Spectroscopic gas detection using a Bragg grating - stabilized external cavity laser, custom written in planar integrated silica-on-silicon.

We present the development of an external cavity Bragg grating stabilized laser for tunable diode laser spectroscopy (TDLS). Our design uses a planar integrated silica-on-silicon platform incorporating a custom written Bragg grating as the wavelength-selective element of the laser cavity. We have developed a prototype singlemode laser at 1651 nm and performed a detailed characterization of its performance for the purpose of spectroscopic measurement of methane at this wavelength using a 25 cm path-length single-pass cell. Mode hop-free tuning of 0.13 nm has been demonstrated at frequencies of up to 10 kHz. A single-point limit of detection for TDLS of ΔI/I0 = 8.3 × 10-5 AU was achieved, which is consistent with the performance of standard distributed feedback lasers. The new device exhibits a side-mode suppression ratio of -40 dB and a low RIN of <-150 dB/Hz, and thus avoids the high levels of noise or instability normally associated with larger, mechanically driven external cavity lasers. The silica-on-silicon platform has the potential for low-volume manufacturing of special lasers at the custom wavelengths required for gas detection, without the need for investment in foundry solutions.

Integrated reconfigurable photonic filters based on interferometric fractional Hilbert transforms.

In this paper, we present integrated reconfigurable photonic filters using fractional Hilbert transformers (FrHTs) and optical phase tuning structure within the silica-on-silicon platform. The proposed structure, including grating-based FrHTs, an X-coupler, and a pair of thermal tuning filaments, is fabricated through the direct UV grating writing technique. The thermal tuning effect is realized by the controllable microheaters located on the two arms of the X-coupler. We investigate the 200 GHz maximum bandwidth photonic FrHTs based on apodized planar Bragg gratings, and analyze the reflection spectrum responses. Through device integration and thermal modulation, the device could operate as photonic notch filters with 5 GHz linewidth and controllable single sideband suppression filters with measured 12 dB suppression ratio. A 50 GHz instantaneous frequency measuring system using this device is also schematically proposed and analyzed with potential 3 dB measurement improvement. The device could be configured with these multiple functions according to need. The reconfigurable structure has great potential in ultrafast all-optical signal processing fields.

Photonic crystal and quasi-crystals providing simultaneous light coupling and beam splitting within a low refractive-index slab waveguide.

Coupling between free space components and slab waveguides is a common requirement for integrated optical devices, and is typically achieved by end-fire or grating coupling. Power splitting and distribution requires additional components. Usually grating couplers are used in combination with MMI/Y-splitters to do this task. In this paper, we present a photonic crystal device which performs both tasks simultaneously and is able to couple light at normal incidence and near normal incidence. Our approach is scalable to large channel counts with little impact on device footprint. We demonstrate in normal incidence coupling with multi-channel splitting for 785 nm light. Photonic crystals are etched into single mode low refractive index SiON film on both SiO2/Si and borosilicate glass substrate. Triangular lattices are shown to provide coupling to 6 beams with equal included angle (60°), while a quasi-crystal lattice with 12-fold rotational symmetry yields coupling to 12 beams with equal included angle (30°). We show how to optimize the lattice constant to achieve efficient phase matching between incident and coupled mode wave vectors, and how to adjust operating wavelength from visible to infrared wavelengths.

Terahertz bandwidth photonic Hilbert transformers based on synthesized planar Bragg grating fabrication.

Terahertz bandwidth photonic Hilbert transformers are proposed and experimentally demonstrated. The integrated device is fabricated via a direct UV grating writing technique in a silica-on-silicon platform. The photonic Hilbert transformer operates at bandwidths of up to 2 THz (~16 nm) in the telecom band, a 10-fold greater bandwidth than any previously reported experimental approaches. Achieving this performance requires detailed knowledge of the system transfer function of the direct UV grating writing technique; this allows improved linearity and yields terahertz bandwidth Bragg gratings with improved spectral quality. By incorporating a flat-top reflector and Hilbert grating with a waveguide coupler, an ultrawideband all-optical single-sideband filter is demonstrated.

Ultra-wide detuning planar Bragg grating fabrication technique based on direct UV grating writing with electro-optic phase modulation.

A direct UV grating writing technique based on phase-controlled interferometry is proposed and demonstrated in a silica-on-silicon platform, with a wider wavelength detuning range than any previously reported UV writing technology. Electro-optic phase modulation of one beam in the interferometer is used to manipulate the fringe pattern and thus control the parameters of the Bragg gratings and waveguides. Various grating structures with refractive index apodization, phase shifts and index contrasts of up to 0.8 × 10(-3) have been demonstrated. The method offers significant time/energy efficiency as well as simplified optical layout and fabrication process. We have shown Bragg gratings can be made from 1200 nm to 1900 nm exclusively under software control and the maximum peak grating reflectivity only decreases by 3 dBover a 250 nm (~32 THz) bandwidth.

Phase controlled integrated interferometric single-sideband filter based on planar Bragg gratings implementing photonic Hilbert transform.

The monolithically integrated all-optical single-sideband (SSB) filter based on photonic Hilbert transform and planar Bragg gratings is proposed and experimentally demonstrated. An SSB suppression of 12 dB at 6 GHz and sideband switching are achieved via thermal tuning. An X-coupler, photonic Hilbert transformer, flat top reflector, and a micro heater are incorporated in a single silicon-on-silica substrate. The device can be thermally tuned by the micro heater on top of the channel waveguide. The device is fabricated using a combination of direct UV grating writing technology and photolithography.

Demonstration of UV-written waveguides, Bragg gratings and cavities at 780 nm, and an original experimental measurement of group delay.

We present direct UV-written waveguides and Bragg gratings operating at 780 nm. By combining two gratings into a Fabry-Perot cavity we have devised and implemented a novel and practical method of measuring the group delay of Bragg gratings.

Demonstration of 100 GHz electrically tunable liquid-crystal Bragg gratings for application in dynamic optical networks.

We demonstrate liquid-crystal-based integrated optical devices with >140 GHz electrical tuning for potential applications in dynamic optical networks. Bragg wavelength tuning covering five 25 GHz wavelength-division multiplexing channel spacing has been achieved with 170 V (peak-to-peak) sinusoidal voltages applied across electropatterned indium tin oxide-covered glass electrodes placed 60 microm apart. This tunability range was limited only by the initial grating strength and supply voltage level. We also observed two distinct threshold behaviors that manifest during increase of supply voltage, resulting in a hysteresis in the tuning curve for both TE and TM input light.

Line defects and temperature effects in liquid crystal tunable planar Bragg gratings.

Liquid crystal tunable planar Bragg Gratings produced by Direct UV Writing are capable of wavelength tuning of over 100GHz. However, such devices exhibit non-linear tuning curves with threshold points and hysteresis. We show that these effects are due to the formation of disclination structures in the liquid crystal and discuss the role of electrode defects and sample temperature on wavelength tuning.

Food choices of obese and non-obese persons.

An observational study of food choices of patrons of a campus cafeteria was conducted to ascertain whether obese and non-obese individuals had the same eating patterns. Subjects were unaware of the monitoring of their food choices. Patrons were categorized by visual appraisal into forty-eight cross-classified groups according to sex (male, female), body build (slender, sturdy, stocky, obese), height (tall, average, short), and age (less than and more than thirty years of age). Servings of food were estimated visually as it was not possible to determine exact amounts. Foods were classified as either protective foods with good contributions of nutrients in proportion to calories (Group B) or as high-calorie, low-nutrient foods (Group A). Significant findings were the tendency for those in the obese category to select more servings of food and more foods from the high-calorie, low-nutrient Group A foods, when compared with selections of persons in the other body-build groups. A more controlled study is suggested for more definitive results. Also pointed out was the importance of recognizing that excessive food intake may be one possibility among many in cases of refractory obesity.