Traditional graft preparation decreases physiologic responses, diminishes viscoelasticity, and reduces cellular viability of the conduit: A porcine saphenous vein model.

Traditional methods of intraoperative human saphenous vein preparation for use as bypass grafts can be deleterious to the conduit. The purpose of this study was to characterize acute graft preparation injury, and to mitigate this harm via an improved preparation technique. Porcine saphenous veins were surgically harvested (unprepared controls, UnP) and prepared using traditional (TraP) and improved preparations (ImP). The TraP used unregulated radial distension, marking with a surgical skin marker and preservation in heparinized normal saline. ImP used pressure-regulated distension, brilliant blue FCF-based pen marking and preservation in heparinized Plasma-Lyte A. Rings from each preparation were suspended in a muscle bath for characterization of physiologic responses to vasoactive agents and viscoelasticity. Cellular viability was assessed using the methyl thiazolyl tetrazolium (MTT) assay and the terminal deoxynucleotidyl transferase dUTP nick-end labeling (TUNEL) assay for apoptosis. Contractile responses to potassium chloride (110 mM) and phenylephrine (10 µM), and endothelial-dependent and independent vasodilatory responses to carbachol (0.5 µM) and sodium nitroprusside (1 µM), respectively, were decreased in TraP tissues compared to both UnP and ImP tissues (p ⩽ 0.05). TraP tissues demonstrated diminished viscoelasticity relative to UnP and ImP tissues (p ⩽ 0.05), and reduced cellular viability relative to UnP control (p ⩽ 0.01) by the MTT assay. On the TUNEL assay, TraP tissues demonstrated a greater degree of apoptosis relative to UnP and ImP tissues (p ⩽ 0.01). In conclusion, an improved preparation technique prevents vascular graft smooth muscle and endothelial injury observed in tissues prepared using a traditional approach.

Re-defining pseudoptosis from a 3D perspective after short scar-medial pedicle reduction mammaplasty.

BACKGROUND: Bottoming out is a well-known phenomenon described with reduction mammaplasty (RM). To date, the evaluation of post-operative bottoming out remains an imprecise science. The following study reports the application of three-dimensional (3D) photography to objectively investigate changes in breast morphology. METHODS: Patients undergoing medial pedicle RM had 3D photographs (Konica Minolta V910) taken during the early and late post-operative period (early=60-120 days; late=400-500 days). 3D images were compared and bottoming out was assessed with 3D parameters and vectors including total breast volume, volumetric tissue distribution above and below the Central (C) plane, distance of the C-plane to the lowest point of the breast, and maximum anterior-posterior projection from the chest wall. RESULTS: Post-operative images from 15 consecutive RM patients showed an average volume of 556+/-144 cm3 (early) and 441+/-183 cm3 (late). The percent of tissue in the upper pole of the breast changed from the early to late post-operative period (76% vs. 69%, respectively; p<0.01). The distance from a fixed C-plane to the inferior pole significantly increased (42+/-15 mm early vs. 51+/-18 mm late; p<0.01). AP projection decreased by an average of 6.23 mm (p<0.01). The lateral border of the IMF significantly dropped by 6.27 mm. CONCLUSIONS: This study objectively describes both the occurrence of bottoming out and the quantitative amount in terms of changes in volumetric distribution, surface topography and breast projection. With 3D photography, plastic surgeons can perform objective evaluation of breast transformation over time, which ultimately will aid in planning to allow for better surgical outcomes.

3D analysis of breast augmentation defines operative changes and their relationship to implant dimensions.

Breast augmentation is one of the most common plastic surgery procedures performed in the United States today. Evaluation of postoperative results lacks true objective measurements. The following study reports the application of 3-dimensional (3D) photography to document changes that occur in breast morphology after breast augmentation. Patients undergoing augmentation mammaplasty with a periareolar incision were offered pre- and postoperative 3D photographs. 3D models were constructed and the following parameters were assessed: maximum anterior-posterior projection from the chest wall, angle of breast projection, total breast volume, volumetric tissue distribution in the superior and inferior poles, and surface and vector distance measurements to key landmarks. A completed series of 3D images were obtained from 14 augmentation patients (28 breasts) at an average postoperative day of 143. Saline and silicone implants were used equally (n = 14 for each). Total volume of the breast changed in correlation with the implant size (1.9% difference, P = 0.83). There were no significant changes in the volumetric distribution within the upper and lower poles of the breasts noted between pre- and postoperative scans (P = 0.81). The internal angle of breast projection was found to increase (13.6 degrees, P < 0.01), as did the sternal notch to nipple distance (11 mm, P = 0.018). Anterior-posterior projection significantly increased by 23.3 mm. However, this increase in projection was 20.9% less than expected based on implant dimensions (72.7-58.7 mm, respectively, P < 0.01). This study documents objective changes in breast morphology after augmentation mammaplasty. 3D imaging scans were able to document true changes that occur with breast augmentation including breast volume, the increase in the internal angle of the breast projection, and the sternal notch to nipple distance. 3D photography further highlighted that breast augmentation results in less than expected anterior-posterior projection, possibly due to tissue attenuation occurring anterior to the implant.