Decomposition of two types of electric wires considering the effect of the metal in the production of pollutants.

Combustion runs at 700 °C in a horizontal laboratory furnace were carried out on two different electric wires (PVC and halogen-free wire). Tests were performed in the presence and in the absence of the metal conductor of the wires. The analyses of the polycyclic aromatic hydrocarbons (PAHs), chlorobenzenes (CBzs), chlorophenols (CPhs), mono- to octa-chlorodibenzo-p-dioxin and dibenzofurans (PCDD/Fs), and dioxin-like PCBs are shown. Regarding semivolatile compounds, PAHs production decreases in the presence of metal, while a higher amount of chlorinated compounds are emitted. Respect to the PCDD/Fs, the PVC wire in the presence of metal presents the highest emission, with a much more emission of furans than dioxins. The maximum emission is with 2 or 3 chlorine atom PCDD/Fs. PCBs emission correlates with PCDD/F production and represents 3-4% of total toxicity, determined by using WHO2005 factors.

Thermal decomposition of electronic wastes: mobile phone case and other parts.

Pyrolysis and combustion runs at 850°C in a horizontal laboratory furnace were carried out on different parts of a mobile phone (printed circuit board, mobile case and a mixture of both materials). The analyses of the carbon oxides, light hydrocarbons, polycyclic aromatic hydrocarbons (PAHs), polychlorodibenzo-p-dioxin, polychlorodibenzofurans (PCDD/Fs), and dioxin-like PCBs are shown. Regarding semivolatile compounds, phenol, styrene, and its derivatives had the highest yields. In nearly all the runs the same PAHs were identified, naphthalene being the most common component obtained. Combustion of the printed circuit board produced the highest emission factor of PCDD/Fs, possibly due to the high copper content.

Pollutant formation and emissions from cement kiln stack using a solid recovered fuel from municipal solid waste.

The thermal decomposition of a solid recovered fuel (SRF) has been studied by two techniques. First, laboratory-scale experiments were performed in a horizontal furnace in which different atmospheres were studied to analyze the dioxins and furans (PCDD/Fs) evolved from the decomposition of the material. Sulfur presence was revealed to be important in PCDD/Fs formation. In the second technique, the emissions of various pollutants (PAHs, PCDD/Fs, metals, acid gases, etc.) were determined in a cement kiln fed on different proportions of SRF material, and where a maximum feed rate of 15000 kg SRF/h was achieved. In the laboratory furnace the dioxin toxicity revealed a maximum when the amount of oxygen in the atmosphere increased until approximately stoichiometric conditions. In the cement kiln, all emitted pollutants were under the legal limits. No correlation between SRF input and metal emission was observed.