The Effect of Long-Term X-Ray Exposure on Human Lymphocyte.

The aim of the paper is to investigate effects of long term x-ray exposure on the human lymphocyte, reactive lymphocyte parameters and morphology of lymphocytes in x-ray technicians at Kirkuk hospitals. The study included 54 apparently healthy male x-ray technicians were matched with another 54 apparently healthy control to show any alteration in the lymphocytes, reactive lymphocytes and morphology. The investigated samples were divide into two groups depending on the work experience and working hours per day. The samples were tested for hematological parameters by complete blood cells count (CBC). The results showed that strong significant (P<0.0001) increasing was recorded for the reactive lymphocytes in all groups of the diagnostic technicians compared with their controls and significantly increasing of lymphocytes observed for some groups. It was concluded that chronic exposure of x-ray can vary lymphocyte and reactive lymphocyte parameters significantly and working hours per day have discernible effects on lymphocyte morphology.

Design and in vivo evaluation of a molecularly defined acellular skin construct: reduction of early contraction and increase in early blood vessel formation.

Skin substitutes are of great benefit in the treatment of patients with full thickness wounds, but there is a need for improvement with respect to wound closure with minimal contraction, early vascularisation, and elastin formation. In this study we designed and developed an acellular double-layered skin construct, using matrix molecules and growth factors to target specific biological processes. The epidermal layer was prepared using type I collagen, heparin and fibroblast growth factor 7 (FGF7), while the porous dermal layer was prepared using type I collagen, solubilised elastin, dermatan sulfate, heparin, fibroblast growth factor 2 (FGF2) and vascular endothelial growth factor (VEGF). The construct was biochemically and morphologically characterised and evaluated in vivo using a rat full thickness wound model. The results were compared with the commercial skin substitute IntegraDRT and untreated wounds. The double-layered construct was prepared according to the design specifications. The epidermal layer was about 40 µm thick, containing 9% heparin and 0.2 µg FGF7 mg per layer, localised at the periphery. The dermal layer was 2.5 mm thick, had rounded pores and contained 10% dermatan sulfate+heparin, and 0.7 µg FGF2+VEGF mg per layer. The double-layered skin construct was implanted in a skin defect and on day 7, 14, 28 and 112 the (remaining) wound area was photographed, excised and (immuno) histologically evaluated. The double-layered skin construct showed more cell influx, significantly less contraction and increased blood vessel formation at early time points in comparison with IntegraDRT and/or the untreated wound. On day 14 the double-layered skin construct also had the fewest myofibroblasts present. On day 112 the double-layered skin construct contained more elastic fibres than IntegraDRT and the untreated wound. Structures resembling hair follicles and sebaceous glands were found in the double-layered skin construct and the untreated wound, but hardly any were found in IntegraDRT. The results provide new opportunities for the application of acellular skin constructs in the treatment of surgical wounds.

Controlled fabrication of triple layered and molecularly defined collagen/elastin vascular grafts resembling the native blood vessel.

There is a consistent need for a suitable natural biomaterial to function as an arterial prosthesis in achieving arterial regeneration. Natural grafts are generally obtained by decellularization of native blood vessels, but batch to batch variations may occur and the nature/content of remaining contaminants is generally unknown. In this study we fabricated a molecularly defined natural arterial graft from scratch resembling the native three layered architecture from the fibrillar extracellular matrix components collagen and elastin. Using casting, moulding, freezing and lyophilization techniques, a triple layered construct was prepared consisting of an inner layer of elastin fibres, a middle (porous) film layer of collagen fibrils and an outer scaffold layer of collagen fibrils. The construct was carbodiimide cross-linked and heparinized. Characterization included biochemical/biophysical analyses, scanning electron microscopy, micro-computed tomography, (immuno)histology and haemocompatibility. Burst pressures were up to 400mm Hg and largely conferred by the intermediate porous collagen film layer. The highly purified type I collagen fibrils and elastin fibres used did not evoke platelet aggregation in vitro. Suturability of the graft in end to side anastomosis was successful and considered adequate for in vivo application.