RESUMO
OBJECTIVES: This study was carried out to examine the effect of application of four different disinfecting agents on the micro-shear bond strength (µ-SBS) of an etch-and-rinse and self-etch adhesive systems. MATERIALS AND METHODS: One hundred flat dentin surfaces of human molars were produced by wet grinding the buccal surfaces. Specimens were randomly assigned to five groups according to the disinfectant used: Group I: Control (no disinfectant); Group II: 5.25% sodium hypochlorite based; Group III: 2% chlorhexidine based (Consepsis), Group IV: 0.1% benzalkoniumchloride based (Tubulicid red) and Group V: 3% doxycycline based (Biopure, MTAD). Specimens were bonded using either Adper Single Bond 2 or Clearfil S(3) Bond, which were employed according to the manufacturer's instructions. Resin composite microcylinders were bonded using Tygon(®) tubes for µ-SBS testing. The modes of failure were noted after visual examination using a binocular stereomicroscope at ×25 magnification. Failures were classified as adhesive, or mixed. µ-SBS results were analyzed using two-way ANOVA followed by Tukey's post-hoc test. RESULTS: Dentin disinfectants tested significantly negated the bonding of Adper Single bond 2 and the groups were ranked; Group I > Group V = Group IV > Group II = Group III, meanwhile they enhanced significantly the µ-SBS values upon using Clearfil S(3) Bond and were ranked; Group II > Group III = Group IV = Group V > Group I. Most failures were adhesive with the Adper single bond adhesive system. Mixed modes of failure were evident with Clearfil S(3) bond. CONCLUSIONS: The disinfectants tested should not be used with Adper Single Bond 2 when applied before the etching step, However they could be used safely prior to bonding with Clearfil S(3) Bond.
