Effect of dry salt versus brine injection plus dry salt on the physicochemical characteristics of smoked salmon after filleting.

Smoked fish fillets are pre-salted as a food conservation and quality preservation measure. Here we investigated biochemical and sensory aspects of smoked salmon fillets. Left-side salmon fillets were dry-salted while the right-side fillets underwent a mixed salting method consisting of an injection of saturated brine followed by surface application of dry salt. After 6 h of salting, all the fillets were smoked. At each step of the process, quality was evaluated using instrumental measurements (pH, color, texture, water content, salt content, aw), and lipid distribution was visualized by MRI. Mixed-salted fillets had a higher salt content than dry-salted fillets and variability in salt distribution was dependent on the salting process. However, these variations had no effect on pH, color or texture, which showed similar values regardless of salting method. Fatty areas had a lower salt content due to slower diffusion of aqueous salt solutions through them. Mixed salting speeds up the salting of the muscle without significantly affecting the quality traits of the salmon fillet.

Impact of Tumbling Process on the Toughness and Structure of Raw Beef Meat Pieces.

Tenderness is a major factor in consumer perception and acceptability of beef meat. Here we used a laboratory tumbling simulator to investigate the effectiveness of the tumbling process in reducing the toughness of raw beef cuts. Twelve Semitendinosus beef muscles from cows were tumbled according to four programs: T1 (2500 consecutive compression cycles (CC), for about 3 h), T2 (6000 CC, about 7.5 h), T3 (9500 CC, about 12 h), and T4 (13,000 CC, about 16 h). The effect of tumbling on the toughness of raw meat was assessed using compression tests (stresses measured at 20% and 80% of deformation ratios) and microscopic observations made at the periphery and centre of meat samples, and compared against non-tumbled controls. Longer tumbling times significantly reduced the stresses measured at 20% and 80% compression rates, which reflected the toughness of muscle fibres and connective tissue, respectively. At the microscopic level, longer tumbling times led to reduced extracellular spaces, increased degradation of muscle structure, and the emergence of amorphous zones. A 12-h tumbling protocol ultimately makes the best compromise between the process time demand and toughness reduction in beef Semitendinosus meat pieces.