Use of Nile tilapia (Oreocromis niloticus) processing residues in the production of pâtés with the addition of oregano (Origanum vulgare) essential oil.

The effect of the use of Nilo tilapia filleting residues in the production of pâtés with the addition of oregano essential oil stored for 90 days at 4 °C was evaluated. For that, 5 treatments were performed as follows: TSA-control treatment; TES with the addition of sodium erythorbate; and formulation TOE1 with 600 ppm oregano essential oil; TOE2 with 1000 ppm essential oil; and TOE3 with 1400 ppm essential oil. The pâtés showed adequate technological and physicochemical characteristics and microbiological counts within the legislation standards. No significant differences were observed in the luminosity of the pâté formulations during storage, and the addition of oil contributed to the increase in a* values and stability of b* values. Regarding the lipid and protein oxidation, TOE3 showed lower values at the end of the shelf-life. The addition of essential oil did not affect the hardness and cohesiveness of the products. The fatty acids in greater amounts in the samples were linoleic, oleic, palmitic, and stearic acids. The analysis of biogenic amines indicated that only the treatments with the highest amounts of sodium erythorbate (TES and TOE1) showed losses of spermidine. It was observed that decreasing the inclusion of sodium erythorbate and increasing the inclusion of oregano essential oil resulted in a drop in cadaverine values. A total of 46 volatile compounds were detected in the samples with the highest amount of free fatty acids and all the formulations were well accepted sensorially.

Optimization of the extraction of phenolic compounds from the leaves of yerba mate (Ilex paraguariensis) through high hydrostatic pressure system using mixture design with process variables.

In this study, a mixture design with process variables was used to optimize the extraction of total phenolic compounds (TPC) from yerba mate leaves through high hydrostatic pressure extraction. The studied variables were pressure (50, 100, and 150 MPa), extraction time (10, 20, and 30 min), and solvent (water, glycerin, and 50% v/v water/50% v/v glycerin). The multiple linear regression model presented an excellent fit (R2 adjusted of 0.9792) and demonstrated the major influence of glycerin content on the water/glycerin mixture solvent for TPC extraction. Optimal process conditions obtained were 69% v/v water, 31% v/v glycerin, 50 MPa pressure, and 10 min time. PRACTICAL APPLICATION: The paper describes a novel extraction method to obtain phenolic compounds from yerba mate (compounds that can replace synthesized antioxidants in the food industry) using high hydrostatic pressure and environmentally friendly solvents. The extraction process was studied to optimize its performance, obtaining more phenolic compounds from the same amount of yerba mate.

Quality of Oreochromis niloticus and Cynoscion virescens fillets and their by-products in flours make for inclusion in instant food products.

The production of fish flour is an alternative for better use of the raw material, although it is rarely used in instant food. Thus, the aimed of this study was to evaluate Oreochromis niloticus (Nile tilapia) and Cynoscion virescens (croaker) fillets and the elaboration of flour with filleting by-products for inclusion in food products. Carcasses and heads of the two fish species were cooked, pressed, ground, subjected to drying and re-grinding to obtain standardized flours. These carcass flours were seasoned (sweet and salted). This study was organized into two experimental tests: Test 1: Yield, physicochemical and microbiological analyzes of fillets and flours made from carcass and head of Nile tilapia and croaker; Test 2: Seasoned flours made from Nile tilapia carcasses. There was a difference in fillets yield, where the croaker demonstrated 46.56% and the Nile tilapia 32.60%. Nile tilapia fillets had higher protein content (17.08%) and lower lipid content (0.89%) compared to croaker fillets (14.21 and 4.45%). Nile tilapia backbone flour had the highest protein content (55.41%) and the croaker the highest ash (45.55%) and the lowest Nile tilapia (28.38%). The head flours had lower protein contents (39.86%). Flours produced with croaker backbone had higher levels of calcium and phosphorus (9.34 and 9.27%). However, Nile tilapia backbone flour showed higher contents of essential amino acids. These flours demonstrated a fine granulometry (0.23 to 0.56 mm). Seasoned flours demonstrated interaction between fish species and flavors for moisture, ash, carbohydrates, calcium and phosphorus. The highest protein content (29.70%) was for Nile tilapia flour sweet flours (31.28%) had higher protein content, while salted lipids (8.06%). Nile tilapia has a lower fillet yield, although with a high protein content and low lipid content. Comparing the flours made from filleting by-products, the backbone flour has better nutritional quality, with Nile tilapia being superior to that of croaker, especially in terms of protein and amino acids.

Characterization and Strength Quality of the Oryctolagus cuniculus Leather Compared to Oreochromis niloticus Leather.

This study aimed to compare the resistance of the Oryctolagus cuniculus L. (rabbit) and Oreochromis niloticus L. (Nile tilapia) skins, as well as to observe the design of the flower of these skins and the morphology of the dermis. Tilapia and rabbit skins were placed inside the same equipment (tannery machine) for the chromium salt tanning process. The flower design of the fish leather distinguishes it from the rabbit leather, the latter being constituted by the opening of the hair follicles and pores, while the fish leather is constituted by the presence of protective lamellae and insertion of the scales. The dermis of rabbit skin consists of thick bundles of collagen fibers arranged in all directions, which differs from the morphology observed in the dermis of fish skin. However, in the Nile tilapia skin dermis, overlapping and parallel layers of longitudinal collagen fiber bundles are observed, these layers are interspersed with fiber bundles crossing the sking surface (transversely), tying the fibers together and providing greater strength, which can be proven by the strength test. The fish leathers, despite having less thickness (1.0 mm), demonstrated significantly greater tensile strength (13.52 ± 1.86 N mm-2) and tear strength (53.85 ± 6.66 N mm-2) than rabbit leathers, that is, (8.98 ± 2.67 N mm-2) and (24.25 ± 4.34 N mm-2). However, rabbit leather demonstrated higher elasticity (109.97 ± 13.52%) compared to Nile tilapia leather (78.97 ± 8.40%). It can be concluded that although the rabbit leather is thicker due to the histological architecture of the dermis (thick bundles of collagen fibers arranged in all directions with no pattern of organization of collagen fibers), it shows less resistance than Nile tilapia leather, which demonstrates an organization of overlapping and parallel layers and intercalating collagen fiber bundles transversally to the surface, functioning as tendons for the swimming process. It is recommended to use a piece of fabric (lining) together with the fleshy side of the rabbit leather, to increase resistance when used in clothing and footwear, as these products require greater tensile strength. Thus, it minimizes this restriction for the use of rabbit leather in the aforementioned purposes.

Flavored Amazonic pirarucu (Arapaima giga) waste flour (salted and sweet) for inclusion in food products.

This study aimed to develop flavored flours (salty and sweet) from Amazonic pirarucu waste (Arapaima gigas), include them in extruded snacks, and evaluate the nutritional, physicochemical, microbiological, and acceptance characteristics of these products. A standard flour was elaborated with pirarucu carcass, which presented 54.42% of protein and 7.24% of lipids, and from this, flavored flours were elaborated (salty and sweet). The standard flour had higher levels of protein, calcium, and phosphorus; and the salted one had higher levels of lipids. The fatty acids present in greater quantities were oleic (average of 32.21%), linolenic (average of 20.74%), and palmitic (average of 17.81%). The flavored flours were better accepted than the standard flour, for all sensory attributes and purchase intention. The snacks with sweet flour, despite better results in the sensory attributes of color, aroma, and flavor, were the ones that presented the lowest content of protein and ash, when compared to those with inclusion of standard flour. It is concluded that the pirarucu waste can be used for producing flavored flours and extruded snacks, with the purpose of improved food products.

Effect of the addition of the probiotic Bifidobacterium animalis subsp. Lactis (BB-12) in free and microencapsulated form and the prebiotic inulin to synbiotic dry coppa.

The effect of the addition of the prebiotic inulin and free and microencapsulated Bifidobacterium animalis subsp. Lactis (BB-12) strains to synbiotic dry coppa formulations was evaluated during 45 days of ripening. The following formulations were made: control C without probiotic and prebiotic; PROB with free probiotic; SYNB with free probiotic and inulin; ENPROB with microencapsulated probiotic, and ENSYNB with microencapsulated probiotic and inulin. The incorporation of BB-12 with inulin provided adequate physicochemical characteristics (proximate composition, weight loss, pH, water activity (aw), and instrumental color). The treatments PRO and SYNB showed lower lipid and protein oxidation levels. The treatments PROB, SYNB, ENPROB, and ENSYNB had viable cell counts above 109 CFU/g and can be considered probiotic. In the in vitro gastrointestinal simulation, the BB-12 strain showed survival and growth capacity in saline solution and at low pH values for all treatments. The sample SYNB was the most accepted by the assessors in the sensory evaluation. Therefore, dry coppa can be used as a vehicle for the development of a synbiotic fermented meat product.

Pantanal yacare (Caiman yacare) tail fillets subjected to traditional hot smoking and liquid smoke.

BACKGROUND: The present study aimed to evaluate the effects of hot smoking and liquid smoke on process yield, physicochemical properties, microbiological parameters, fatty acid profile, benzo(a)pyrene levels, and sensory profile of Pantanal yacare tail fillets. The fillets were subjected to two types of smoking processes: hot smoking and liquid smoke flavoring. RESULTS: The process yield of liquid-smoked fillets was higher (69.8%) compared to hot-smoked fillets (58.0%). All fillets were with good microbiological quality and low benzo(a)pyrene levels and were well accepted by consumers. The hot-smoked fillets and the liquid-smoked fillets presented 456.2 and 589.7 g kg-1 moisture, 262.3 and 263.7 g kg-1 crude protein, 218 and 85 g kg-1 total lipids, and 26.0 and 20.9 g kg-1 ash, respectively. The major fatty acids identified in the smoked tail fillets were palmitic, stearic, oleic, and linoleic acids. CONCLUSION: The liquid-smoked fillets had lower lipid content, and higher process yield because of lower losses; thus, they proved to be more advantageous and practical to obtain than the hot-smoked fillets. © 2022 Society of Chemical Industry.

Sodium chloride reduction in fresh sausages using salt encapsulated in carnauba wax.

Carnauba wax was used in salt encapsulation, allowing sodium reduction in fresh sausages while maintaining the salty taste due to the inhomogeneous salt distribution. Four treatments were made, as follows: treatment C containing 2% non-encapsulated salt, and the treatments S2.0%, S1.5%, and S1.0% containing 2, 1.5, and 1% encapsulated salt, respectively. The physicochemical parameters were within the standard regulations for all treatments, with the lower hardness and cohesiveness observed for S1.0%. The treatments and the storage period (90 days) had no effect on aw and instrumental color. Although a decrease in pH and an increase in lipid oxidation were observed during storage, the results were within acceptable levels. Concerning the consumers' perception of saltiness, the assessors reported no differences among the treatments C, S2.0%, and S1.5%. Thus, it is possible to reduce 25% salt in fresh sausages using the taste contrast technology.

Supplementation with free methionine or methionine dipeptide improves meat quality in broilers exposed to heat stress.

This study aimed to evaluate the effect of methionine dipeptide supplementation on the meat quality of broilers subjected to heat stress. A completely randomized 3 × 2 factorial design with four repetitions of each treatment was used. Three diets, unsupplemented (U), supplemented with methionine (M), and supplemented with methionine dipeptide (MM), were fed to 96 broilers subjected to thermal comfort (TC) or heat stress (HS, 32 °C for 24 h) conditions antemortem. Meat quality parameters, total antioxidant capacity (TAC), protein and lipid oxidation, and ryanodine receptor type 3 (RYR3) gene expression in breast muscle of 35-day-old broilers were evaluated. Methionine supplementation (M and MM) enhanced the nutritional quality of breast meat. Diet had a significant effect on breast meat pH, color (a*), and nitrogen and lipid contents. Interaction effects of diet and HS on TAC and protein oxidation were not observed. Diet and HS influenced lipid oxidation of breast meat after 7 days of refrigerated storage. High RYR3 expression was observed in breast meat of broilers subjected to heat stress and fed the U diet. No differences were observed between M and MM diets in any of the parameters evaluated. The results showed that both sources of methionine (M and MM) can be supplemented in broiler diets with beneficial effects on breast yield and meat nutritional quality. In addition, HS has made chickens more susceptible to biomolecule oxidation, and MM can potentiate chicken TAC. Further study is needed to better understand the effects of MM on broilers.

Qualidade de doce de leite pastoso, adicionado de soro de queijo em pó / Quality of dulce de leche, the addition of cheese powder whey

O processamento de doce de leite, embora empregue uma tecnologia simples, apresenta alguns problemas tecnológicos, sendo um deles a desestabilização das proteínas. Outro problema é a estabilidade microbiológica, que depende principalmente do controle higiênico do processo e deve ser atingida por evitar desenvolvimento de bolores e leveduras que podem ocorrer mesmo em condições de alta pressão osmótica do produto. O presente trabalho tem como principal objetivo avaliar as condições de soro de queijo em pó. Na maioria das amostras não foi detectada a presença de bolores e leveduras e de Stafilococus aureus coagulase positiva, encontrando-se valores inferiores a 1 x 10² UFC/g. Sendo assim todas as amostras encontram-se aptas para o consumo humano e dentro dos padrões da legislação.