Effect of feeding treatment during the backgrounding phase of beef production from pasture on: II. Longissimus muscle proximate composition, cholesterol and fatty acids.

This study evaluated effects of feedlot backgrounding strategies (40, 70 or 100% alfalfa hay diets) or pasture grazing on moisture, protein, total lipids, ash, cholesterol concentration, and lipid profiles of the longissimus dorsi muscle (LM) of pasture finished Angus heifers. Ninety six calves were allocated to the strategies over a 114-day period, followed by pasture grazing over 132 days. At the end of the backgrounding stage, the concentration of omega-3 (n-3) fatty acids was highest in the Pasture group and this difference persisted (P<0.032) until the end of the 132 day pasture finishing phase. Similarly, the n-6/n-3 ratio was lowest in the Pasture group at the end of backgrounding and after pasture finishing. Backgrounding diets based on 70 and 100% hay or pasture grazing showed greater (P<0.041) conjugated linoleic acid (CLA) concentration in the lipid fraction than 40% hay. Results suggested that residual effects of backgrounding strategies could be detected in intramuscular fat of pasture finished heifers.

The development of a blend-sampling technique to assess the uniformity of a powder mixture.

This article discusses the challenges overcome during the development of a blend-sampling technique and the successful validation of the blending operation for a tablet dosage form containing 2% active ingredient. Content uniformity results are discussedfor three pilot-scale (15-kg) and seven commercial-scale (150-kg) batches of tablets. Blend and core content uniformity data from the pilot-scale batches were acceptable. For the initial commercial-scale batches, although the tablet core content uniformity data were acceptable, the blend uniformity results were poor. The blend data for these batches had very high mean values, but acceptable relative standard deviations (RSDs). This suggested that the drug was being preferentially sampled by the thief but in a consistent, reproducible manner. Extensive testing was performed on a commercial-scale development batch to identify potential causes of sampling error. The results of this testing helped define the blend-sampling technique and strategy used to validate the mixing operation.

Comparison of the performance of two sample thieves for the determination of the content uniformity of a powder blend.

The objective of this study was to compare the performance of two sample thieves (plug and grain) to determine the content uniformity of a powder blend. The powder blend was prepared by mixing 2% drug substance with the remaining excipients in a tumble blender for 30 min. Samples were taken at 10 locations in the blender using both thieves. The performance of each sample thief was assessed based on the respective content uniformity values and relative standard deviations obtained for each device, as well as the content uniformity values reported following analysis of the resulting compressed tablets. The relative standard deviation values for blend samples taken with the plug thief were approximately half of those obtained using the grain thief. The superior performance of the plug thief in this study is attributed to the static charge acquired by the microcrystalline cellulose, which leads to poor flow characteristics. This impeded the flow of the blend into the sample chamber of the grain thief resulting in segregation and variable content uniformity results. The plug thief, which does not require powder flow to obtain a sample, performs better for this formulation. The selection of a sampling thief should be assessed on a case-by-case basis. Superior performance is expected for the plug thief when poor flowing, compressible blends are sampled.