cytochrome c peroxidase from the same organism. The voltammetric behaviour was examined at a gold membrane electrode, and the studies were performed in the presence of calcium to enable the peroxidase activation. A formal reduction potential, E (0)', of 230 +/- 5 mV was determined for pseudoazurin at pH 7.0. Its voltammetric signal presented a pH dependence, defined by pK values of 6.5 and 10.5 in the oxidised state and 7.2 in the reduced state, and was constant up to 1 M NaCl. This small copper protein was shown to be competent as an electron donor to cytochrome c peroxidase and the kinetics of intermolecular electron transfer was analysed. A second-order rate constant of 1.4 +/- 0.2 x 10(5) M(-1) s(-1) was determined at 0 M NaCl. This parameter has a maximum at 0.3 M NaCl and is pH-independent between pH 5 and 9.

Redox chemistry of low-pH forms of tetrahemic cytochrome c3.

Desulfovibrio vulgaris Hildenborough cytochrome c(3) contains four hemes in a low-spin state with bis-histidinyl coordination. High-spin forms of cytochrome c(3) can be generated by protonation of the axial ligands in order to probe spin equilibrium (low-spin/high-spin). The spin alterations occurring at acid pH, the associated changes in redox potentials, as well as the reactivity towards external ligands were followed by the conjunction of square wave voltammetry and UV-visible, CD, NMR and EPR spectroscopies. These processes may be used for modelling the action of enzymes that use spin equilibrium to promote enzyme activity and reactivity towards small molecules.

Flow amperometric determination of pharmaceuticals with on-line electrode surface renewal.

In this article, a flow system developed for the amperometric determination of a great variety of pharmaceuticals that are known to lead the rapid poisoning of the working electrode surface is described. The referred system was made up of two parallel flow channels that shared the voltammetric detector of tubular configuration, whose movement in the manifold followed the concept of multi-site location of detector. In this way, after each measurement, the conditioning of the working electrode was possible through the passage by its surface of a regeneration solution without implying the alteration of the carrier that flowed in the analytical channel of the manifold. The methodology proposed was evaluated through the determination of two drugs belonging to two distinct therapeutic groups: an antihypertensive (diltiazem) and a non-steroid anti-inflammatory (nimesulide). The results obtained after evaluation of various pharmaceutical formulations on the Portuguese market were in the case of diltiazem compared with those supplied by the reference US Pharmacopoeia XXIV method, with no statistically significant differences having been observed for a confidence interval of 95%. In the case of nimesulide, since no official reference method exists, a series of recovery experiments were proceeded with and a mean value of 101.1% with a R.S.D. of 0.7% was obtained.

Square-wave voltammetric techniques for determination of psychoactive 1,4-benzodiazepine drugs.

Direct square-wave voltammetry (SWV) and square-wave cathodic stripping voltammetry (SWCSV) at hanging mercury drop electrodes have been developed for determination of the psychoactive 1,4-benzodiazepine compounds clonazepam, bromazepam, midazolam, diazepam, medazepam, and flurazepam over a wide range of concentrations. Analysis was performed with better precision, lower detection limits, and much more rapidly than by previously reported voltammetric techniques. The applicability of both procedures is discussed. The methods were applied to the analysis of commercially available tablets with minimum sample manipulation. The accuracy of the results was accessed by comparison with those obtained by use of the methods described in official pharmacopoeias. A critical comparison with those procedures is also presented.

Copper-psychoactive drug complexes: a voltammetric approach to complexation by 1,4-benzodiazepines.

Copper complexation by the 1,4-benzodiazepines medazepam, diazepam, flurazepam, nitrazepam, and clonazepam was investigated using differential pulse polarography and cyclic voltammetry at a mercury electrode in 0.10 M KNO3 and pH 7.0 +/- 0.1. Because the 1,4-benzodiazepines are easily reduced at a mercury electrode through the two-electron reduction of the 4,5-azomethine functional group, copper reduction, as well as that of the ligands, was analyzed under varying experimental conditions. In most situations adsorption phenomena occurred and their influence on voltammetric signals had to be carefully analyzed. The voltammetric behavior was then interpreted in terms of complex formation. The results showed that all benzodiazepines can act as ligands toward copper(II) ions, forming 1:1 and 1:2 complexes with similar stabilities. The stoichiometric acidity constants of the benzodiazepines under study were also determined by potentiometric titration in water-ethanol medium and 0.10 M KNO3 and then extrapolated to 0% concentration of ethanol.

Gradient flow titration for the determination of fluoride ion in natural waters.

The determination of fluoride ions in water samples was accomplished by using a gradient flow titration. A standard commercial combined electrode is used in a cell configuration that combines the gradient chamber and the electrode in a single unit. The methodology developed gives results with a relative standard deviation of about 3%. The average recoveries after spiking natural samples with fluoride are in the range 100-102%. The method was used successful in determining the fluoride concentration in water samples.

Thermodynamics of uptake of cadmium by Chlorella marina.

From voltammetric titration curves of living Chlorella marina cells with cadmium ion, at constant pH, the surface binding capacity of the alga was determined and interpreted in terms of average conditional equilibrium constants and of differential equilibrium function. Since the alga can live in estuaries, the influence of ionic strength and competition of alkaline and alkaline earth cations has been considered. Cadmium complexation with dead algae killed by heat or using formaldehyde has also been studied for comparison.

Spectrophotometric determination of bromhexine hydrochloride in pharmaceutical preparations.

The presence of an aromatic primary amino group in bromhexine HCl enables the use of diazotization-coupling, according to the classic Bratton-Marshall method, for its analysis in pharmaceutical preparations. Spectrophotometric parameters were established for standardization of the method, including statistical analysis of data. Substances such as potassium guaiacolsulfonate, ampicillin, cephalexin, oxytetracycline HCl, amoxycillin, and erythromycin ethylsuccinate do not interfere with the determination. The precision of the method is about 2.0%.