A Method to Correct the Temporal Drift of Single-Photon Detectors Based on Asynchronous Quantum Ghost Imaging.

Single-photon detection and timing has attracted increasing interest in recent years due to their necessity in the field of quantum sensing and the advantages of single-quanta detection in the field of low-level light imaging. While simple bucket detectors are mature enough for commercial applications, more complex imaging detectors are still a field of research comprising mostly prototype-level detectors. A major problem in these detectors is the implementation of in-pixel timing circuitry, especially for two-dimensional imagers. One of the most promising approaches is the use of voltage-controlled ring resonators in every pixel. Each of these runs independently based on a voltage supplied by a global reference. However, this yields the problem that the supply voltage can change across the chip which, in turn, changes the period of the ring resonator. Due to additional parasitic effects, this problem can worsen with increasing measurement time, leading to drift in the timing information. We present here a method to identify and correct such temporal drifts in single-photon detectors based on asynchronous quantum ghost imaging. We also show the effect of this correction on recent quantum ghost imaging (QGI) measurement from our group.

3D quantum ghost imaging.

We present current results of a novel, to the best of our knowledge, type of setup for quantum ghost imaging based on asynchronous single photon timing using single photon avalanche diode (SPAD) detectors, first presented in [Appl. Opt.60, F66 (2021)APOPAI0003-693510.1364/AO.423634]. The scheme enables photon pairing without fixed delays and, thus, overcomes some limitations of the widely used heralded setups for quantum ghost imaging [Nat. Commun.6, 5913 (2015)NCAOBW2041-172310.1038/ncomms6913]. It especially allows three-dimensional (3D) imaging by direct time of flight methods, the first demonstration of which will be shown here. To our knowledge, it is also the first demonstration of 3D quantum ghost imaging at all.

Quantum ghost imaging based on a "looking back" 2D SPAD array.

Quantum ghost imaging (QGI) is an intriguing imaging protocol that exploits photon-pair correlations stemming from spontaneous parametric down-conversion (SPDC). QGI retrieves images from two-path joint measurements, where single-path detection does not allow us to reconstruct the target image. Here we report on a QGI implementation exploiting a two-dimensional (2D) single-photon avalanche diode (SPAD) array detector for the spatially resolving path. Moreover, the employment of non-degenerate SPDC allows us to investigate samples at infrared wavelengths without the need for short-wave infrared (SWIR) cameras, while the spatial detection can be still performed in the visible region, where the more advanced silicon-based technology can be exploited. Our findings advance QGI schemes towards practical applications.

The role of children and work-from-home in gender labor market asymmetries: evidence from the COVID-19 pandemic in Latin America.

Asymmetry in childcare responsibilities is one of the main reasons behind gender gaps in the labor market. In that context, the ability to work from home may alleviate the hindrances of women with children to participate in the labor market. We study these issues in Latin America, a region with wide gender gaps, in the framework of a major shock that severely affected employment: the COVID-19 pandemic. In particular, we estimate models of job loss exploiting microdata from the World Bank's High-Frequency Phone Surveys conducted immediately after the onset of the pandemic. We find that the mitigating effect of working from home on the severity of job losses was especially relevant for women with children. The results are consistent with a plausible mechanism: due to the traditional distribution of childcare responsibilities within the household, women with children were more likely to stay home during school closures, and therefore the ability to work from home was crucial for them to keep their jobs.

Characterization of space-momentum entangled photons with a time resolving CMOS SPAD array.

Single-photon avalanche diode arrays can provide both the spatial and temporal information of each detected photon. We present here the characterization of spatially entangled photons with a 32 × 32 pixel sensor, specifically designed for quantum imaging applications. The sensor is time-tagging each detection event at pixel level with sub-nanosecond accuracy within frames of 50 ns. The spatial correlations between any number of detections in a defined temporal window can thus be directly extracted from the data.The space-momentum entanglement of photon pairs is demonstrated by violating an EPR-type inequality directly from the measured near-field correlations and far-field anti-correlations.

Numerical Model of SPAD-Based Direct Time-of-Flight Flash LIDAR CMOS Image Sensors.

We present a Montecarlo simulator developed in Matlab® for the analysis of a Single Photon Avalanche Diode (SPAD)-based Complementary Metal-Oxide Semiconductor (CMOS) flash Light Detection and Ranging (LIDAR) system. The simulation environment has been developed to accurately model the components of a flash LIDAR system, such as illumination source, optics, and the architecture of the designated SPAD-based CMOS image sensor. Together with the modeling of the background noise and target topology, all of the fundamental factors that are involved in a typical LIDAR acquisition system have been included in order to predict the achievable system performance and verified with an existing sensor.

Coincidence detection of spatially correlated photon pairs with a monolithic time-resolving detector array.

We demonstrate coincidence measurements of spatially entangled photons by means of a multi-pixel based detection array. The sensor, originally developed for positron emission tomography applications, is a fully digital 8×16 silicon photomultiplier array allowing not only photon counting but also per-pixel time stamping of the arrived photons with an effective resolution of 265 ps. Together with a frame rate of 500 kfps, this property exceeds the capabilities of conventional charge-coupled device cameras which have become of growing interest for the detection of transversely correlated photon pairs. The sensor is used to measure a second-order correlation function for various non-collinear configurations of entangled photons generated by spontaneous parametric down-conversion. The experimental results are compared to theory.

Fast and simple spectral FLIM for biochemical and medical imaging.

Spectrally resolved fluorescence lifetime imaging microscopy (λFLIM) has powerful potential for biochemical and medical imaging applications. However, long acquisition times, low spectral resolution and complexity of λFLIM often narrow its use to specialized laboratories. Therefore, we demonstrate here a simple spectral FLIM based on a solid-state detector array providing in-pixel histrogramming and delivering faster acquisition, larger dynamic range, and higher spectral elements than state-of-the-art λFLIM. We successfully apply this novel microscopy system to biochemical and medical imaging demonstrating that solid-state detectors are a key strategic technology to enable complex assays in biomedical laboratories and the clinic.