Your browser doesn't support javascript.
loading
Mostrar: 20 | 50 | 100
Resultados 1 - 9 de 9
Filtrar
Mais filtros










Base de dados
Intervalo de ano de publicação
1.
Sci Rep ; 11(1): 18342, 2021 Sep 15.
Artigo em Inglês | MEDLINE | ID: mdl-34526572

RESUMO

Indium-substituted strontium hexaferrites were prepared by the conventional solid-phase reaction method. Neutron diffraction patterns were obtained at room temperature and analyzed using the Rietveld methods. A linear dependence of the unit cell parameters is found. In3+ cations are located mainly in octahedral positions of 4fVI and 12 k. The average crystallite size varies within 0.84-0.65 µm. With increasing substitution, the TC Curie temperature decreases monotonically down to ~ 520 K. ZFC and FC measurements showed a frustrated state. Upon substitution, the average and maximum sizes of ferrimagnetic clusters change in the opposite direction. The Mr remanent magnetization decreases down to ~ 20.2 emu/g at room temperature. The Ms spontaneous magnetization and the keff effective magnetocrystalline anisotropy constant are determined. With increasing substitution, the maximum of the ε/ real part of permittivity decreases in magnitude from ~ 3.3 to ~ 1.9 and shifts towards low frequencies from ~ 45.5 GHz to ~ 37.4 GHz. The maximum of the tg(α) dielectric loss tangent decreases from ~ 1.0 to ~ 0.7 and shifts towards low frequencies from ~ 40.6 GHz to ~ 37.3 GHz. The low-frequency maximum of the µ/ real part of permeability decreases from ~ 1.8 to ~ 0.9 and slightly shifts towards high frequencies up to ~ 34.7 GHz. The maximum of the tg(δ) magnetic loss tangent decreases from ~ 0.7 to ~ 0.5 and shifts slightly towards low frequencies from ~ 40.5 GHz to ~ 37.7 GHz. The discussion of microwave properties is based on the saturation magnetization, natural ferromagnetic resonance and dielectric polarization types.

2.
Sci Rep ; 7(1): 15460, 2017 11 13.
Artigo em Inglês | MEDLINE | ID: mdl-29133957

RESUMO

The ability to control a magnetic phase with an electric field is of great current interest for a variety of low power electronics in which the magnetic state is used either for information storage or logic operations. Over the past several years, there has been a considerable amount of research on pathways to control the direction of magnetization with an electric field. More recently, an alternative pathway involving the change of the magnetic state (ferromagnet to antiferromagnet) has been proposed. In this paper, we demonstrate electric field control of the Anomalous Hall Transport in a metamagnetic FeRh thin film, accompanying an antiferromagnet (AFM) to ferromagnet (FM) phase transition. This approach provides us with a pathway to "hide" or "reveal" a given ferromagnetic region at zero magnetic field. By converting the AFM phase into the FM phase, the stray field, and hence sensitivity to external fields, is decreased or eliminated. Using detailed structural analyses of FeRh films of varying crystalline quality and chemical order, we relate the direct nanoscale origins of this memory effect to site disorder as well as variations of the net magnetic anisotropy of FM nuclei. Our work opens pathways toward a new generation of antiferromagnetic - ferromagnetic interactions for spintronics.

3.
Sci Rep ; 6: 35471, 2016 10 20.
Artigo em Inglês | MEDLINE | ID: mdl-27762278

RESUMO

Antiferromagnetic spintronics is an emerging field; antiferromagnets can improve the functionalities of ferromagnets with higher response times, and having the information shielded against external magnetic field. Moreover, a large list of aniferromagnetic semiconductors and metals with Néel temperatures above room temperature exists. In the present manuscript, we persevere in the quest for the limits of how large can anisotropic magnetoresistance be in antiferromagnetic materials with very large spin-orbit coupling. We selected IrMn as a prime example of first-class moment (Mn) and spin-orbit (Ir) combination. Isothermal magnetotransport measurements in an antiferromagnetic-metal(IrMn)/ferromagnetic-insulator thin film bilayer have been performed. The metal/insulator structure with magnetic coupling between both layers allows the measurement of the modulation of the transport properties exclusively in the antiferromagnetic layer. Anisotropic magnetoresistance as large as 0.15% has been found, which is much larger than that for a bare IrMn layer. Interestingly, it has been observed that anisotropic magnetoresistance is strongly influenced by the field cooling conditions, signaling the dependence of the found response on the formation of domains at the magnetic ordering temperature.

4.
Nat Commun ; 5: 4671, 2014 Sep 10.
Artigo em Inglês | MEDLINE | ID: mdl-25204755

RESUMO

Recent studies in devices comprising metal antiferromagnets have demonstrated the feasibility of a novel spintronic concept in which spin-dependent phenomena are governed by an antiferromagnet instead of a ferromagnet. Here we report experimental observation of the anisotropic magnetoresistance in an antiferromagnetic semiconductor Sr2IrO4. Based on ab initio calculations, we associate the origin of the phenomenon with large anisotropies in the relativistic electronic structure. The antiferromagnet film is exchange coupled to a ferromagnet, which allows us to reorient the antiferromagnet spin-axis in applied magnetic fields via the exchange spring effect. We demonstrate that the semiconducting nature of our AFM electrode allows us to perform anisotropic magnetoresistance measurements in the current-perpendicular-to-plane geometry without introducing a tunnel barrier into the stack. Temperature-dependent measurements of the resistance and anisotropic magnetoresistance highlight the large, entangled tunabilities of the ordinary charge and spin-dependent transport in a spintronic device utilizing the antiferromagnet semiconductor.

5.
Nat Commun ; 5: 3404, 2014 Mar 03.
Artigo em Inglês | MEDLINE | ID: mdl-24584546

RESUMO

Interfacial magnetoelectric coupling is a viable path to achieve electrical writing of magnetic information in spintronic devices. For the prototypical Fe/BaTiO3 system, only tiny changes of the interfacial Fe magnetic moment upon reversal of the BaTiO3 dielectric polarization have been predicted so far. Here, by using X-ray magnetic circular dichroism in combination with high-resolution electron microscopy and first principles calculations, we report on an undisclosed physical mechanism for interfacial magnetoelectric coupling in the Fe/BaTiO3 system. At this interface, an ultrathin oxidized iron layer exists, whose magnetization can be electrically and reversibly switched on and off at room temperature by reversing the BaTiO3 polarization. The suppression/recovery of interfacial ferromagnetism results from the asymmetric effect that ionic displacements in BaTiO3 produces on the exchange coupling constants in the interfacial-oxidized Fe layer. The observed giant magnetoelectric response holds potential for optimizing interfacial magnetoelectric coupling in view of efficient, low-power spintronic devices.

6.
Nat Mater ; 13(4): 367-74, 2014 Apr.
Artigo em Inglês | MEDLINE | ID: mdl-24464243

RESUMO

The bistability of ordered spin states in ferromagnets provides the basis for magnetic memory functionality. The latest generation of magnetic random access memories rely on an efficient approach in which magnetic fields are replaced by electrical means for writing and reading the information in ferromagnets. This concept may eventually reduce the sensitivity of ferromagnets to magnetic field perturbations to being a weakness for data retention and the ferromagnetic stray fields to an obstacle for high-density memory integration. Here we report a room-temperature bistable antiferromagnetic (AFM) memory that produces negligible stray fields and is insensitive to strong magnetic fields. We use a resistor made of a FeRh AFM, which orders ferromagnetically roughly 100 K above room temperature, and therefore allows us to set different collective directions for the Fe moments by applied magnetic field. On cooling to room temperature, AFM order sets in with the direction of the AFM moments predetermined by the field and moment direction in the high-temperature ferromagnetic state. For electrical reading, we use an AFM analogue of the anisotropic magnetoresistance. Our microscopic theory modelling confirms that this archetypical spintronic effect, discovered more than 150 years ago in ferromagnets, is also present in AFMs. Our work demonstrates the feasibility of fabricating room-temperature spintronic memories with AFMs, which in turn expands the base of available magnetic materials for devices with properties that cannot be achieved with ferromagnets.

7.
Nanoscale ; 5(17): 8037-44, 2013 Sep 07.
Artigo em Inglês | MEDLINE | ID: mdl-23872985

RESUMO

Ferroelectric (FE) and ferromagnetic (FM) materials engineered in horizontal heterostructures allow interface-mediated magnetoelectric coupling. The so-called converse magnetoelectric effect (CME) has been already demonstrated by electric-field poling of the ferroelectric layers and subsequent modification of the magnetic state of adjacent ferromagnetic layers by strain effects and/or free-carrier density tuning. Here we focus on the direct magnetoelectric effect (DME) where the dielectric state of a ferroelectric thin film is modified by a magnetic field. Ferroelectric BaTiO3 (BTO) and ferromagnetic CoFe2O4 (CFO) oxide thin films have been used to create epitaxial FE/FM and FM/FE heterostructures on SrTiO3(001) substrates buffered with metallic SrRuO3. It will be shown that large ferroelectric polarization and DME can be obtained by appropriate selection of the stacking order of the FE and FM films and their relative thicknesses. The dielectric permittivity, at the structural transitions of BTO, is strongly modified (up to 36%) when measurements are performed under a magnetic field. Due to the insulating nature of the ferromagnetic layer and the concomitant absence of the electric-field effect, the observed DME effect solely results from the magnetostrictive response of CFO elastically coupled to the BTO layer. These findings show that appropriate architecture and materials selection allow overcoming substrate-induced clamping in multiferroic multi-layered films.

8.
Phys Rev Lett ; 106(5): 057206, 2011 Feb 04.
Artigo em Inglês | MEDLINE | ID: mdl-21405430

RESUMO

We demonstrate that the magnetization of a ferromagnet in contact with an antiferromagnetic multiferroic (LuMnO(3)) can be speedily reversed by electric-field pulsing, and the sign of the magnetic exchange bias can switch and recover isothermally. As LuMnO(3) is not ferroelastic, our data conclusively show that this switching is not mediated by strain effects but is a unique electric-field driven decoupling of the ferroelectric and antiferromagnetic domain walls. Their distinct dynamics are essential for the observed magnetic switching.

9.
Phys Rev Lett ; 107(25): 257601, 2011 Dec 16.
Artigo em Inglês | MEDLINE | ID: mdl-22243112

RESUMO

Cycloidal magnetic order occurring in some AMnO(3) perovskites is known to induce ferroelectricity. The polarization is perpendicular to the propagation vector direction of the cycloid and its chirality, and therefore it is directly related to the chiral domain structure. We show that the switching process of chiral domains is sensitively dependent on the magnetoelectric history of the sample. Moreover, by appropriate field cycling, magnetic order can display partial chiral memory. We argue that memory results from electric field coupling of cycloidal domain and nucleation and pinning of chiral domain walls, much like the domain structure in other ferroic systems.

SELEÇÃO DE REFERÊNCIAS
DETALHE DA PESQUISA
...