Identification and health risk evaluation of soil contaminated by polycyclic aromatic hydrocarbons at shale gas extraction sites based on positive matrix factorization.

The impact of shale gas extraction on surrounding environmental media remains unclear. In this study, the current state of contamination by polycyclic aromatic hydrocarbons (PAHs), which are high-frequency contaminants of shale gas, was investigated in the soil surrounding emerging shale gas development sites. The source analysis of PAHs was conducted in the soils of shale gas extraction sites using positive matrix factorization (PMF). The health risk assessment (HRA) was calculated for ingestion, dermal contact, and inhalation exposures, and the priority sources of PAHs in the soil were jointly identified by PMF and HRA to refine the contribution level of different individual PAHs to the carcinogenic risk. The results showed that both Sichuan and Chongqing mining site soils were contaminated to different degrees. Shale gas extraction has an impact on the surrounding soil, and the highest contributing source of PAHs in the mining site soil of Sichuan was anthropogenic activity, accounting for 31.6%, whereas that in the mining site soil of Chongqing was biomass combustion and mixed automobile combustion, accounting for 35.9%. At the two mining sites in Sichuan and Chongqing, none of the three exposure pathways (ingestion, dermal contact, and inhalation) posed a carcinogenic risk to children, whereas the dermal exposure pathway posed a carcinogenic risk to adults. Health risk assessments based on specific source assignments indicate that when managing soil pollution, the control of fossil fuel combustion and vehicular emissions should be prioritized.

Amplification of fluorescence polarization signal based on specific recognition of aptamers combined with quantum quenching effect for ultrasensitive and simple detection of PCB-77.

Here, we report a novel aptasensor based on decahedral silver nanoparticles (Ag10NPs) enhanced fluorescence polarization (FP) for detecting PCB-77. Using aptamer modified Ag10NPs hybridized with DNA sequence labeled fluorescent group as an analytical probe, polychlorinated biphenyls (PCB-77) could be detected with high sensitivity and selectivity. The linear range of determination was 0.02 ng/L to 390 ng/L and the limit of detection was 5 pg/L. In addition, through the optimization of the experiment condition and signal probe DNA (pDNA), we found that the maximum FP signal could be generated when the distance between fluorescein and the surface of Ag10NPs was 3 nm. When the aptamer was immobilized on the surface of Ag10NPs could be strengthened the anti-interference performance of aptamer nanoprobe and further improved the detection ability. At the same time, we also compared the detection performance of the traditional FP signal enhancer streptavidin (SA) analysis system. The fluorescence polarization aptasensor could detect PCB-77 samples efficiently in complex environmental water, which shows a good application prospect.

Bioleaching for detoxification of waste flotation tailings: Relationship between EPS substances and bioleaching behavior.

The production of large volumes of waste flotation tailings results in environmental pollution and presents a major ecological and environmental risk. This study investigates bioleaching of waste flotation tailings using Acidithiobacillus ferrooxidans. The experiments were performed with 5.00% solid concentration, pH 2.0 with 100 mL medium for 25 d in the lab. The pH, OPR, metal concentration, dissolved organic matter (DOM) in leachate and extracellular polymeric substances (EPS) were recorded. Bioleaching tailing materials were finally characterized. Results showed that microorganisms, acclimating with mine tailings, effectively accelerated the bioleaching process, achieving maximum Zn and Fe extraction efficiencies of 95.45% and 83.98%, respectively, after 25 days. Compared with raw mine tailings, bioleaching could reduce 96.36% and 95.84% leachable Zn and Pb, and Pb presented a low risk (4.13%), while Zn, Cu, and Cr posed no risk (0.34%, 0.64%, and 0%). Toxicity and environmental risk analysis revealed bioleaching process significantly reduced the environmental risk associated with mine tailings. EPS analysis indicated that the loosely-bound EPS (LB-EPS) and tightly-bound EPS (TB-EPS) fractions contained different organic substances, which played different roles in the bioleaching process. Pearson correlation analysis revealed that EPS was highly correlated with bioleaching behavior (p < 0.05), and EPS was the main factor affecting the bioleaching process, promoting bioleaching in the LB-EPS and TB-EPS fractions.

Effects of fermentative and non-fermentative additives on silage quality and anaerobic digestion performance of Pennisetum purpureum.

The effect of additives on the silage quality, microbial community, and anaerobic digestion performance of Pennisetum purpureum with high moisture content was studied. The sample treated with a mixed additive had best silage quality with the lowest pH and highest lactic acid/acetic acid ratio. Different additives influenced the dominant desirable bacteria. Correspondingly, Enterobacter was the dominant bacterial genus for sample with non-fermentative additives, whereas for the samples with fermentative or mixed additives, both Enterobacter and Lactobacillus had high relative abundance. The parameters of NH3-N, hemicellulose and lactic acid were positively correlated with the specific methane yield, while the lignin content was inversely correlated with the specific methane yield. The higher specific methane yield of 293.81 ± 0.15-334.69 ± 22.75 mL/g VS was obtained for samples treated with fermentative additive. Therefore, the mixed additive and fermentative additive are recommended for the silage of material with high-moisture content to improve the silage quality and methane yield.

Reassessing the atmospheric oxidation mechanism of toluene.

Photochemical oxidation of aromatic hydrocarbons leads to tropospheric ozone and secondary organic aerosol (SOA) formation, with profound implications for air quality, human health, and climate. Toluene is the most abundant aromatic compound under urban environments, but its detailed chemical oxidation mechanism remains uncertain. From combined laboratory experiments and quantum chemical calculations, we show a toluene oxidation mechanism that is different from the one adopted in current atmospheric models. Our experimental work indicates a larger-than-expected branching ratio for cresols, but a negligible formation of ring-opening products (e.g., methylglyoxal). Quantum chemical calculations also demonstrate that cresols are much more stable than their corresponding peroxy radicals, and, for the most favorable OH (ortho) addition, the pathway of H extraction by O2 to form the cresol proceeds with a smaller barrier than O2 addition to form the peroxy radical. Our results reveal that phenolic (rather than peroxy radical) formation represents the dominant pathway for toluene oxidation, highlighting the necessity to reassess its role in ozone and SOA formation in the atmosphere.

Isolation of a non-fermentative bacterium, Pseudomonas aeruginosa, using intracellular carbon for denitrification and phosphorus-accumulation and relevant metabolic mechanisms.

A newly designed pilot-scale system was developed to enrich denitrifying phosphate-accumulating organisms (DNPAOs) for nitrogen and phosphorus nutrient removal synchronously. A strain of DNPAOs was isolated and its biochemical characteristics and metabolic mechanisms of this bacterial strain were analyzed. The results showed that compared with previously reported system, this newly designed system has higher removal rates of nutrients. Removal efficiencies of NH3-N, TN, TP, and COD in actual wastewater were 82.64%, 79.62%, 87.22%, and 90.41%, respectively. Metabolic activity of DNPAOs after anoxic stage in this study even reached 94.64%. Pseudomonas aeruginosa is a strain of non-fermentative DNPAOs with strong nitrogen and phosphorus removal abilities. Study on the metabolic mechanisms suggested that intracellular PHB of P. aeruginosa plays dual roles, supplying energy for phosphorus accumulation and serving as a major carbon source for denitrification.

[Pollution level and chemical speciation of heavy metals in PM2.5 during autumn in Guangzhou city].

PM2.5 samples were collected in Guangzhou city during autumn. Total concentration and chemical speciation of 10 heavy metals in PM2.5 were quantified by acid digestion method and sequential extraction procedure. The pollution level and bioavailability of these metals were also evaluated. Results showed that PM2.5 and heavy metal concentration were significantly high in Guangzhou city. Ranged from 0.0833 to 0.1900 mg m(-3), PM2.5 levels in the region were much higher than outdoor PM2.5 standard recommended by US-EPA. High enrichment factor values (K > 10) were obtained for Cd, Pb, Zn, Cu and Mo, reflecting the importance of anthropogenic inputs. In contrast, K values of Ni, Mn, Co and Fe were among 1 to 10, suggested that they were mainly from natural sources except for human activities. According to the results of chemical speciation analysis, more than 80% of Al and Fe were found bound to organic matter, oxidisable and sulphidic fraction, and residual fraction. Meanwhile, most of Zn, Pb, Cd and Cu were distributed in soluble and exchangeable fraction and carbonate, oxide and reducible fraction. Bioavailable coefficients (k) revealed that the order of comparative mobility and bioavailability of heavy metals is: Cd > Zn > Pb > Cu> Mn> Mo> Co> Ni> Fe> Al. With k > 0.8, Cd, Zn and Pb were classified as bioavailable elements, while Cu, Mn, Mo, Co and Ni (k approximately equal 0.5) were remarked as potential bioavailable elements, and Fe and Al (k <0.2) as non-available elements.

[Distribution of heavy metals in PM10 and its release in the simulated acid rain].

The distribution of heavy metals in inhalable particulate matter (PM10), which were collected in Foshan during December of 2004, was characterized by scanning electron microscope-X-ray energy dispersive analysis technique (SEM-EDS) and inductively coupled plasma-atomic emission spectroscopy (ICP-AES). The releases of Cu, Pb, Zn and Cd were also examined for their potential releases in simulated acid rain, which were quantified with batch reactors. The results showed that the daily average concentration of PM10 was 0.19 mg/m(3), about 79% higher than the secondary standard of China. The relatively contents of Zn and Pb in PM10 were much higher than Cd and Zn, whereas the releasing rates of Cd and Zn in simulated acid rain were greater than that of Cu and Pb. The releasing rates of heavy metals from PM10 were increased as the pH of the acid rain decreased.